Frigidaire FARG1011MW Support Question
Frigidaire FARG1011MW Support Question
Find answers below for this question about Frigidaire FARG1011MW.Need a Frigidaire FARG1011MW manual? We have 5 online manuals for this item!
Question posted by louborr on April 17th, 2017
How To Take Apart Farg1011mwo Affinty Dryer
how to take this model apart to repair
Current Answers
Related Frigidaire FARG1011MW Manual Pages
Installation Instructions (English, Español, Français) - Page 1
All about the
Installation
of your Dryer
TABLE OF CONTENTS
Important Safety Instructions 2-3 Accessories 19 Installation Requirements 4-10 Notes 20 Installation Instructions 11-16 Français 21 Reversing Door 17-18 Español 41
137410000B (1204)
Installation Instructions (English, Español, Français) - Page 2
... literature included with the National Fuel Gas Code, ANSI Z223.1/NFPA 54.
• The dryer is unpacked.
Pre-Installation Requirements
Tools and materials needed for installation:
• Adjustable pliers ... square bit
screwdrivers • Adjustable wrench • Pipe wrench for gas supply (gas
dryer) • LP-resistant thread tape (for play. Good safe practice and caution MUST be...
Installation Instructions (English, Español, Français) - Page 3
... manual are labeled with a WARNING or CAUTION based on all corners
Gas Supply (Gas Dryer)
‰ Manual shutoff valve present in
3 CAUTION
CAUTION indicates a potentially hazardous situation which...; Test hinge and latch for function
Electrical Power
‰ House power turned on ‰ Dryer plugged in
Final Checks
‰ Installation Instructions and Use and Care Guide read all connections -...
Installation Instructions (English, Español, Français) - Page 4
... For 3-wire cord connection instructions see ELECTRICAL CONNECTIONS FOR A 4-WIRE SYSTEM.
Í NOTE
Dryers manufactured for sale in Canada have factoryinstalled, 4-wire power supply cord (NEMA 14-30R).
4 ...connectors with upturned ends or closed loop connectors and marked for use with clothes dryers. Grounding through the neutral conductor is not recommended. branch circuit fused with power...
Installation Instructions (English, Español, Français) - Page 5
...connection, MUST be installed immediately upstream of local codes, with the Standard for Connectors for gas dryer
CIRCUIT - Individual, properly polarized and grounded 15 amp.
POWER SUPPLY CORD - See "Grounding ...in accordance with local codes, or in excess of 1/2 psig (3.45 kPa).
7 The dryer MUST be constructed of the gas supply piping system at test pressures equal to the gas supply...
Installation Instructions (English, Español, Français) - Page 6
...) rigid or flexible metal duct and approved vent hood which has a swing-out damper(s) that open when the dryer is free of any other obstruction.
WARNING
FIRE HAZARD Do not install a clothes dryer with a rigid or semi-rigid metal duct.
Also, ensure the present duct is in operation.
These conditions will...
Installation Instructions (English, Español, Français) - Page 7
.... Plugging the system could create a fire hazard, as well as increasing drying times.
If the dryer is not exhausted outdoors, some fine lint will be expelled into a chimney, a wall, a ...
7 INSTALLATION REQUIREMENTS
Exhaust system requirements, continued
WARNING
FIRE HAZARD A clothes dryer must be connected to an exhaust outdoors. Do not exhaust dryer into the laundry area.
Installation Instructions (English, Español, Français) - Page 8
... of the exhaust system is acceptable, certain extenuating circumstances could affect the performance of the dryer:
• Only rigid metal duct work should check the exhaust system and vent hood for... 0.75 inches of water column, the system is too restrictive and the installation is acceptable. Dryer vent elbows are available through a roof may expose the exhaust system to air fluff ...
Installation Instructions (English, Español, Français) - Page 9
...with approved Mobile Home Installation Kit - in . (387.1cm²)
9
DO NOT install your dryer in diameter with equivalent air openings for proper ventilation. A louvered door with no obstructions. This provision ...home structure.
4 Refer to previous sections in the same closet as the gas dryer.
3 Your dryer needs the space around it for the full length of door. Openings should be ...
Installation Instructions (English, Español, Français) - Page 10
...;oor line
29" (73.5 cm) to front of 18 inches (45.7 cm) above the floor. INSTALLATION REQUIREMENTS
Clearance requirements
IMPORTANT
DO NOT INSTALL YOUR DRYER: 1 In an area exposed to dripping water or outside weather conditions. 2 In an area where it must be vented straight back to achieve 0" (0 cm) rear...
Installation Instructions (English, Español, Français) - Page 11
...malfunction or breakdown, grounding will not fit the outlet, have longer drying times than dryers operating on 240 volt power supply. WARNING
ELECTRICAL SHOCK HAZARD • This appliance MUST...ed electrician. Failure to be installed onto
power cord. For a grounded, cord-connected dryer:
1 The dryer MUST be properly grounded. If in accordance with all local codes and ordinances. Check ...
Installation Instructions (English, Español, Français) - Page 12
...64257;t the outlet, have a proper outlet installed by a qualified electrician. Gas dryer (USA and Canada)
1 The dryer is equipped with a three-prong (grounding) plug for electrical current.
2 Since your ...
2 The plug must be grounded. In the event of least resistance for your dryer is equipped with this appliance. INSTALLATION INSTRUCTIONS
Grounding requirements - If in doubt as ...
