Frigidaire FTF2140FS Support Question
Frigidaire FTF2140FS Support Question
Find answers below for this question about Frigidaire FTF2140FS - 27" Front-Load Washer.Need a Frigidaire FTF2140FS manual? We have 2 online manuals for this item!
Question posted by mdiab3 on June 22nd, 2014
The 30 Minute Perm Press Cycle On My Washer Will Run 8 Mins And Then Stop
The Cycle Will Run 8 Minutes And Then Go Back To The Beginning With 30 Mins On Display Panel And Stop
Current Answers
Answer #1: Posted by online24h on June 22nd, 2014 4:44 PM
online24h
Member since:
March 28th, 2014 Points: 531,660
Member since:
March 28th, 2014 Points: 531,660
Hello
Page 9 below
http://www.manualslib.com/products/Frigidaire-Ftf2140fs-27-Front-Load-Washer-6809.html
Page 9 below
http://www.manualslib.com/products/Frigidaire-Ftf2140fs-27-Front-Load-Washer-6809.html
Hope this will be helpful "PLEASE ACCEPT"
Related Frigidaire FTF2140FS Manual Pages
Use and Care Guide - Page 2
...of injury, and tell you don't follow instructions. The model and serial numbers of your washer. This symbol alerts you to reduce the chance of electrical and electronic equipment.
NLPWD15 (White),... No. All safety messages will identify the hazard, tell you purchased the product. Your washer may not be killed or seriously injured if you what can be treated as instructed in...
Use and Care Guide - Page 3
... these items on or in the cycle selector knob and allow children to INSTALLATION INSTRUCTIONS for 2 weeks or more. Prevent Fire •Do not wash items that has not been used near the washer. Children might use them the proper, safe use of up to 30 minutes, if the washer has not been manually turned...
Use and Care Guide - Page 4
...washed separately. • The washer can be fully loaded, but the items should not be washed together. Sort laundry into loads that can be tightly packed. Permanent press, synthetic, knit and corduroy ...buttons, belt buckles, and other items in the wash load. • Mend rips and tears to prevent further damage during the wash cycle. • Turn knit items inside out to prevent tangling...
Use and Care Guide - Page 5
...cause early dispensing of the cycle. Note: Liquid detergent will drain into the
washer drum as it is flushed from the dispenser at the beginning
of the fabric softener which...tumble action washers.
5 Fill to the mininum fill line (MIN.) for large loads. Add detergent, bleach and fabric softener to exceed 1/3 cup (80 mL)) and pour it stops. • After adding laundry products, slowly...
Use and Care Guide - Page 6
...by testing stain remover on top of the washer. Do not store or place laundry products on an inside seam. • Rinse and wash items after the cycle has ended.
8. Do not use highly ...
Slowly close the dispenser drawer, and press START to continue. • Do not slam the washer door closed or try to the washer. • DO NOT leave the washer door open.
Note: If there are...
Use and Care Guide - Page 7
...enzymes. Pretreat or soak in warm water using bleach safe for 30 minutes or more. Wash using product containing enzymes. Scrape off dry ...tar, apply nonflammable dry cleaning fluid to back of an entire load, use on white fabric Grass Grease, oil, tar (butter...PASTE: Scrape residue from fabric. Wash. Pretreat stain. Press with chlorine bleach if safe for fabric. Replace paper towels...
Use and Care Guide - Page 8
... fabric.
See Washing Procedures for a few
minutes to abrasion from washer as soon as
cycle is attracting lint. •Load washed too long. Rewash using correct water... load.
•Increase water temperature using the Perm Press or Delicate cycle.
•Do not overload washer. •Remove items from normal wear. Wrinkling
•Overloading the washer. •Incorrect wash cycle...
Use and Care Guide - Page 9
... fiberboard under the front leveling legs to the Max Fill level and run empty washer through a
complete cycle using the Normal Cycle setting. Residue should always be clean to the washer:
1. If door or console becomes stained, clean with a nonabrasive household cleanser.
Close door. 5. Press Pause/Cancel twice, unplug electrical power cord, dry off water supply...
Use and Care Guide - Page 10
... electrician. Install rubber sealing washers provided.
• Wrong detergent. Run rinse cycle. See INSTALLATION INSTRUCTIONS.
10
Stop washer and redistribute wash load.
Move washer so it enters slowly.
... this washer. The list includes common concerns that are kinked. If noise continues after spin. To prevent unnecessary noise and damage to 30 minutes (if washer has ...
Installation Instructions - Page 1
...local codes and ordinances and the latest edition of life.
- This will simpfify the installation and ensure the washer is installed correctly and safely. Leave these instructions.
P/N 134848900 (0701)
Follow the gas suppliers instructions. &#...Action Washers
Before beginning installation, carefully read these instructions near the washer after installation for future reference.
Installation Instructions - Page 2
... floor should be located so the power supply cord is
accessible when the washer is not required. Properly grounded 3-prong receptacle to be : Minimum height:... pliers. 4.
GROUNDING
REQUIREMENTS
Improper connection of the equipment grounding conductor can be between 30 and 120 pounds per minute.
2. DRAIN REQUIREMENTS
I .
Individual, properly polarized and grounded 15 amp. POWER SUPPLY...
Installation Instructions - Page 4
...from the back panel of cardboard to an upright position.
5.
Using a rug, blanket or piece of the washer: 4 shipping bolts, 4 spacers, 1 metal "P" clamp.
7. Carefully move the washer to dripping water ...= 0 in. (0 cm) Top = 0 in. (0 cm) When installed in closet: Front = I .27 cm per 30.5 cm). per foot (I in. (2.54 cm) Closet door ventilation required: 2 Iouvered openings each 60 in2(387...
Installation Instructions - Page 5
...Do not crossthread or over-tighten these connections.
.
Run some water from the tub of the
spring clamp...washer• Adjust the leveling legs so the washer is level front-to-rear and side-to-side, and stable corner-to-corner.
\\\
SPRING
/
CLAMP
PROVIDED
ON HOSE i /
\\
/'
jr 4
PUSH HOSE ONTO COUPLERTO STOP...washer tub with the pedestal.
Adjust the appropriate leg so the washer...
Installation Instructions - Page 6
...purchased your washer, call 1-800-944-9044, or visit our website, www.frigidaire.com, for service.
1 I. Run the washer through a complete cycle. NLPWD15(...to the standpipe, inlet hose, laundry tub, etc. Secure the drain hose with the washer. Plug the power cord into... washer does not operate, please review the "Avoid Service Checklist" in the enclosure package) to the left hand side panel ...
Similar Questions
Washer Beeps When Start Is Pressed But Washer Won't Start.
When the washer start button is pressed there are 2 beeps but the washer won't start. What is the ca...
When the washer start button is pressed there are 2 beeps but the washer won't start. What is the ca...
(Posted by Selin052 5 years ago)
Frigidaire Front Loader Washer Wont Start Cycle
(Posted by Lapaul 9 years ago)
I Have To Wait 30 Between Loads Of The Washer
Everytime my washer ends with a load I have to wait 30 mins before I could start a new one. The elec...
Everytime my washer ends with a load I have to wait 30 mins before I could start a new one. The elec...
(Posted by ivanfraustro 13 years ago)