Frigidaire AEQ8000FE Support Question
Frigidaire AEQ8000FE Support Question
Find answers below for this question about Frigidaire AEQ8000FE - Affinity 5.8 cu. Ft. Dryer.Need a Frigidaire AEQ8000FE manual? We have 2 online manuals for this item!
Question posted by Jl3933 on February 5th, 2015
Frigidaire Affinity Aeq8000fe0 No Heat
Frigidaire affinity aeq8000fe0 no heat
Current Answers
Answer #1: Posted by waelsaidani1 on February 5th, 2015 4:15 PM
waelsaidani1
Member since:
May 12th, 2013 Points: 19,501,797
Member since:
May 12th, 2013 Points: 19,501,797
Here is a video guide on how to solve this problem: https://www.youtube.com/watch?v=OCKynRU2SUY
Related Frigidaire AEQ8000FE Manual Pages
Use and Care Manual - Page 2
... of this Use & Care Guide and the Operating Instructions included with your
Purchase Date dryer.
We have every feature included. Always read and obey all instructions before using this...a neighbor's phone. Pedestal A pedestal accessory, Model No. For your gas supplier, call your dryer are not followed. Record and • Care
retain these numbers. It also contains information about ...
Use and Care Manual - Page 3
... other packing materials after each load. Note: The instructions appearing in inefficient drying and possible fire. Some rubber materials, when heated, can become airtight chambers. • Keep laundry products out of the dryer, lint screen housing and exhaust duct should be practiced when installing, operating and maintaining any accumulation of lint around the...
Use and Care Manual - Page 4
...until the dryer has stopped completely before reaching inside. • Close the door and press Start to persons, read and follow fabric care labels and laundry product ...dryer from those that lint screen is moving. Load the dryer.
• The average load will be removed. If the dryer is moved to prevent tangling and for operating your specific model information. 5. Dryer heat...
Use and Care Manual - Page 5
... -Risk of Fire - To remove this build-up .
Use only the Air Fluff/No Heat option for directions on whenever the door is not in the screen restricts air flow,
which ... could result in warm, soapy water. The screen is equipped with a reversible door. Reversible Dryer Door Your dryer is located at the end of the cycle and periodically during loading and unloading.
Remove by ...
Use and Care Manual - Page 6
...dryer at medium or low heat for cleaning the cabinet.
• Before moving the dryer... fold.
• Do not overload dryer. • Remove items as soon ...(120 ml) in dryer
after cycle ends.
...dryer to
electricity.
• Or, add a fabric softener sheet and
reduce static electricity.
• Lint screen not clean
tumble without heat...• Do not overload dryer.
• Overdrying causes ...
Use and Care Manual - Page 7
....
Items left in wall outlet. Remove items as soon as belt buckles, zippers and fasteners may turn but won't heat.
SOLUTION
Make sure the plug fits tightly in dryer too long.
Dryer should heat when utility service is not covered by the warranty.
7
or buttons are inside of material securely around ornaments before drying...
Installation Instructions - Page 2
...only. Pipe thread sealer (Gas). 9. Plastic knife.
2 NOTE: The gas service to the Dryer must be followed to minimize the risk of fire or explosion or to hazards that can kill ... For your appliance. Do not store or use any phone in Canada, CAN/ACG B149.1-2000 NOTE: The Dryer is installed correctly and safely. Phillips head screwdriver. 2. Duct tape. 6. This symbol alerts you to prevent ...
Installation Instructions - Page 3
... venting materials are specific requirements for (1) New branch circuit installations (2) mobile homes; (3) recreational vehicles; OUTLET RECEPTACLE -
Risk of insects and rodents. Do not exhaust dryer into the laundry area. and (4) areas where local codes do not permit grounding through the neutral, (1) disconnect the link from
plug.
NEMA 10-30R receptacle to be...
Installation Instructions - Page 4
..., the system is unacceptable. Rigid Metal Duct
VENT HOOD TYPE (Preferred)
Louvered
4" (10.2 cm)
60 ft.(18.28 m)
2½" (6.35 cm) 48 ft.(14.63 m)
EXHAUST DIRECTION All dryers shipped from the factory are kept or stored. The dryer MUST NOT be higher than 0.75 inches of water column. Do not allow combustible materials...
Installation Instructions - Page 5
...be of stainless steel or plastic-coated brass. 4.
MINIMUM INSTALLATION CLEARANCES - The dryer MUST be disconnected from the gas supply piping system during any pressure testing of 1...54 cm)
0" (0 cm)
No other fuel burning appliance shall be used .
1. DO NOT install your dryer to dripping water or outside weather
conditions.
2. A minimum of 120 square inches (774.2 square cm) of ...
Installation Instructions - Page 6
Dryer Installation Dimensions
Free-Standing & Under Counter
23¾" (60.33)
24" (60.96)
...13)
Gas supply pipe on rear of unit
27" (68.58)
35" (88.90) 34" (86.36)
2.25" (5.72)
inches (cm)
27" (68.58)
Stacked Dryer Installation Dimensions
27"
(68.58)
T2T2T2T5iooo9883on..."527cfcc(cr1"55hlllo(eee3""7en((aa4a477strr.r.1369odo(..2k370cf)opo)63moebc))nars)bdinoeot111r222333444555666777888999000111222333444555666777888999000111222333444555666777888999000111222111222333444555666777888999000111222333444555666777888111111111111111111111111111111111111111111111111111...
Installation Instructions - Page 7
... inner door to the opposite side of the front panel. Install the top screw first.
6
7
"T" Hinge Slot Post
13. DRYER DOOR REVERSAL INSTRUCTIONS
Be sure to remove the door. 4. Open the dryer door. 2. Use care to the front panel.
Dispose of the inner door. Rotate it and install it to the outer...
Installation Instructions - Page 8
... the carton and plastic bags after servicing.
Failure to an upright position. Also see pages 3 and 4). Metal ducting must be used when elevating the dryer for the Frigidaire Company Authorized Parts Distributor nearest you purchased your Use and Care Guide before plugging the power cord into a grounded outlet. Using the four shipping...
Installation Instructions - Page 9
... installed by any movement of the equipment grounding conductor can cause electrical shorts. Since your dryer is equipped with a three-prong (grounding) plug for proper grounding. A U.L.
Improper ...the risk of electrical shock by a path of least resistance for electrical current. 2. The dryer is to L.P. In the event of a malfunction
or breakdown, grounding will reduce the ...
Installation Instructions - Page 10
...Tighten the strain relief nut securely so that is resistant to the back of the dryer upper corner.
2. Attach the white (neutral) power cord conductor from the power ...power cord.
8. ELECTRICAL CONNECTIONS FOR 3-WIRE SYSTEM
ELECTRICAL CONNECTIONS FOR 4-WIRE SYSTEM
USA ELECTRIC Dryer
1. approved strain relief in U.S.A.
Install a U.L. GREEN GROUND SCREW
NEUTRAL GROUND WIRE
SILVER TERMINAL...
Similar Questions
Need Specs - Width, Cubic Ft. Of Washer, Etc. (capacity)
(Posted by sjcolbert 8 years ago)
How Many Cubic In. Or Ft. Is This Dryer. 6.5 Or 7.0 ?
(Posted by chrispowell8 10 years ago)
My Dryer Is Not Heating
what part do i have to buy or what can i do cause my dryer is not heating?
what part do i have to buy or what can i do cause my dryer is not heating?
(Posted by mmirnahernandez 11 years ago)
