Home » Ford » Troubleshooting » 2000 Ford Contour

2000 Ford Contour Support Question

Find answers below for this question about 2000 Ford Contour.
Need a 2000 Ford Contour manual? We have 4 online manuals for this item!

Ford Overview Questions Manuals Reviews Videos Research

Question posted by bjoseph59 on January 30th, 2013

My 2000 Ford Contour Won't Start When I Turn The Ignition Key

The red light on the passive security system on the dash flashes about every 5 seconds. When I turn the key the starter clicks but will not turn over. However the battery tested good and is fully charged. When I tried using jumper cables, the car eventualy started but immediatelyl cut out when I removed the cables from the other car. Also, the windshield wipers started even though the wiper switch was off, and the accelerator needle was bouncing all around. Seems like an electrical or computer problem. Thoughts?

I Know the Answer!

I have the same question
Request More Information

Current Answers

Answer #1: Posted by roadrunnertim on January 30th, 2013 2:44 PM

This answer was accepted by the poster of the original question.

roadrunnertim

Member since:
May 9th, 2012

Points: 1,071,190

1,100
points

Try wiping off your car key with a cloth. The resistor in the key can get dirty and not complete the circuit when you turn the key in the ignition.

If that doesn't work, the key's resistor may be defective. Try your spare key or have a new key made and see if that solves the problem.

Related Manual Pages

Owner's Manual - Page 19

Instrumentation Testing the warning and indicator lights and chimes Turn the ignition key to the on the safety belt warning chime, refer to the Seating and safety restraints chapter. 19 The following warning and indicator lights will illuminate briefly: charging system, safety belt (does not illuminate, if the driver's safety belt is open . If any of these lights do...

Owner's Manual - Page 54

...main electrical circuits are disabled. On vehicles with automatic transaxles, the ignition key can return to avoid discharging the battery unnecessarily. 3. The accessory position. Controls and features STEERING COLUMN CONTROLS 3 4 5 6 7 0 x 1000 TRACTION TRACTION NTROL CONTROL Ignition 1. Release the key as soon as the engine starts. 2 1 C H 8 55 60 70 80 50 100 120 90 140 40 60...

Owner's Manual - Page 69

... lamps will flash for the remote entry system transmitters may be caused by two coin-type, three-volt lithium batteries. Controls and features Opening the luggage compartment Press the TRUNK control. To deactivate the alarm, press the PANIC control again or turn the ignition key to the on position. Replacement batteries for approximately 2 minutes and 45 seconds.

Owner's Manual - Page 72

... approximately three seconds to indicate that the system is operating correctly. Remove the key and try again. Have the malfunction repaired by your dealer or a qualified technician as soon as possible. Controls and features Functional check When the ignition is switched on, the control light will illuminate for approximately one minute and then flashes repeatedly at...

Owner's Manual - Page 73

... security reasons. 1 2 3 4 73 If coding is switched on with the newly coded key. Controls and features Spare key programming A maximum of 8 keys in all can be coded with any two coded keys. • Insert the first key in the ignition switch and turn to position 3 within 5 seconds - Repeat the coding process after the ignition is not completed correctly, the control light flashes...

Owner's Manual - Page 84

...8226; the ignition switch is in OFF position. Within seven seconds of injury, do not deactivate/activate the Belt Minder feature while driving the vehicle. 1. Wait until the Saftety belt warning light turns off (... have to the ON position (DO NOT START THE ENGINE). 2. To reduce the risk of the Saftety belt warning light turning off the headlamps. 5. Seating and safety restraints...

Owner's Manual - Page 113

Make sure the following lights illuminate briefly. Alternative design 113 Starting 3. Turn the key to the on position (without turning the key to illuminate, have the vehicle serviced by your dealer or a qualified service technician. If a light fails to start). BRAKE BRAKE Alternative design CHECK ENGINE TRACTION CONTROL O/D OFF • If the driver's safety belt is fastened, ...

Owner's Manual - Page 114

... the accelerator depressed about 1/4 of the way down . DO NOT crank for a few seconds, apply the brake pedal and release the parking brake. 114 Turn the key to crank with the 2.0 l engine: If the engine fails to start, continue to the start within five seconds, wait ten seconds and try again. 3. The key will return to the on (3) position. 1 2 3 4 2.

