Frigidaire FEC30S6AB Support Question
Frigidaire FEC30S6AB Support Question
Find answers below for this question about Frigidaire FEC30S6AB - on 30" Smoothtop Electric Cooktop.Need a Frigidaire FEC30S6AB manual? We have 3 online manuals for this item!
Question posted by delta0512 on April 13th, 2012
All Burners Will Cycle On And Off Very Quickly On Any Heat Setting
see question title
Current Answers
Related Frigidaire FEC30S6AB Manual Pages
Installation Instructions (All Languages) - Page 1
....2) 32 1/4 (81.9) 32 1/4 (81.9) 36 3/4 (93.3) 36 (91.4)
36 (91.4)
B. pages 1-6
1
Español -
C
Cooktop Cutout Dimensions
F
E D * 30" (76.2 cm) min. pages 7-13 Français -
Cooktop Dimensions
30" Min. *
A
B
(76.2 cm)
IMPORTANT INSTALLATION-INFORMATION
• All electric cooktops run off a single phase, three-wire or four-wire cable, 240/208 volt, 60 hertz, AC only...
Installation Instructions (All Languages) - Page 2
...Front Edge of Unit). From Edge of
Cooktop to chart on this cooktop since burner box
extends G below surface of Cutout
...30" (76.2 cm) Min. CAUTION To eliminate the risk of the cabinets.
12" (30.5 cm)
Drawers cannot be avoided. ELECTRIC COOKTOP... storage is Protected by reaching over heated surfaces, cabinet storage space located above the cooktop should be used with this figure refer...
Installation Instructions (All Languages) - Page 3
... is installed and grounded properly by a qualified installer or service technician.
• These cooktops must not be pretreated before use may result in Canada. Electrical Connection
Connect the flexible armored cable that the ceramic-glass smoothtop be used with CSA Standard C22.1, Canadian Electrical Code, Part 1, and local codes and ordinances.
3 Then make the...
Installation Instructions (All Languages) - Page 4
...(or bare copper) wire (and the white wire for model with the National Electrical Code and local codes and ordinances. This appliance is manufactured with a copper conductor... cable is supplied) to aluminum, and follow the manufacturer's recommended procedure closely.
2. ELECTRIC COOKTOP INSTALLATION INSTRUCTIONS
This appliance is equipped with a frame connected green (or bare copper) ground...
Installation Instructions (All Languages) - Page 5
... on the shafts and press down information. ELECTRIC COOKTOP INSTALLATION INSTRUCTIONS
Cooktop Installation
1.
These spacers center the cooktop in figure 12. 4. Models: 32" Coil Elements Cooktops 1. Remove all remaining work must be installed, to prevent excess heat buildup that may result in "Electrical Connection" section. After setting the unit into countertop opening and...
Installation Instructions (All Languages) - Page 6
The tumb screw should then be run thru
bracket and un against burner box walls.
4. Models: 30" and 36" (36"X 211/2") Coil Elements Cooktops - These cooktops are not the result of defective workmanship or materials in this appliance. SPACER
BURNER BOX SCREW
Figure 13
3. Make electrical connections as shown in an existing countertop opening (not exceeding maximum...
Complete Owner's Guide (English) - Page 1
F Electric
Cooktop
CONTENTS
Page
Versión en español 2
Product Registration 2
Important Safety Instructions 3-4
Selecting Surface Cooking Utensils 5
Specialty Pans & Trivets 5
Canning Tips & Information 6
Setting Surface Controls 6
Indicator Lights (Coil Elements Models 6
Ceramic Glass Cooktop (Some Models 7-10
Types of Heating Units Used 7
Hot Surface Indicator ...
Complete Owner's Guide (English) - Page 2
...de este Manual del Usuario, sírvase escribir a la dirección que se incluye a continuación. Your cooktop may have all the described features. The information contained within this appliance.
Product Registration
Register Your Product
The PRODUCT REGISTRATION... new appliance.
If service is performed while the appliance is under the cooktop or inside the burner box.
Complete Owner's Guide (English) - Page 3
... not be allowed to sit or stand on the cooktop to burst and result in ignition of a pot holder.
• Do Not Heat Unopened Food Containers. The use , do not touch...an authorized repair service. IMPORTANT SAFETY INSTRUCTIONS
Read all instructions given. Know how to disconnect the electrical power to cause burns. Areas near surface units. Here is equipped with packaging material.
&#...
Complete Owner's Guide (English) - Page 4
... and Not Extend Over Adjacent Surface Units. FOR COOKTOPS WITH COIL ELEMENTS ONLY
• Do Not Immerse or Soak Removable Surface Heating Elements. Absence of the appliance.
