Frigidaire FEQ1442ES Support Question
Frigidaire FEQ1442ES Support Question
Find answers below for this question about Frigidaire FEQ1442ES - 27" Electric Dryer.Need a Frigidaire FEQ1442ES manual? We have 2 online manuals for this item!
Question posted by mdtemps on March 31st, 2011
Feq1442es1 Will Not Stop Beeping
The person who posted this question about this Frigidaire product did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.
Current Answers
Related Frigidaire FEQ1442ES Manual Pages
Installation Instructions - Page 2
...dryers. NEMA 10-30R (3-wire) receptacle or NEMA 1430R (4-wire) receptacle to be exhausted into the laundry...27 m)
14 ft. (4.27 m)
10 ft. (3.05 m)
NOT RECOMMENDED PRE-INSTALLATION REQUIREMENTS
Tools and Materials Required for use any circumstances remove grounding prong from a neighbor's phone. ELECTRICAL REQUIREMENTS
ELECTRIC Dryer...6.
When the dryer stops, the dampers ...
Installation Instructions - Page 3
.... Read the measurement on electric dryers, exhausting can be of the dryer.
cm)
GAS SUPPLY REQUIREMENTS
Replace copper connecting pipe that will cause an increase in vent restriction. • Running the exhaust system through your dryer to the right or left side of the cabinet or the bottom of 1/2 inch (1.27 cm) pipe. 3. Stainless steel...
Installation Instructions - Page 4
... to clear knobs (70.49cm) 28.5 to clear door handle (72.39cm)
2.375" (6.03cm)
(34.29cm) 13.5" To rear & base exhausts
27.0"
(68.58cm)
Stacked Dryer Installation Dimensions
(68.58cm) 27.0"
Electrical supply on rear of unit
28.25" to front of cabinet(71.76cm)
28.75" to clear knobs (73.03cm) 29.5" to...
Installation Instructions - Page 5
...enclosed, the exhaust system MUST terminate outside make up or move the dryer.
2.
Return the dryer to the dryer front panel with the termination securely fastened to the floor.
Remove ... Metal ducting must be fastened to the mobile home structure.
3.
When installing a gas dryer into a mobile home, a provision must be exhausted outside (outdoors, not beneath the ...
Installation Instructions - Page 6
NOTE: You may need a plastic knife to the dryer front panel. Remove the four screws that secure the door hinges to help remove the ... 6. Retain the plugs for use them to help remove the plugs. Align the handle holes in Step 4. 7. Open the dryer door. Be careful to avoid scratching the paint. 5. Apply moderate downward pressure on the left side of the hinges. 10. ...
Installation Instructions - Page 7
... the strain relief.
6. Finger tighten the nut only at this time.
5. Tighten both screws securely.
Do not use an aluminum wired receptacle with two screws. ELECTRIC Dryer
TYPICAL 4 CONDUCTOR
TYPICAL 4 CONDUCTOR
BLACK WHITE
1. Remove the screws securing the terminal block access cover and the
RED
strain relief mounting bracket located on the...
Installation Instructions - Page 8
... 1-800-944-9044, or visit our website, www.frigidaire.com, for service.
7. Connect a 1/2 inch (1.27 cm) I.D.
Place these instructions in your dryer does not operate, please review the "Avoid Service Checklist" located in a location near the dryer for play. Test all connections by a qualified gas technician.
2. Wiring errors can become airtight chambers causing...
Operating Instructions - Page 1
... type of drying time.
Load the dryer. A signal will automatically be dried. Auto Dry Auto Dry cycles take the guesswork out of installation and electrical voltage or gas pressure can also affect... settings, press PAUSE/CANCEL once.To resume the cycle, press START again. • To stop or change the dryness level, press DRYNESS until the indicator for each load. PN 134420600C (0412)...
Operating Instructions - Page 2
...in the future, select More Dry. The dry load will not light.
Dryer Features
Control (Control Lock) To avoid having someone accidentally start or stop the dryer, press OPTIONS and SELECT at the end of the cycle. You will automatically... remove wrinkles from clean and dry items that cycle is selected, a beep will beep 3 times. To remove the control lock, press OPTIONS and SELECT again.
Operating Instructions - Page 3
... Dry **
*
PN 134420600C Consult the Error Code Chart below or the "Avoid Service Checklist" in the control panel. Dryer overloaded. ERROR CODE CHART
If the dryer stops, the status lights flash and the signal beeps, an error has occured. Make correction, then select a cycle and press START. Remove lint; Press buttons lightly and release...
Similar Questions
Trouble Restarting Electric Dryer
After an electric dryer warms it will not restart unless the selector nob is tapped. Which part need...
After an electric dryer warms it will not restart unless the selector nob is tapped. Which part need...
(Posted by jrpetrick 5 years ago)
Frigidaire Electric Dryer Fer641fs. No Heat. Timer Not Advancing.
My electric dryer has no heat and the timer is not advancing like it suppose to. It just keeps spinn...
My electric dryer has no heat and the timer is not advancing like it suppose to. It just keeps spinn...
(Posted by mouatech 10 years ago)
How To Reset Frigidaire Dryer Model Feq1442es1 To Stop Beeping
(Posted by Angelhea 10 years ago)
Frigidaire Dryer Won't Stop Beeping
(Posted by billyasani 10 years ago)
