2002 Ford Crown Victoria Support Question
2002 Ford Crown Victoria Support Question
Find answers below for this question about 2002 Ford Crown Victoria.Need a 2002 Ford Crown Victoria manual? We have 5 online manuals for this item!
Question posted by Anonymous-109579 on April 29th, 2013
Turn Signals Don't Work And Not The Bulbs
turn signals don't work and bulbs are good
Current Answers
Related Manual Pages
Owner's Manual - Page 1
...) CD changer
22
22 26 33 39 49
Climate Controls
Manual heating and air conditioning Electronic automatic temperature control
54
54 56
Lights
Headlamps Turn signal control Bulb replacement
63
63 65 65
Driver Controls
Windshield wiper/washer control Steering wheel adjustment Power windows Mirrors Speed control Message center
72
72 73 74...
Owner's Manual - Page 15
...light will flash six times (if a door is turned to ON. Instrument Cluster
Turn signals Illuminates when the turn signals or the hazard lights are turned on.
CHECK AIR SUSPENSION OVERDRIVE OFF LOW WASHER FLUID...Speed control This light comes on when the windshield washer fluid is turned to ON and will sound for a burned-out bulb. With the ignition in RUN position, a tone will stay on...
Owner's Manual - Page 25
... information will again display for ten seconds before reverting back to increase hours.
Any time that the media is turned on, and then revert to increase minutes.
Tune adjust The tune control works in clock mode, the media information will display for ten seconds, when the radio is changed, (new radio station...
Owner's Manual - Page 30
...
• •
to decrease minutes and to increase minutes.
Any time that the media is turned on, and then revert to clock information. To set the minute, press and hold the CLK ...radio station, stereo information, etc.) and clock display mode (time). Tune adjust The tune control works in clock mode, the media information will display for 10 seconds, when the radio is changed,...
Owner's Manual - Page 51
Entertainment Systems
Radio power must be turned on a rough road, playing badly scratched discs or the disc may be that: • A disc is already loaded ...the glove box when not being used in the changer. Skipping will damage the CD player and void your changer does not work, it may be traveling on to the eyes. If sound skips: • You may be dirty. Keep the CD changer...
Owner's Manual - Page 65
...; Push down to activate the left or right turn lamp bulb (front or rear) is burned out.
HI LO
F
S OFF
The flash rate of the turn signal will speed up considerably if the left turn signal. • Push up to activate the right turn on your vehicle has been in an accident the alignment of the following...
Owner's Manual - Page 66
... extended period of time, contaminants may enter the lamp housings and affect performance. Lights
• Turn signal lamps • Backup lamps • License plate lamp Do not remove lamp bulbs unless they will provide quality bulb burn time. Using the right bulbs Replacement bulbs are clear in the chart below. To replace all instrument panel lights -
Owner's Manual - Page 67
... from the rear) to the unlock position. 3. Without turning, remove the old bulb from the lamp assembly by gently pulling it counterclockwise (when viewed from the bulb by rotating it straight back out of children's reach. Replacing headlamp bulbs To remove the headlamp bulb: 1. Remove the bulb retaining ring by pulling rearward.
4. Keep the ring to...
Owner's Manual - Page 68
...work properly. If the headlamp was correctly aligned before you changed the bulb, you feel a "stop." 3. Make sure headlamp switch is in reverse order.
68 Rotate the bulb socket counterclockwise and remove from the bulb by turning...new bulb's plastic base facing upward, insert the glass end of the lamp assembly. 2. Replacing front parking lamp/turn signal bulbs The park/turn lamp bulbs can ...
Owner's Manual - Page 69
... vehicle with three nut and washer assemblies ensuring the washers on the nuts are located in the new bulb. 6. Lights
Replacing tail lamp/brake/turn lamp bulbs
The tail lamp, the brake lamp and the turn signal lamp bulbs are flush with the body to prevent water from entering the trunk. 8. Make sure headlamp switch is...
Owner's Manual - Page 70
... headlamp switch is in OFF position, then open trunk and remove bulb socket from the trunk lid. 2. Install the bulb socket in the new bulb. 3. Pull the bulb straight out of the socket and push in trunk lid by turning counterclockwise. 2. Replacing backup lamp bulbs 1. Make sure headlamp switch is in OFF position, then remove two...