Owner's Manual - Page 119

... the ignition is turned on for approximately three (3) seconds. You should not take unnecessary driving risks because of the ignition key. Driving TRACTION CONTROL (if equipped) This system prevents wheel spin at all speeds. The control will toggle this function on and off, but the feature defaults to the on position, the traction control system light...

Owner's Manual - Page 122

... in any position except P (Park), the ignition key cannot be turned to lock or removed from P (Park) with the brake pedal depressed: 1. Turn the ignition off and remove the ignition key. 2. Driving Overriding the brake-shift interlock feature If it is necessary to use the accelerator as necessary. When the gearshift is secure in the Roadside emergencies chapter. Rotate...

Owner's Manual - Page 142

... again for leaking fuel. 3. Turn the ignition key to the on position for a few seconds, then turn it to start your vehicle. Roadside emergencies If you may have a different mechanical problem. 4. Check under the vehicle for leaking fuel. If the button is already set, you see or smell fuel, push the red reset button down. If you...

Owner's Manual - Page 149

... link 100 amp fuse link Color violet brown red light blue yellow light green pink orange yellow black blue Auxiliary relays (outside of fuse boxes) Relay R 18 R 20 R 21 R 22 R 23 R 24 R 25 R 26 R 32 Circuits switched "One touch" switch (driver's window) Not used Not used Foglamps Turn signals Panic alarm - driver's side Panic alarm - right...

Owner's Manual - Page 155

... Connecting the jumper cables 1. Note: In the illustrations, "lightning bolts" are tight and level. 5. Park the booster vehicle close to the positive (+) terminal of the discharge battery. Set the parking brake on in both vehicles and stay clear of the disabled vehicle, making sure the two vehicles do not touch. Turn all battery terminals and...

Owner's Manual - Page 158

... engine of the booster vehicle and run both engines. Start the engine of the disabled vehicle. 3. Remove the jumper cable from the "ground" metal surface. 158 Removing jumper cables Remove the jumper cables in the reverse order that the cables are clear of fan blades, belts and other moving parts of both engines for a further three minutes before...

Owner's Manual - Page 159

... positive (+) terminal of the disabled vehicle's battery. Remove the jumper cable on the negative (-) connection of the booster vehicle's battery. 4. After the disabled vehicle has been started and the jumper cables removed, allow it to idle for several minutes so the engine computer can "relearn" its idle conditions. 159 Remove the jumper cable from the positive (+) terminal of the...

Owner's Manual - Page 188

... diameters of 10 to deep tread, winter-type snow tires, space-saver or temporary use on passenger cars. Tire Quality Grades apply to give you the following information about tire grades exactly as...tire's sidewall. U.S. Department of Transportation requires Ford to new pneumatic tires for use spare tires, tires with tires that the United States Department of Transportation has set....

Owner's Manual - Page 200

Maintenance and care Cleaner air Ford approves the use of gasolines to the fuel tank or fuel system if an authorized Motorcraft fuel filler ... until it stops before completely removing the fuel filler cap. Turn off the engine, remove the fuel filler cap and reinstall it with cosolvents and additives to align the cap properly. If you start the engine, the fuel filler cap may be no more ...

Owner's Manual - Page 202

... than Ford, Motorcraft, or Ford authorized parts are considered essential to the life and performance of your vehicle and to its emissions system. The scheduled maintenance services listed in the "Scheduled Maintenance Guide" are required because they are used for maintenance replacements or for service of fuel. • Do not turn off the ignition while...

Owner's Manual - Page 203

...the charging system warning light or the check engine warning light.... TRACTION CONTROL O/D OFF 203 Alternative design Watch for fluid leaks, strange odors, smoke, loss of oil pressure, engine overheating, illumination of harmful and potentially lethal fumes into the passenger compartment. The emission system heats up the engine compartment and exhaust system, which can start...

SVT Supplement 1st Printing - Page 16

... of aftermarket parts and their effect on warranty coverage as follows: Repairs are not reimbursable under warranty at any SVT can be driven as other Ford Contour models. This information is covered in its entirety in the Ford Motor Company Warranty Guide. A word about warranty coverage A WORD ABOUT WARRANTY COVERAGE The SVT...