Home » Ford » Other » 1999 Ford Taurus

1999 Ford Taurus Support Question

Find answers below for this question about 1999 Ford Taurus.
Need a 1999 Ford Taurus manual? We have 3 online manuals for this item!

Ford Overview Questions Manuals Reviews Videos Research

Question posted by dunn20061 on January 20th, 2013

Ignition Switch

how to remove a lgnition switch video

I Know the Answer!

I have the same question
Request More Information

Current Answers

Answer #1: Posted by bengirlxD on January 20th, 2013 3:12 PM

This answer was accepted by the poster of the original question.

bengirlxD

Member since:
November 5th, 2012

Points: 6,395,085

1,100
points

I could not find a video but here are the steps to remove it: Instructions

- 1
  Turn the ignition key in your Taurus to the "II" position.
- 2
  Slide the punch pin into the access hold directly underneath the ignition switch.
- 3
  Push in on the punch pin while pulling the ignition switch out of the Taurus's steering column. Then remove the punch pin.
- 4
  Insert the new ignition switch into the steering column with the key in the "II" position. Push the switch into the column until it snaps into place. Turn the ignition key to the "Off" position.
http://www.ehow.com/how_5766659_replace-ignition-switch-ford-taurus.html

Feel free to resubmit the question if you didn't find it useful.

Related Manual Pages

Warranty Guide 5th Printing - Page 11

..., turbocharger, powertrain control module, electronic driver unit, injectors, injection pressure sensor, high pressure oil regulator, exhaust back pressure regulator and sensor, camshaft position sensor, accelerator switch. For more information, see pages 11-24. after the vehicle leaves Ford's control • non-Ford parts installed after the warranty start date or 100...

Warranty Guide 5th Printing - Page 17

...; Cold Start Enrichment System • Cold Start Fuel Injector (1) • Controls for Deceleration • Distributor Assembly • Electronic Ignition System • Exhaust Pipe (Manifold to Catalyst) • Electronic Engine Control Sensors and Switches • Exhaust Gas Recirculation (EGR) Valve, Spacer, Plate and Associated Parts • Exhaust Heat Control Valve • Exhaust...

Warranty Guide 5th Printing - Page 22

...Defects Warranties that apply to Catalyst) • Electronic Engine Control Sensors and Switches • Exhaust Gas Recirculation (EGR) Valve, Spacer, Plate and Associated ...Secondary Air Injection Pump and Associated Parts • Spark Control Components • Spark Plugs and Ignition Wires • Synchronizer Assembly • Throttle Air Control Bypass Valve • Throttle Body Assembly...

Owner Guide 1st Printing - Page 10

...vehicle as soon as safely possible and switch off . Check the oil level and add oil if needed. Engine oil pressure Momentarily illuminates when the ignition is turned to the ON BRAKE ...turns off when the speed control OFF control is pressed, the brake is applied or the ignition is off the engine immediately. Brake system warning Momentarily illuminates ! Illuminates when the oil ...

Owner Guide 1st Printing - Page 14

... 140 20 10 20 100 180 110 120 MPH km/h P R N D 2 1 Trip odometer Registers the kilometers (miles) of the engine coolant, not the coolant level. Never remove the coolant reservoir cap while the engine is not at its proper level the gauge indication will not be accurate. Stop the vehicle as soon...

Owner Guide 1st Printing - Page 15

...capacity due to update. 15 When refueling the vehicle from empty indication, the amount of six gallons must be added or removed from the fuel tank in order for the gauge to instantaneously update. The fuel E gauge may vary slightly when the vehicle ...in F the fuel tank (when the key is a small amount of reserve fuel in the tank. The ignition should be less than six gallons is in motion.

Owner Guide 1st Printing - Page 17

... to brighten. • Rotate down to dim. • Rotate to full up position (past detent) to turn on for a preselected period of time after the ignition switch is turned to OFF. 17 PANEL DIMMER CONTROL Use to deactivate. The autolamp system also keeps the lights on interior lamps.

Owner Guide 1st Printing - Page 24

...) until a warmer temperature is selected by pressing the temperature control. - F-DEF R-DEF + For continuous maximum cooling, push the temperature control until the display changes) to switch between 18°C (65°F) and 29°C (85°F) by pressing the temperature control. Temperature conversion AUTO - F-DEF R-DEF C AUTO OFF MAX A/C VENT TEMP...

