Frigidaire FFLE1011MW Support Question
Frigidaire FFLE1011MW Support Question
Find answers below for this question about Frigidaire FFLE1011MW.Need a Frigidaire FFLE1011MW manual? We have 3 online manuals for this item!
Question posted by JMartin56361 on January 18th, 2016
How Do I Remove The Wash Plate Cap?
I need to remove the cap on the agitator or the wash plate cap.
Current Answers
Answer #1: Posted by TommyKervz on January 19th, 2016 4:18 AM
TommyKervz
Member since:
January 10th, 2013 Points: 17,776,813
Member since:
January 10th, 2013 Points: 17,776,813
Click here and follow the instructions.
Related Frigidaire FFLE1011MW Manual Pages
Complete Owner's Guide - Page 2
...installation, operation or maintenance information which , if not avoided, will result in your laundry center.
do not
use gasoline or other flammable vapors and liquids in this...words and labels
Safety items throughout this manual are found on the serial plate located on the risk type as instructed in the vicinity of fire...washer. Do not store or use any other models.
Complete Owner's Guide - Page 3
... exhaust opening and in the surrounding area.
• Clean the lint screen before using this laundry center, comply with 3-prong grounded plug
Avoid fire hazard or electrical shock. IMPORTANT SAFETY...to the wash water. RISK OF FIRE
To reduce the risk of lint around the opening and remove any other flammable or explosive substances to persons when using the washer, turn...
Complete Owner's Guide - Page 4
... prong from service or discarded, remove the washer door to prevent accidental entrapment.
• Failure to do not reach into a properly grounded and polarized 3-prong outlet. Allow the wash tub or dryer drum to coast to follow this warning can become airtight chambers.
• Keep laundry products out of children is necessary when the...
Complete Owner's Guide - Page 5
...fault.
• Failure to comply with an electrical overload protector.
Install laundry center on top. The washer motor will be produced by an authorized servicer unless specifically recommended...tamper with ammonia or acids such as toilet cleaners, rust removers, acid or products containing ammonia. The laundry center is not meant to cover every possible condition and ...
Complete Owner's Guide - Page 6
...
To reduce the risk of fire, electric shock or injury to persons, read these IMPORTANT SAFETY INSTRUCTIONS in this guide for safe, successful stain removal instructions.
4 Add a measured amount of detergent to the
wash tub before operating your washer.
1 Sort laundry into loads that shed lint from durable items.
• Do not machine...
Complete Owner's Guide - Page 7
... above the maximum fill line. • Turn fabric softener option on the wash load. DO NOT use bleach in a load. After the lock releases, lift the lid and add the item. WASHER OPERATING INSTRUCTIONS
Washing Procedures, continued
6 Add laundry load to fabric
softener dispenser (available on some models).
For models with the lid...
Complete Owner's Guide - Page 8
... hear two beeps. Excess wrinkling, color transfer or odors may develop in items left in the cycle selector knob to be washed.
• To open the locked lid. WASHER OPERATING INSTRUCTIONS
Washing Procedures, continued 10 Remove items when the cycle is completed.
• For your safety, the lid is missing, damaged or operating improperly.
8
Complete Owner's Guide - Page 9
...washed. For best soil and stain removal, use a bleach or a soaking agent safe for heavily soiled cottons, towels, shirts, denims and mixed loads.
For best results
Follow the fabric care label instructions on select models only) Add one large comforter or two light-duty sleeping bags to start the new cycle.
WASHER...light to add fabric softener that need a cold water rinse or to ...
Complete Owner's Guide - Page 11
... their original labeled containers and out of fire or serious injury to be washed.
11 WASHER OPERATING INSTRUCTIONS
Safe Stain Removal Procedures
To reduce the risk of children's reach.
• Thoroughly wash any utensils used.
• Do not combine stain removal products, especially ammonia and chlorine bleach. Vapors can set stains.
• Consult care...
Complete Owner's Guide - Page 12
... water safe for fabric. Washing may be impossible to remove solvent. Brush off surface wax. Wash using nonchlorine bleach in warm water using bleach safe for fabric. Wash. Once paint is wet. Wash using bleach safe for fabric. LIQUID: Pretreat with bar soap. Wash using bleach safe for fabric. WASHER OPERATING INSTRUCTIONS
Stain Removal Suggestions
STAIN Adhesive tape...
Complete Owner's Guide - Page 13
...• Overloading the washer.
• Rewash load.
