1997 Ford Expedition Support Question
1997 Ford Expedition Support Question
Find answers below for this question about 1997 Ford Expedition.Need a 1997 Ford Expedition manual? We have 6 online manuals for this item!
Question posted by Newdford on January 23rd, 2013
What Do I Have To Do To Install An Engine Water Pump
need instructions on installing an engine water pump?
Current Answers
Answer #1: Posted by bengirlxD on January 23rd, 2013 1:40 PM
bengirlxD
Member since:
November 5th, 2012 Points: 6,395,085
Member since:
November 5th, 2012 Points: 6,395,085
Instructions
-
- 1
Place a pan under the radiator, loosen the petcock and drain the coolant from the radiator.
- 2
Place a three-eighths-inch ratchet drive into the belt-tensioner pulley, lift up on the handle and remove the serpentine belt.
- 3
Remove the 10 bolts that secure the fan shroud to the back of the radiator with a socket and ratchet. Pull the shroud out of the engine bay.
- 4
Remove the four bolts securing the water-pump pulley to the pump.
- 5
Remove the four bolts that attach the water pump to the engine block and pull out the pump.
- 6
Clean the sealing surfaces of the new water pump and the engine block with a clean towel.
- 7
Lubricate the new o-ring seal with clean antifreeze and install the seal around the mating flange of the water pump.
- 8
Install the water pump and four retaining bolts with the socket and ratchet.
- 9
Install the water pump pulley.
- 10
Install the fan shroud.
- 11
Pull up on the ratchet drive handle and install the serpentine belt. Use the guide printed on the underside of the engine hood as a reference for installing the belt.
- 12
Pour the coolant back into the radiator.
http://www.ehow.com/how_7405640_change-pump-1998-ford-expedition.html
- 1
Feel free to resubmit the question if you didn't find it useful.
Related Manual Pages
Owner's Manual - Page 11
... the hazard lights are on or continues to flash, the ABS needs to be serviced. Instrumentation
Anti-lock brake system (ABS) Momentarily...beams Illuminates when the headlamp high beams are turned on and the engine is off. If the light stays on .
Anti-theft system ... to Fuel pump shut-off switch has been activated. For more information , refer to the ON position and the fuel pump shut-off...
Owner's Manual - Page 93
...the manufacturer's instructions. 4. Insert the tongue into the proper buckle. 5. If the child seat moves excessively, repeat steps five and six, install a tether strap or properly install the child seat... the belt webbing to discuss the special needs of your child with your pediatrician. INSTALLING CHILD SAFETY SEATS IN THE REAR SEATING POSITIONS To install a child safety seat in the center ...
Owner's Manual - Page 98
...). Seating and safety restraints
Using a tether strap Ford recommends using the instructions provided with the tether strap attached to you attach tether safety seats in a rear seating position (if possible), with the kit. Tether anchor hardware A tethered seat can be installed to a anchor bracket. put the tether strap over the seatback and...
Owner's Manual - Page 99
... park, idle, or drive your vehicle in a closed garage or in this chapter for more instructions.
100 Starting
BEFORE STARTING YOUR VEHICLE Important safety precautions A computer system controls the engine's idle revolutions per minute (RPM). If the engine idle speed does not slow down automatically, have the vehicle checked. Exhaust fumes can be...
Owner's Manual - Page 109
... steering system checked by your vehicle is running. This action could damage the power steering pump. Driving
Never hold the steering wheel to the extreme right or the extreme left for more than a few seconds when the engine is speed sensitive. Speed sensitive steering
The steering in your dealer or a qualified service...
Owner's Manual - Page 126
... to tow in the "Service Guide". • Do not tow a trailer until your vehicle's engine, transmission, axle, brakes, tires, and suspension. Refer to Preparing to ensure safe towing procedure: ...least 800 km (500 miles). • Refer to the instructions included with your vehicle for the proper installation and adjustment specifications.
127 Refer to the severe duty schedule ...
Owner's Manual - Page 129
Install and adjust brakes according to your vehicle's brake system.
Trailer weight range The trailer ...range by weight that meet Federal and local regulations. Do not connect a trailer's hydraulic brake system directly to the manufacturer's instructions. Using safety chains Always connect the trailer's safety chains to the 130 Driving
• Weigh your vehicle as you customarily ...
Owner's Manual - Page 130
... Trailer Towing Guide" available from your local trailer retailer or rental agency for proper instructions and equipment for the installation and specific use hitches that: • clamp onto the vehicle bumper • attach... that it does not shift and change the weight on the tongue. Follow the towing instructions of the trailer is enough slack to allow the vehicle to the axle. Using a ...
Owner's Manual - Page 133
... of vehicle breakdown, approaching danger, etc.
Roadside emergencies
HAZARD LIGHTS CONTROL Use only in a substantial jolt.