Contact a qualified... burns, ignition of electric shock. Only certain types of glass, glass/ ceramic, ceramic, earthenware, or other use aluminum foil to the appliance.
Surface heating elements should break, ...
Complete Owner's Guide (English) - Page 5
...of the porcelain enamel range surface, and damage to the surface elements and/ or damage to heat one large pan such as lobster pots, griddles and pressure cookers may be used . The ...be used in the oven or on your cooktop are available in direct contact with the surface elements.
5 Check for its intended purpose. For glass smoothtop models, only flat bottomed woks (without support ...
Complete Owner's Guide (English) - Page 6
... small amounts and light loads. Check with hot water and a high heat setting to be sure all the control knobs have an indicator light for the latest canning information.
2. Start with your local Cooperative Agricultural Extension Service or a manufacturer of the cooktop when it takes to bring water to avoid canning on top...
Complete Owner's Guide (English) - Page 7
...radiant elements (some models)
The ceramic-glass cooktop has electric heating coils located below the ceramic glass surface. knobs...smoothtop surface (without cooking utensils) is too small for small utensils use the larger graduations; Placing foods directly on the cooktop may not look identical to be found under the ceramic glass cooktop: - Types of heat that has a dual set the heat...
Complete Owner's Guide (English) - Page 8
...serving temperatures by HI, MED and LO. Do not use plastic warp to the chart for recommended heating levels. Plastic may melt onto the surface and be covered with the medium level, and adjust ...continue to glow until the hot surface indicator light goes off.
To set at any position between HI and LO for oven and cooktop use potholders or oven mitts when removing food from the warm zone ...
Complete Owner's Guide (English) - Page 9
... to boil dry, not only will be minimized by continual use .
These marks should break, do not affect cooking. Use and Care of heat generated by such items. 6.
Sliding or scraping metal utensils or oven shelves across cooktop surface. NOTE: Due to a cooled surface. The ceramic
surface may scratch or metalmark the...
Complete Owner's Guide (English) - Page 10
...cooktop surface and are clean and dry. Do Use on Ceramic Glass Cooktop 1. For burned on a heated surface. Avoid rust stain removers containing hydrofluoric acid. 5. Scrub with single-edged razor blade, held at a 30...
Start with damaging or hazardous results. Select heat settings and cookware large enough for Ceramic Glass Cooktop Some cleaning materials may interact, with approximately ...
Complete Owner's Guide (English) - Page 11
.... 3.
To Remove and Replace Surface Elements and Drip Bowls (some models)
Before cleaning the cooktop, be permanently damaged if turned on the coil elements as possible and slide the terminal end ... be sure the controls are set at OFF. Be sure the surface element is COOL. Gently lower the cooktop into the frame.
DO NOT drop or bend the cooktop when raising or lowering.
Never...
Complete Owner's Guide (English) - Page 12
...cloth. Excess water in a slightly diluted liquid cleanser or a solution made especially for 30 to 60 minutes. Food spilled on brushed chrome. Always rinse with clean water and ...damaged during future heating. General Cleaning (Continued)
Cleaning Various Parts of Your Cooktop
Before cleaning any part of the cooktop, be sure all controls are turned OFF and the cooktop is used. Surfaces...
Complete Owner's Guide (English) - Page 13
... has tripped. If the problem is on ceramic glass cooktop surface.
Contact installation agent or dealer. Power outage. Call local electric company. Surface element does not heat. If the problem is properly connected to a slightly higher setting until proper amount of heat is incorrect. Too low heat setting. Turn control to the specified power source. Be sure...
Complete Owner's Guide (English) - Page 16
... THE DURATION OF IMPLIED WARRANTIES, SO THESE LIMITATIONS OR EXCLUSIONS MAY NOT APPLY TO YOU. If service is performed, it is installed, used in a commercial setting.
7. Obligations for appliances not in materials or workmanship when such appliance is shipped from the factory.
10. Service calls to repair or replace appliance light...
Similar Questions
Frigidaire Fpec3085ks Error
I just installed a new unit and when I turn the breaker on the 4 burner displays read from top to bo...
I just installed a new unit and when I turn the breaker on the 4 burner displays read from top to bo...
(Posted by morgantaylor 11 years ago)
Limiter Function
All burners cycle and do not maintain the correct heat setting. Would a replacement harness with lim...
All burners cycle and do not maintain the correct heat setting. Would a replacement harness with lim...
(Posted by delta0512 12 years ago)
Reset Power
30 amp circuit breaker tripped upon power outage. When power came back on everything worked except c...
30 amp circuit breaker tripped upon power outage. When power came back on everything worked except c...
(Posted by cebeck 12 years ago)