Owner's Manual - Page 95
This feature will not work with the ignition in the OFF position. A decrease in either the ACC or ON position. Panic ... and Security
Sounding a panic alarm Press this control to ACC or ON. To deactivate the alarm, press the control again or turn the ignition to activate the alarm. Replacing the battery The remote transmitter is powered by the following factors: • Weather conditions ...
Owner's Manual - Page 147
...). If your vehicle until you verify that a fuse has blown or the vehicle's brakelamps are working properly. See your vehicle. Do not rock the vehicle if the engine is possible that the brakelamps...stopping between shifts, in a steady pattern. Press lightly on the accelerator in each gear. Turn the ignition to the LOCK position and remove the key whenever you leave your dealer or a...
Owner's Manual - Page 161
... Control Switch, Anti-lock Brakes (ABS), Instrument Cluster Speed Control Servo, Main Light Switch Illumination, Lighting Control Module (LCM), Clock, Police Power Relay Reversing lamps, Turn Signals, Shift Lock, DRL Module, EVO Steering, Electronic Day/Night Mirror Wiper Motor, Wiper Control Module Heater Blower Motor Auxiliary Power Point Not Used Multifunction Switch...
Owner's Manual - Page 191
...find out which makes tracking routine service easy. Motorcraft parts are designed and built to specifications. Turn off 1. If you disconnect the battery, the engine must "relearn" its idle conditions before... parts and service. Block the wheels to prevent the vehicle from moving parts. • Do not work on a hot engine. • When the engine is securely latched in P (Park). 2. Use...
Owner's Manual - Page 198
...power from the battery. Because your foot on the brake pedal and with your eyes when working near the battery to protect against possible splashing of acid solution. With the vehicle at ... the end walls could cause acid to flow through the vent caps, resulting in P (Park), turn off all accessories and start the engine. 3. Wash hands after handling. Battery posts, terminals and related...
Owner's Manual - Page 208
... if the correct genuine Ford or Motorcraft fuel filler cap is working. It can activate the Service Engine Soon warning. To install... for which may be covered by law and could damage your bulb is not used. The customer warranty may not be under pressure...disengage in possible personal injury. If you do not use of a turn off . 2. Otherwise, fuel may damage the fuel system or cause...
Owner's Manual - Page 213
...compared to driving on the vehicle under optimum conditions. If other emission control components continue to work properly: • Use only the specified fuel listed. • Avoid running boards, ski/...for example bug deflectors, rollbars/light bars, running out of fuel. • Do not turn off the ignition while your vehicle is not supplied with lower temperatures during the first 12...
Owner's Manual - Page 236
... ...64 daytime running light ...63 headlamps ...63 headlamps, flash to pass ...64 instrument panel, dimming ...64 interior lamps ...63, 65, 67 replacing bulbs ...65, 67-71 Lane change indicator (see Turn signal) ...65 Lights, warning and indicator ...10 air bag ...13 air suspension ...14 anti-lock brakes (ABS) ...12, 143 brake ...12 charging...
Owner's Manual - Page 238
... Transmission ...146 fluid, checking and adding (automatic) ...216 fluid, refill capacities ...225 lubricant specifications ..226, 228 Trip odometer ...21 Trunk ...92 remote release ...89, 95 Turn signal ...15, 65 V Vehicle dimensions ...228 Vehicle Identification Number (VIN) ...230 Vehicle loading ...151 Ventilating your vehicle ...141
238
Similar Questions
How Do I Get To The Transmission Shifter Light Bulb In Console Of Crown Vic Spor
(Posted by hduff12577 10 years ago)
Why The Rear Door Locks Don't Work In A 2009 Ford Crown Victoria Police
interceptor
interceptor
(Posted by ulbeg 10 years ago)
Turn Signal Does Not Work Lighting Control Module 1997 Ford Crown Victoria
(Posted by jesusid 10 years ago)
My Turn Signals Are Not Working. The Dash Light Is Not Coming On, You Can Hear T
(Posted by robklair 11 years ago)