Home » Frigidaire » Laundry Washers » Frigidaire FAFW3921NW

Frigidaire FAFW3921NW Support Question

Find answers below for this question about Frigidaire FAFW3921NW.
Need a Frigidaire FAFW3921NW manual? We have 3 online manuals for this item!

Frigidaire Overview Questions Manuals Reviews Videos Research

Question posted by aluly on April 4th, 2023

Command/control (display/buttons) Board Looks Ok But Machine Does Not Start.

The washer machine seems to be ok when turned-on, display and selector buttons seem to function ok but when commnded to start it wont start. Door lock seems to signal ok too. Please advice if replacement needed or any other service (troubleshooting) manual reading or tutorials availables. Thaks a lot, Regards.

I Know the Answer!

I have the same question
Request More Information

Current Answers

Answer #1: Posted by Technoprince123 on April 4th, 2023 10:23 AM

Technoprince123

Member since:
February 8th, 2021

Points: 1,205,190

100
points

https://www.repairclinic.com/RepairHelp/How-To-Fix-A-Washing-Machine/46-2--/Frigidaire-Washer-Won-T-Start

https://www.manualslib.com/manual/409148/Frigidaire-Fafw3921nw.html

Please response if this answer is acceptable and solw your problem thanks

Answer #2: Posted by SonuKumar on April 4th, 2023 9:00 PM

SonuKumar

Member since:
May 9th, 2021

Points: 16,633,680

100
points

If the command/control board on your Frigidaire FAFW3921NW front-load washing machine appears to be functioning normally but the machine does not start, there may be a problem with another component in the washing machine. Here are a few troubleshooting steps you can try:

Check the power supply: Make sure the washing machine is properly plugged in and the outlet has power. You can test the outlet by plugging in a different appliance or device and seeing if it turns on.
Check the door latch: Make sure the door is properly closed and latched. If the door is not closed or latched correctly, the washing machine may not start.
Check the water supply: Make sure the water supply to the washing machine is turned on and the hoses are properly connected. If the washing machine does not detect a water supply, it may not start.
Check the motor control board: The motor control board controls the operation of the washing machine's motor. If the motor control board is faulty, it can prevent the washing machine from starting. You may need to replace the motor control board if it is malfunctioning.
Check the motor: If the motor is not working correctly, it can prevent the washing machine from starting. You may need to replace the motor if it is malfunctioning.

If none of these steps resolve the issue, it may be best to contact a qualified technician to diagnose and repair the washing machine.

Please respond to my effort to provide you with the best possible solution by using the "Acceptable Solution" and/or the "Helpful" buttons when the answer has proven to be helpful.

Regards,
Sonu
Your search handyman for all e-support needs!!

Related Frigidaire FAFW3921NW Manual Pages

Complete Owner's Guide (English) - Page 4

... moving. Incorrect usage can cause serious injury or death. Install washer on top. Do not rest heavy loads on a solid ﬂoor. Turning the controls to the weather. • Do not install on carpet. Before loading, unloading or adding items, push in the washer for installer's reference. Do not use or mix liquid chlorine...

Complete Owner's Guide (English) - Page 5

Cascading Wash Vanes 5 FEATURES Cycle Selector Control Lock LED Display Laundry Product Dispenser Drawer Door Latch with Safety Lock Door Striker Inner glass with small article redistribution ramp Vent Latch Stainless Steel Wash Drum Adjustable Leveling Legs As an ENERGY STAR® Partner, Electrolux Major ...

Complete Owner's Guide (English) - Page 7

...and baby socks in a mesh bag. 1 Sort laundry into loads that attract lint. OPERATING INSTRUCTIONS Operating Your Washer WARNING To reduce the risk of -balance load. The door should not be washed together. (Mesh bag not ...that shed lint from durable items. • Do not machine wash items containing ﬁberglass. Large items should close easily. • Brush off lint and dirt.

Complete Owner's Guide (English) - Page 8

... see water in either direction to the chamber labeled "LIQUID BLEACH" and marked with the detergent. Look for this symbol . • Fill to prevent oversudsing in tumble action washers. Closing the drawer too quickly could disable your machine and result in the cycle. Í NOTE From time to the MIN line for small...

Complete Owner's Guide (English) - Page 9

... care for the door lock to release. DO NOT force open the door. • A signal will be displayed as directed on the door or crawl inside the washer. "PAU" will sound at the end of the cycle, if desired. • As a safety measure, the door will automatically lock during spin, it will hear several beeps when the buttons are no...

Complete Owner's Guide (English) - Page 10

...the hottest water safe for loads that need a cold water rinse or to perform a spin only cycle or select no -iron ﬁnish. Cycle Selection Turn the cycle selector in a regular cycle. delicates Use ... not change the cycle once it has begun, press the cancel button before selecting a new cycle. Just turning the cycle selector knob to be washed. Your model may have been omitted in either...

Complete Owner's Guide (English) - Page 11

...time and hold until the signal sounds. NSF Protocol P172 Sanitization Performance of each cycle. delay start select cancel auto temp spin speed options soil level START pause To return to &#...To change the temperature once the cycle has begun, press the pause button, make the new selection and press START again. The indicator will extract more convenient time. Heavy, normal, ...

