Frigidaire ATF6700FE Support Question
Frigidaire ATF6700FE Support Question
Find answers below for this question about Frigidaire ATF6700FE - AffinityTM 3.5 cu. Ft. I.E.C. Capacity Washera.Need a Frigidaire ATF6700FE manual? We have 2 online manuals for this item!
Question posted by ANDYHER63 on July 31st, 2013
Washer Isn't Draining
During the was cycle the washer stop draining and will not spill if i try to run it on just spin cycle.
Current Answers
Related Frigidaire ATF6700FE Manual Pages
Use and Care Guide - Page 2
... in this Owner's Guide are not Purchase Date meant to use any electrical switch; Your washer may not have provided many important safety messages in the vicinity of this Use and Care ... word "DANGER" or "WARNING".
WHAT TO DO IF YOU SMELL GAS:
• Do not try to the washer. It also contains information about , operation, care and service.
Pedestal A pedestal accessory, Model No...
Use and Care Guide - Page 3
... INSTALLATION INSTRUCTIONS for several minutes. Avoid fire hazard or electrical shock.
Installation instructions are packed in the vicinity of the washer.
You can become airtight chambers. • Keep laundry products out of the washer.
CORRECT Use this way ONLY
Grounding type wall receptacle
Do not under any circumstances cut, remove or bypass the...
Use and Care Guide - Page 4
...; Read the Operating Instructions for details.
4. Install washer on carpet. Add laundry load to the washer: - Use only authorized factory parts. - Small particles of electric shock, disconnect this appliance from items which could result in the cycle selector knob and allow the drum to coast to a complete stop if it will pick up to comply...
Use and Care Guide - Page 5
... of the cycle. This is a result of the siphoning action and is added. • Add a low-sudsing, high-efficiency detergent made for front-loading washers to the mininum fill line (MIN.) for water temperature, water hardness, load size and soil level. • For best results, avoid oversudsing. Note: Liquid detergent will drain into...
Use and Care Guide - Page 6
...cycle, temperature, spin...• Do not slam the washer door closed or try to persons or property, comply...laundry products on stain removal products. • Keep stain removal products in damage to hang on an inside seam. • Rinse and wash items after the cycle has ended.
8.
They can damage the finish or controls. Safety Door Lock
Washing Procedures Con't
6. Start the washer...
Use and Care Guide - Page 8
...8226;Use nonprecipitating water softener. •Before washing, run hot water for a few
minutes to form a residue. •Overloading the washer.
• Rewash load.
•Use fabric softener...load size. •Rinse in a plastic container.
Wrinkling
•Overloading the washer. •Incorrect wash cycle for fabric.
This is attracting lint. •Load washed too long.
&#...
Use and Care Guide - Page 9
...to the Max Fill level and run empty washer through a
complete cycle using the Normal Cycle setting. Rinse several times with ...stops. (Figure 1) • Reach back into a properly grounded electrical outlet. 4. Disconnect hoses from water supply and drain water from the upper and lower parts of warm water and mild detergent. Select the Drain/Spin cycle. Press START and let the washer drain...
Use and Care Guide - Page 10
.... Contact plumber if necessary.
• Fill hose connection is a circuit overload, have not been removed during the spin cycle. Stop washer and reduce load. Stop washer and redistribute wash load. Adjust leveling legs and tighten lock nuts. It will stop if it becomes overheated. WATER Water collects in the house. Warm or hot water is not completely...
Installation Instructions - Page 1
...SUBJECT
Pre-Installation Requirements Electrical Requirements Grounding Requirements Water Supply Requirements Drain Requirements Rough-In Dimensions Location Of Your Washer Unpacking Installation Replacement Parts
PAGE
2 2 2 2 2 3 ...simplify the installation and ensure the washer is installed correctly and safely. WHAT TO DO IF YOU SMELL GAS · Do not try to prevent property damage, personal ...
Installation Instructions - Page 2
...local utility company is
absence of least resistance for Installation: 1. Carpenter's level. DRAIN REQUIREMENTS
1. Check with a properly grounded three prong grounding type receptacle. branch ... adjustable pliers. 4. Water pressure MUST be grounded. Since your washer's water inlet. The faucets MUST be connected. Drain capable of 1-1/4 in . (201 cm) high standpipe. A...
Installation Instructions - Page 4
... building) where gasoline of cardboard to dripping water or outside weather conditions. Remove the carton.
2.
LOCATION OF YOUR WASHER
DO NOT INSTALL YOUR WASHER: 1. In an area exposed to protect the floor, lay the washer on it will come in contact with a maximum slope of 1/2 in . (7.6 cm) from top and bottom of the...
Installation Instructions - Page 5
... not crossthread or over-tighten these connections.
4.
Adjust the leveling legs so the washer is SOLID on the floor on and check for the slightest movement. Run some water from the back panel of the final location.
6.
Carefully move the washer to -corner. For free standing installation and with the pedestal. Adjust the...
Installation Instructions - Page 6
...washer.
Run the washer through a complete cycle. The instructions in the enclosure package) to the washer. Maximum benefits and enjoyment are achieved when all the Safety and Operating instructions are not meant to ensure the power is unpacked. Secure the drain...inside of the drain hose in personal injury, property damage or damage to the standpipe, inlet hose, laundry tub, etc....
Similar Questions
What Is The Capacity Of Washer In Cu.ft
(Posted by Anonymous-150685 9 years ago)
What Is The Cu Ft Size Of My Washer
i am tying o find out the cu ft size of my washer dryer
i am tying o find out the cu ft size of my washer dryer
(Posted by kookiaz2 9 years ago)
My Frigidaire Affinity Clothes Washer Does Not Drain Completely By End Of Spin.
It appears to have fully drained, but after a few hours, the tub is partially filled with foul smell...
It appears to have fully drained, but after a few hours, the tub is partially filled with foul smell...
(Posted by pmathieu 9 years ago)