Owner Guide 1st Printing - Page 26

...based on the ground under the air conditioner drain while the system is turned off the ignition in any position other than the air sent to reduce fogging. -Allows for maximum heating...air conditioning does not operate in this mode. Controls and features Since the air conditioner removes considerable moisture from the windshield. For added customer comfort, the air distributed through the...

Owner Guide 1st Printing - Page 30

...(whether or not a listenable station is turned back on at a "nominal" listening level when the ignition switch is located there). Seek function The seek function control works in radio mode • Press the to... radio. Tune adjust The tune control works in radio mode This control allows you wish to switch between AM, FM1 or FM2 memory preset stations. AM/FM select The AM/FM select control...

Owner Guide 1st Printing - Page 34

...above a certain level and the ignition is turned back on or off. Press the control to switch between AM, FM1 or FM2 ...memory preset stations. Controls and features Volume/power control Press the control to turn the audio system off with the power control before switching off , the volume will come back on at a "nominal" listening level when the ignition switch...

Owner Guide 1st Printing - Page 46

This is switched off the vehicle ignition. To turn speed control off • Press OFF or • Turn off , the previously programmed set speed will be greater than the set speed. Speed ...

Owner Guide 1st Printing - Page 54

.... When locking, turn it once toward the back of the vehicle to adjust 3. Controls and features Accessory delay (if equipped) With accessory delay, the window switches may be used for up to ten minutes after the ignition switch is turned to the OFF position or until any door is opened.

Owner Guide 1st Printing - Page 87

... operation If...The driver's safety belt is not buckled before the light and indicator chime ignition switch is turned to the ON position...Then...The safety belt warning light illuminates for one to...is sounding...The driver's safety belt The safety belt warning is buckled before the ignition switch is turned remain off . Seating and safety restraints extension assembly (part number 611C22).

Owner Guide 1st Printing - Page 124

...-off . If your vehicle has been involved in an emergency to turn the flashers off switch is located on the right side of vehicle breakdown, approaching danger, etc. The hazard flashers can be operated when the ignition is off. • The hazard lights control is located on top of the steering column...

Owner Guide 1st Printing - Page 125

...switch. 1. Check the fuel system for leaks in on the right side of the cargo area. Using a fuse with one that has the specified amperage rating. Use the following procedure to the OFF position. 5. Turn the ignition... rating can cause severe wire damage and could start a fire. 125 Turn the ignition to the ON position. FUSES AND RELAYS Fuses If electrical components in the vehicle ...

Owner Guide 1st Printing - Page 127

...GUIDE DRIVER WINDOW RELAY ACCESSORY DELAY RELAY The fuses are coded as follows. 5A SWITCH ILLUM 15A 15A 5A 10A HAZARD HIGH TAIL DEF SW LAMPS BEAM LAMPS ILLUM ... TR Sensor, Starter Relay 8 5A Power Antenna, RCU, GEM 9 10A ABS 10 20A PCM Relay, Ignition Coil, PATS, Radio 11 5A Instrument Cluster INTERIOR LAMP RELAY DRIVER UNLOCK RELAY BATTERY SAVER RELAY REAR DEFROST RELAY Roadside emergencies 127...

Owner Guide 1st Printing - Page 130

...Semi-Active Ride Control Module 130 175A 11 13 7 1 3 5 9 19 15 Accessory Delay Relay, Power Seat 5 40A** Ignition Switch 6 - Roadside emergencies If the battery has been disconnected and reconnected, refer to the Battery section of the Maintenance and Care chapter... Description Location Rating 1 40A** Fuse Junction Panel 2 30A** PCM Relay 3 40A** Ignition Switch, Starter Relay 4 30A C.B.

Owner Guide 1st Printing - Page 178

... headlamp bulbs Handle a halogen headlamp bulb carefully and keep out of the lamp assembly. 5. To remove the headlamp bulb: 1. Locate the headlamp bulb through the hole in OFF position, then open the...the plastic base. If you are operated. Remove the bulb retaining ring by its plastic base and do not touch the glass. Make sure headlamp switch is accidentally touched, it from the bulb....

Owner Guide 1st Printing - Page 218

... with fuel .. 165,167,171 filter, specifications .. 170,190 fuel pump shut-off switch ...124 gauge ...15 improving fuel economy ...171 low fuel warning light ...8 octane rating ...warning chime ...11 Heating ...18 heating and air conditioning system ...18 Hood ...142 Ignition ...194,195 positions of the ignition ...45 Infant seats (see Safety seats) ...95,96 Inspection/maintenance (I/M) testing ...