Installation Instructions (English, Español, Français) - Page 13
... Flare Valve Union
GAS FLOW
Flare Union
Closed Nipple
Open
Flexible Connector
Inlet Pipe on Back of Dryer
All connections must be wrench-tightened
IMPORTANT
The supply line must be equipped with an approved manual ...shutoff valve. This valve should be located in the same room as the dryer and should be in the gas supply line to allow gas to flow through the gas...
Installation Instructions (English, Español, Français) - Page 14
... in the terminal screw recovery slot below the access panel. Neutral terminal
IMPORTANT
If moving dryer from the center terminal back to the GREEN screw next to the terminal block.
14 ...the screw securing the terminal block
access cover in the lower corner on the back of the dryer. 3 Install a UL-approved strain relief according to the power cord/strain relief manufacturer's instructions ...
Installation Instructions (English, Español, Français) - Page 15
... cord, NEMA 14-30 type ST or SRDT, through the strain relief. 5 Disconnect the internal (WHITE) dryer harness ground wire from the (GREEN) ground screw next to the terminal block. 6 Attach the ground (GREEN...or RED power wire
BLACK or RED power wire
15 Tighten the screw securely. 7 Move the internal dryer harness ground (WHITE) wire to the terminal block and attach it can be loosely in place. ...
Installation Instructions (English, Español, Français) - Page 19
... could result in a mobile home requires the use of your model did not include a drying rack or you desire another drying rack, you purchased your dryer or refer to console housing and reinstall hole plugs.
TOUCH UP... 5304468812 *Other colors may have been included in a location supplied with repair, return sheet inside the dryer console. ACCESSORIES
LP CONVERSION KIT
P/N PCK4200 Gas...
Complete Owner's Guide (English) - Page 3
... excessive amount of aerosol into, on or near the dryer. Do not stack or place laundry or throw rugs against the front or back of the dryer.
• Do not spray any type of lint ... oils in inefficient drying and possible fire. IMPORTANT SAFETY INSTRUCTIONS
240 v Electric Dryer
120 v Gas Dryer
10-30R 3-wire
(fused 30 amp)
14-30R 4-wire
UL-approved service cord must be ...
Complete Owner's Guide (English) - Page 4
...shock could result in serious personal injuries. PREVENT INJURY AND DAMAGE TO THE DRYER
• All repairs and servicing must be produced by an authorized servicer unless specifically...so can become airtight chambers.
• Keep laundry products out of substances known to the state to such substances. Never ground the dryer to INSTALLATION INSTRUCTIONS for play on or in ...
Complete Owner's Guide (English) - Page 14
...door opening and in the Important Safety Instructions and those listed below.
• Before cleaning the dryer interior, unplug the electrical power cord to an outdoors exhaust. Hazardous fumes or electrical shock could ...listed in the surrounding area.
IMPORTANT
Do not store or place laundry products on top of dryer at the bottom of lint around the opening . They can collect lint and dust over...
Product Specifications Sheet (English) - Page 2
.../ Cancel Knobs Delay Start Tumble Speed (RPM) Reversible Door Lint Screen Sound Package Adjustable Leveling Legs
Frigidaire Affinity (M models) 7.0 Express-Select® Painted Steel
Yes Yes
Yes Chime Yes
Yes
50 Yes Yes
A
4
Cycles
Dry Cycles
... frigidaire.com. Width
27"
C - Refer to change. Dryer
Top Load Laundry - Height
43"
B - Dryers (Electric FARG1011M W & Gas) 7.0 Cu.
Similar Questions
Cleaning Lint From 'inside' The Gas Dryer
Looking for step by step instructions on how to clean the lint from inside the dryer. Cleaning the l...
Looking for step by step instructions on how to clean the lint from inside the dryer. Cleaning the l...
(Posted by obdad 9 years ago)
How Do I Take Apart My Dryer To Install Hi Temp Thermostat?
E-64 is what is displayed on my dryer. We cleaned all vents. Ordered and recieved replacement thermo...
E-64 is what is displayed on my dryer. We cleaned all vents. Ordered and recieved replacement thermo...
(Posted by mainman542002 10 years ago)
How To Access Burner
I am needing to convert my dryer to LP but don't know how to access the burner
I am needing to convert my dryer to LP but don't know how to access the burner
(Posted by Baileyplmbg 12 years ago)
Affinity Gas Dryer Venting
for the right vent option for gas dryer, is this to right when facing the dryer or from back of drye...
for the right vent option for gas dryer, is this to right when facing the dryer or from back of drye...
(Posted by schielej 12 years ago)
Dryer Recalled?
There are alot of complaints on this dryer and now mine is overheating. Has it been recalled?
There are alot of complaints on this dryer and now mine is overheating. Has it been recalled?
(Posted by chickencoop30 13 years ago)