• Overloading the washer. • Incorrect wash cycle for wash
load.
• Agitation time too short. • Wash water temperature too
low...washing, run hot water for a
few minutes to remove and permanent press fabrics. WASHER OPERATING INSTRUCTIONS
Common Washing Problems
Many washing problems involve poor soil and stain removal...
Complete Owner's Guide - Page 18
... filter after every load.
Í NOTE
Fabric softener may build up , wash them with water.
• The base plate or tub may develop in items left in the dispenser well. Remove cleanser residue before the lid is required. INSIDE WASHER • Remove items from using dryer-added fabric softener sheets. Rinse well with a damp...
Complete Owner's Guide - Page 19
... (3.8 L) nontoxic recreational vehicle (RV) antifreeze to empty wash drum.
Start the cycle and let the washer drain for cold weather storage and care.
19 Not all...Remove glue residue from washer after storage, run empty washer through a complete cycle using detergent.
Rinse several times with the sticky side of tape. • Before moving the laundry center, place a strip of laundry...
Complete Owner's Guide - Page 20
...
Make sure all lint has been removed from items before attempting to support the... fuse. Water supply faucets are hitting wash drum.
Close washer lid.
Thermal limiter tripped.
LP gas...laundry center. It may be at least 4 inches in INSTALLATION INSTRUCTIONS. Squealing sound or hot rubber odor.
If noise continues after washer is open . Do not overload washer.
The washer...
Complete Owner's Guide - Page 21
...of the drum finish. drain or drains slowly. Water leaks.
Water is a distance from washer. wash cycle is not hot enough. did not occur. Do not bypass lid lock. Items left in... "Operating Instructions." and fasteners may be hitting the inside the dryer.*
Remove objects from pockets before or during washer use at a time.
are not completely open hot and cold faucets....
Installation Instructions - Page 3
...Foam shipping restraint (inside wash tub) removed and stored Shipping bolt (underneath appliance) removed and stored
Leveling
Laundry Center is level, side...-to-side and frontto-back Cabinet is setting solid on all corners
Water Supply
Use only new hoses and verify rubber sealing washers are labeled with a WARNING or CAUTION based on Laundry...
Installation Instructions - Page 13
...
PLASTIC CLIP
3.
NOTE
If the laundry center is to be transported at a later date, the tub blocking pad, shipping bolt, and plastic spacer block should be completed.
1. Using a ratchet with 3/8" (10 mm) socket, remove the mechanism shipping bolt and plastic spacer block from the center of the washer, remove the wire shipping clip securing...
Installation Instructions - Page 14
... through the pipe. conversion kit must be installed by brushing on Back of the dryer. Wait a few minutes for the connection. INSTALLATION INSTRUCTIONS
Gas connection
1 Remove the shipping cap from gas supply line to the gas shutoff valve.
14
Installation Instructions - Page 17
... the water lines and remove particles
a
that might clog the water valve screens and to the COLD water supply. Tighten by hand until snug. RUBBER WASHERS MUST BE PRESENT
USE ...the HOT inlet connection on the washer and the COLD inlet hose to the COLD inlet connection on the washer. Then tighten each supply connection another 2/3 turn with laundry center purchase. Keep the leveling ...
Installation Instructions - Page 19
... or a standpipe and secure the drain hose with the
laundry center. It contains valuable and helpful information that will save you time and money. 5 Run the washer through a complete cycle, checking for water leaks and proper operation. 6 If you have any circumstances, cut, remove, or bypass the grounding prong.
Place the formed end...
Similar Questions
How Do You Get A Belt On A Frigidaire Washer It's A Devil Stacker
how do you get the belt on a washer
how do you get the belt on a washer
(Posted by senseiterry1 4 years ago)
Model Gleh1642fs. How To Remove Lightbulb Plate In Dryer .
There's a lightbulb in dryer with a plastic plate over it. How do you remove the plate to install a ...
There's a lightbulb in dryer with a plastic plate over it. How do you remove the plate to install a ...
(Posted by dcbrowder 8 years ago)
When Water Is Supposed To Drain, Smells Like The Unit Is Burning.
I've owned the unit for one and half years. When water is supposed to drain, smells like the unit is...
I've owned the unit for one and half years. When water is supposed to drain, smells like the unit is...
(Posted by bestladylord 9 years ago)
Stack Washer And Dryer Frigidaire Won't Agitate
(Posted by todbrh 10 years ago)