Complete Owner's Guide (English) - Page 12

...to factory settings, press the START/pause and select buttons at the same time and hold until the blinking light indicates the desired option. The signal has an adjustable volume level or...no longer be turned off. OPERATING INSTRUCTIONS Cycle Options To select or delete the chime, stain clean, energy saver, extended spin or fresh rinse, press options until the signal sounds. The ...

Complete Owner's Guide (English) - Page 13

.... To apply the vent latch, (1) open the door slightly, (2) lift the latch arm and then (3) press the arm down when you select START. Control Lock To avoid having someone accidentally start the washer, press options and select at the hinge location. The time may increase if water pressure is displayed during the cycle. The vent latch can...

Complete Owner's Guide (English) - Page 17

...soap. Pretreat with bar soap. May be impossible to pretreat or soak stains. Repeat, replacing paper towels frequently. Rinse thoroughly before washing. Use prewash stain remover or rub with ... stain remover or nonﬂammable dry cleaning ﬂuid. Use packaged color remover. Replace towels under stain frequently. Some inks may set some inks. Wash. Rub detergent into...

Complete Owner's Guide (English) - Page 18

... fresh rinse on the door or crawl inside the washer. WARNING HARMFUL VAPOR HAZARD Do not use both for 10 seconds until the display changes to begin the cycle, press and hold both . An open door could damage the washing machine. REMOVE ALL ITEMS FROM WASH DRUM before unlocking the door. 18 Press START to "CLn". For...

Complete Owner's Guide (English) - Page 19

...Replace the insert by pressing it stops. • Reach back into the left in the washer... out until you may leave the door ajar when the washer is required. CARE AND CLEANING Other... of the wash day. • Dry around the washer door opening , use . • Leave the dispenser drawer... the drawer. • Remove the insert from the washer as soon as the cycle ends. These areas should ...

Complete Owner's Guide (English) - Page 20

...procedure to help clear any residual bleach before unlocking the door. 20 WARNING HARMFUL VAPOR HAZARD Do not use or...cleaner, open the detergent drawer and pour one (1) pouch of TIDE® WASHING MACHINE CLEANER in Inside Routine Cleaning (Preventive). Select System Clean cycle as toilet cleaners, ... Cycle. delay start the washer. Select system clean cycle as above procedure.

Complete Owner's Guide (English) - Page 21

...Turn water faucets off to empty wash drum. IMPORTANT Do not store or place laundry products on top of the RV antifreeze will be expelled. 6 Press Cancel, unplug electrical power cord, dry off drum interior and close door. 7 Remove dispenser drawer. Or, touch residue with the sticky side of washer with a damp cloth. Press Start...the ﬁnish or controls. ANTIFREEZE RV Follow ...

Complete Owner's Guide (English) - Page 25

...authorized servicer. OPERATING Washer does not start. Reset circuit breaker or replace fuse. Motor is a power outage, call local electric company. Washer door is not resting ...washer has not been manually turned off). OCCURRENCE NOISE High pitch "jet engine" noise. SOLUTIONS TO COMMON PROBLEMS Service Prevention Checklist Before calling for service, review this washer. Stop washer...

Complete Owner's Guide (English) - Page 27

Functional life of God. Damages to the ﬁnish of appliance or home incurred during installation, including ...performed by Electrolux Canada Corp. THIS WRITTEN WARRANTY GIVES YOU SPECIFIC LEGAL RIGHTS. IF YOU NEED SERVICE Keep your original date of purchase, Electrolux will repair or replace any parts of trim, cupboards, shelves, etc., which do not involve malfunction or defects ...

Installation Instructions (All Languages) - Page 3

... Carpenter's level 3 IMPORTANT SAFETY INSTRUCTIONS Í NOTE The electrical service to the washer must be applied when installing, operating and maintaining any appliance. WARNING FIRE HAZARD For...Destroy the carton and plastic bags after the washer is unpacked. Tools and materials needed for play. Do not stack washer on top of washer already installed on top of dryer. IMPORTANT...

Installation Instructions (All Languages) - Page 4

... breaker. Properly grounded 3-prong receptacle to have a licensed electrician replace it with 15 amp. Check with a licensed electrician if you..., grounding will reduce the risk of least resistance for laundry hose connection. The faucets MUST be plugged into an...the equipment grounding conductor can advise you are in doubt as to the washer can reach a 74 in a risk of 1-1/4 in doubt, call ...

Installation Instructions (All Languages) - Page 8

... to relax before they can be easily pulled through shipping hole. Installing hole plugs Locate 4 hole plugs in washer back panel. UNPACKING WASHER Removing shipping hardware Í NOTE Rubber expansion material on spacers may need time to help prevent shipping damage. x 4 4 HOLE PLUGS (IN BAG) 8 x 2 x 4 x 4 2 P CLAMPS 4 BOLTS 4 SPACERS Remove all of the following...

Installation Instructions (All Languages) - Page 11

... UNIVERSAL APPLIANCE WRENCH is available to disconnection when servicing controls. Contact the source where you purchased your washer. Wiring errors can cause improper and dangerous operation. ...for this washer may have been included in personal injury, property damage or damage to the washer. (682.57.0cm" ) (3185c.0m") (2667.5c"m) Replacement parts: If replacements parts are needed for ...