Frigidaire GLEQ2152EE Support Question
Frigidaire GLEQ2152EE Support Question
Find answers below for this question about Frigidaire GLEQ2152EE - 27" Front-Load Electric Dryer.Need a Frigidaire GLEQ2152EE manual? We have 4 online manuals for this item!
Question posted by Cculpepper on July 3rd, 2018
What Is The Capacity Of This Dryer?
What is the capacity of this dryer?
Current Answers
Related Frigidaire GLEQ2152EE Manual Pages
Use and Care Manual - Page 2
...be followed to minimize the risk of fire or explosion or to reduce the chance of electrical and electronic equipment. Read and Save These Instructions
Read all safety messages. All safety messages...or seriously injured if you don't follow instructions. Use the dryer only as household waste. Do not store or use any electrical switch; do not use gasoline or other flammable vapors and...
Use and Care Manual - Page 3
... could result in the dryer. An excessive amount of lint build-up in these warnings could cause a load to fabrics can become airtight chambers. • Keep laundry products out of aerosol ...that may melt or burn. ELECTRIC DRYERS:
14-30R
FUSED 30 AMP 120/240 V OR 120/208 V WALL RECEPTACLE
DRYER
DRYER SERVICE CORD
Grounding type wall receptacle
GAS DRYERS:
Do not under certain ...
Use and Care Manual - Page 4
... For delicate or very small loads, add 2 lint-free towels for easy removal.
2. Load the dryer.
• The average load will stop before reaching inside ...dryer, the electrical power cord of a gas dryer must be plugged into a properly grounded and polarized 3-prong outlet. To reduce the risk of fire, electrical shock, or injury to persons, read and follow fabric care labels and laundry...
Use and Care Manual - Page 5
... the dryer interior, unplug the electrical power cord to avoid electrical shock hazards.
• Do not use any accumulation of fire or serious injury to the dryer. Hazardous fumes or electrical shock ...the lint screen. Inside • Clean the lint screen after every load. Remove cleanser residue before drying the next load.
• Every 18 months an authorized servicer should not exceed ...
Use and Care Manual - Page 6
...con't
Do not store or place laundry products on top of load
before starting the dryer. Never use spray starch or fabric
finish on top of dryer at medium or low heat for ...Wrinkling
• Overloading. • Leaving items in washer or dryer to
electricity.
• Or, add a fabric softener sheet and
reduce static electricity.
• Lint screen not clean
tumble without heat.
•...
Use and Care Manual - Page 7
... is connected to a 208 volt circuit. See INSTALLATION INSTRUCTIONS. Refill or replace tank.
Electric dryer is empty or there has been a utility interruption of defective workmanship or materials in or plug may be necessary to the dryer.
See Drying Procedures. Dryer is not securely plugged in this list.
The list includes common occurrences that...
Technical Data Sheet - Page 1
...on gas models, replace electronic control. If meter reads 120V, check the rest of thermistor. Dryer Tech Data Sheet
This information is within 50 K (± 10%), check wiring between thermistor ...replace electronic control. Remove wires from the Normal cycle option. 2. If meter reads 240V on electric models and 120V on electronic control. Enter function test mode and perform key (button) test...
Technical Data Sheet - Page 2
... status LED's should be used to select the following tests: Rotate the program knob clockwise from dryer. When the Pause Cancel button is pressed, all LED'S will determine the value of the temperature... as follows. Control thermistor reading is off . d. heat source is lit. Dryer will make the DAMP LED come on . heat source is on the both moisture sense ...
Installation Instructions - Page 2
...knife.
Appliance grounded to be exhausted into the laundry area. NEMA 10-30R receptacle to neutral ...ELECTRICAL REQUIREMENTS
ELECTRIC Dryer
CIRCUIT - branch circuit fused with a 15 amp. See ELECTRICAL CONNECTIONS FOR A 4-WIRE SYSTEM. (Canada - 4-wire power supply cord is equipped with clothes dryers.
When the dryer stops, the dampers automatically close to exhaust the dryer...
Installation Instructions - Page 3
...387.1 sq. Read the measurement on electric dryers, exhausting can be constructed of the gas supply piping system at test pressures equal to the dryer. 6. On gas dryers, exhausting can be used. 1. ... line should check the exhaust system and vent hood for the full length of 1/2 inch (1.27 cm) pipe. 3. The tubing MUST be accomplished by installing Exhaust Kit, P/N 131456800, available...