134 FUEL PUMP SHUT-OFF SWITCH If the engine cranks but does not start after a collision, the fuel pump shut-off . The shut-off switch is off. The warning lights can be operated when the ignition is...
Owner's Manual - Page 137
...system (4WABS) Air suspension compressor Trailer tow battery charge, engine minifuse box fuse #2, engine minifuse box fuse #4 Four-wheel drive (4WD) transfer case motor and clutch Driver power seat Fuel pump Junction box ignition switched feed Junction box ignition switched feed...PCM diode Description Windshield wipers high/low speed Windshield wipers run/park Front washer pump relay Fuel pump relay
Owner's Manual - Page 143
...gradually decrease your vehicle are stowed in the following locations:
Tool Spare tire Jack, wheel nut wrench, instructions, work gloves Jack handle Location Under the vehicle, just in front of the road: • Park... on the right rear quarter panel interior trim. Location of the engine compartment.
144 On the top of the raditator support at the front of the spare tire...
Owner's Manual - Page 145
... out from under the vehicle. Place the gearshift in P(Park). 5. On vehicles equipped with Air Suspension, turn OFF the Air Suspension switch prior to the instruction sheet for detailed tire change instructions. 1. To re-install the spare tire or tools, reverse the removal procedure. Park on a level surface. 2.
Set the parking brake. 4.
Owner's Manual - Page 159
... drain into the oil pan. 2. If the engine is not covered by your Ford warranty. The engine oil and oil filter must still be used in P. 3. Synthetic engine oils which are never needed and could, under certain conditions, lead to engine damage which is running, turn the engine off and wait a few minutes for the oil...
Owner's Manual - Page 160
.... Insert the dipstick fully, then remove it is fully seated. Check the engine oil. For instructions, refer to pour oil in this chapter. 2. Add engine oil through the oil filler cap. Make sure the oil level is beyond the maximum line, engine damage or high oil consumption may occur and some oil must be...
Owner's Manual - Page 172
... an extended period at high speeds, in P(Park), set the parking brake and leave the engine running. 4. Install the dipstick. 6. Remove the dipstick and inspect the fluid level.
173 Maintenance and care
approximately...1. Remove the dipstick, wiping it clean with a clean, dry rag. 5. Start the engine and move the gearshift lever through all of driving. If your vehicle has been operated for...
Owner's Manual - Page 177
... is installed, the computer must be reset once the battery is electronically controlled by a computer, some control conditions are maintained by power from the battery. Follow your vehicle's engine is ...is eventually relearned. • If the battery has been disconnected or a new battery has been installed, the clock and preset radio stations must "relearn" its idle, the idle quality of used...
Owner's Manual - Page 221
...Capacities for refilling fluids ...213, 215 Changing a tire ...147 Cleaning your vehicle ...206 engine compartment ...208 fabric ...211 instrument panel ...211 plastic parts ...209 tail lamps ...210 ...driving instructions ...120, 121 Fuel calculating fuel economy ...193 improving fuel economy ...133 octane rating ...191 quality ...191 safety information relating to automotive fuels ...189 Fuel pump ...
Customer Assistance Guide 1st Printing - Page 12
...affected by a qualified service technician. • Mobile communications systems may cause the engine to your vehicle's operation.) • Ford cannot assume responsibility for specific weight information...of your dealer for any adverse effects or damage that are not properly installed. Any such equipment installed in mind when adding accessories or equipment to your vehicle: • ...
Warranty Guide 1st Printing - Page 7
... affect these components: cylinder block, heads and all internal parts, intake and exhaust manifolds, flywheel, timing gear, harmonic balancer, valve covers, oil pan and pump, water pump, fuel pump and fuel system (excluding fuel lines and fuel tank), high pressure lines, gaskets and seals, glow plugs, turbocharger, powertrain control module, electronic driver unit, injectors...
Warranty Guide 1st Printing - Page 9
• engine tune-up Other Items and Conditions Not Covered Your New Vehicle Limited Warranty also does not cover: • non-Ford parts of your vehicle that are installed by body builders or manufacturers other than Ford • vehicle's built with titles that specify "dismantled", "fire", "flood", "junk", "rebuilt", "reconstructed", or "salvaged" •...
Similar Questions
Passenger Side Water Leakage On Engine.
My daughter in law has 2001 ford expidition XLT 4.6L V8. It is leaking antifreeze on the passengers ...
My daughter in law has 2001 ford expidition XLT 4.6L V8. It is leaking antifreeze on the passengers ...
(Posted by Jewels65 9 years ago)
The Engine On My Expedition Does Not Fire Up. Fuel Pump Is Good. No Fire To Plug
is there a relay or fuse to replace for this problem and where is located. just another thing to che...
is there a relay or fuse to replace for this problem and where is located. just another thing to che...
(Posted by johnmaxeyy 9 years ago)
Where Is The Engine Block Number Stamped On 1997 Ford Expedition
(Posted by prttim 10 years ago)