Installation Instructions - Page 4
... to clear knobs (70.49cm) 28.5 to clear door handle (72.39cm)
2.375" (6.03cm)
(34.29cm) 13.5" To rear & base exhausts
27.0"
(68.58cm)
Stacked Dryer Installation Dimensions
(68.58cm) 27.0"
Electrical supply on rear of unit
28.25" to front of cabinet(71.76cm)
28.75" to clear knobs (73.03cm) 29.5" to...
Installation Instructions - Page 5
..., the exhaust system MUST terminate outside the enclosure with the four screws.
4.
Hold the door firmly before removing the last two screws.
3.
When installing a gas dryer into a mobile home, a provision must be fastened to help pull out the plugs.
Remove the four screws that will not support combustion. MOBILE HOME INSTALLATION...
Installation Instructions - Page 6
... of the door opening . Retain the plugs for use later. Be careful to the dryer front panel. Remove the screws from the opposite side of the door to reinstall the ....
3. NOTE: Remove one screw from Step 1 into the holes left side of the hinges. 10.
Open the dryer door. Be careful to help remove the plugs. NOTE:
You may need a plastic knife to avoid scratching the paint...
Installation Instructions - Page 7
... will reduce the risk of electrical shock by a path of the dryer and can be pulled out of least resistance for your dryer is equipped with all local codes and ordinances. The laundry center is properly installed and grounded in electrical shock. ELECTRICAL CONNECTIONS FOR 3-WIRE SYSTEM
Non Canadian ELECTRIC Dryer
1. If your dryer. Do not modify plug provided...
Installation Instructions - Page 8
...1/2 inch (1.27 cm) I.D.
Tighten the screw securely.
7. Connect the exhaust duct to L.P. The dryer MUST be used when elevating the dryer for service.
7. Also see pages 6 and 7). NOTE: On gas dryers, before plugging the power cord into a grounded outlet. REPLACEMENT PARTS
Pedestal A pedestal accessory, Model No.
Place all pipe connections.
3. ELECTRICAL CONNECTIONS...
Operating Instructions - Page 1
...dryer Owner's Guide. If the load is clean and in place. 3. Normal Select this Auto Dry cycle for more details.
5. It also has many suggestions for drying. 2.
For best results, follow the fabric care label instructions on size and dampness of fire, electric...or change the cycle, press Pause/ Cancel twice.
6. Load the dryer. Close the door. 4. Press START to the desired ...
Operating Instructions - Page 2
... "Dryer Settings Chart" for delicate fabrics. Low heat is not recommended for a cycle, the indicator will not light.
For loads requiring less drying time, select Less Dry.
The dry load will...or to the desired heat.
Select Damp Dry for any button will automatically be dried. Dryer Features
(Control Lock) To avoid having someone accidentally start or stop the washer, press OPTIONS...
Operating Instructions - Page 3
... Options
Shrink Guard
Press Saver
Cycle Signal * Factory
setting
*
Available settings
*
*
*
** Not recommended
*
*
*
*
*
*
*** Estimated cycle duration is based on normal dryness level and factory settings.
DRYER SETTINGS CHART
AVAILABLE CYCLE SETTINGS -
Similar Questions
Need To Fix Ed68 Code On My Model Gleq2152ee0 Front Load Dryer
need to fix e68 code on my model GLEQ2152EE0 FRONT LOAD DRYER
need to fix e68 code on my model GLEQ2152EE0 FRONT LOAD DRYER
(Posted by Ledesma2020 3 years ago)
Trouble Restarting Electric Dryer
After an electric dryer warms it will not restart unless the selector nob is tapped. Which part need...
After an electric dryer warms it will not restart unless the selector nob is tapped. Which part need...
(Posted by jrpetrick 5 years ago)
My Frigidaire Dryer #134431300d-0801 Just Quits And All Lights Flash!
My Frigidaire dryer #134431300D-0801 just quits and all lights flash!
My Frigidaire dryer #134431300D-0801 just quits and all lights flash!
(Posted by bananalunajane 10 years ago)
What Does It Mean When The Dryer Shows Ad
the dryer is a frigidaire aeq7000ego
the dryer is a frigidaire aeq7000ego
(Posted by yeleydg 10 years ago)
Fridgidaire Electric Dryer Model Fase703lwo Not Starting
Our dryer is not starting and reads door open. An error code did appear however disappeard and has n...
Our dryer is not starting and reads door open. An error code did appear however disappeard and has n...
(Posted by juliemccleskey 10 years ago)