Get support for 1996 Ford Aerostar

1996 Ford Aerostar Support Question

1996 Ford Aerostar Support Question

Find answers below for this question about 1996 Ford Aerostar.
Need a 1996 Ford Aerostar manual? We have 2 online manuals for this item!
Question posted by sunnjuana on January 8th, 2014

How To Remove 1996 Ford Aerostar Van 2nd Row Seat

The person who posted this question about this Ford automobile did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.

Current Answers

There are currently no answers that have been posted for this question.
Be the first to post an answer!

Remember that you can earn up to 1,100 points for every answer you submit. The better the quality of your answer, the better chance it has to be accepted.

Related Manual Pages

Owner's Manual - Page 11

... water u Wash your vehicle while it clean. Paint damage resulting from fallout is not related to chemical industrial fallout. Ford, however, believes that continual improvement in hot weather. Customers may be required to remove harmful deposits and protect the finish. 8 Take similar precautions if your vehicle with a mild detergent. DO NOT: u Wash...
Owner's Manual - Page 15

Combination Lap and Shoulder Belts While your vehicle is , remove the twist. After you brake hard, turn hard, or if your forward movement. ...or more, thelap/shoulder belt locks and helps reduce your vehicle receives an impact of this chapter. 13 Fastening the front seat combination lap and shoulder belt NOTE: Be sure to your movement. However, if you get into the proper buckle until ...
Owner's Manual - Page 18

..., DO NOT use the hanging belt as an assist when entering the vehicle. 16 The second row passenger side outboard seating position uses a hook above the sliding/cargo door to the outboard side of the rear seats. This should remain attached, except when removing the rear seats. NOTE: When the belt is not being used.
Owner's Manual - Page 19

Then lift upward. 17 To disengage the safety belt from the seat. Proper stowage of shoulder safety belt Disengaging rear seat safety belts for seat removal In order to remove the rear seat, the safety belt must be disengaged from the seat, insert a key or small screwdriver into the slot provided on the detachable anchor.
Owner's Manual - Page 21

Whenever a rear seat has been removed, the tongue end of the detachable anchor must be correctly stowed. See the following illustration. Rear seat shoulder safety belt - stowage (with seat removed) 19
Owner's Manual - Page 25

... free the webbing with this may weaken it will go and untwist the belt or remove the object that is noted. Feed the belt back into the retractor until it is...if equipped), child safety seat tether bracket assemblies (if equipped), and attaching hardware, should be inspected after any mild soap solution that is recommended for cleaning upholstery or carpets. Ford recommends that all safety...
Owner's Manual - Page 26

... figures and this procedure to Correct a Twisted Safety Belt at any outboard seating position that has a "D" ring. 24 For Twisted Rear Outboard Combination Lap and Shoulder Safety Belts - Detachable Anchor Disengage the detachable anchor tongue from the detachable anchor, remove the twist and re-install the detachable anchor tongue end into the...
Owner's Manual - Page 30

.... at 1-800-782-4356. For additional important safety information on the steering wheel or in front seat areas that may increase the risk of personal injury in contact with a deploying air bag. Failure to Ford's brochure entitled Some Important Information About Air Bag Supplemental Restraint System which connects the components. 28 RWARNING...
Owner's Manual - Page 34

...do not provide maximum protection for children. Safety Restraints for specific requirements. Check your local Ford or Lincoln-Mercury dealer. RWARNING To prevent the risk of injury, make sure children sit ...vehicle is moving. The passenger cannot protect the child from injury in safety seats that are required by qualified personnel. and Canada, you must put them in a collision. Air...
Owner's Manual - Page 36

... shoulder belt around a shield above and ahead of the three-passenger second row bench seat only if a top tether strap is recommended for the size and weight of the child. Ford recommends placing forward-facing safety seats in this vehicle. Safety Seats for added protection. RWARNING The following instructions MUST BE FOLLOWED to reduce risk...
Owner's Manual - Page 43

See Figures 5 and 6. 41 Allow the belt to remove any slack in the automatic locking mode. Pull up on the shoulder webbing. This indicates the retractor is in the belt. Push down on the child seat while you pull up on the belt to retract. A clicking sound will be heard as the belt retracts. 5.
Owner's Manual - Page 46

... RWARNING Carefully follow all of the manufacturer's instructions included with the safety seat you do not install and use . Check to the vehicle sensitive locking mode for normal adult usage. NOTE: To remove the retractor from automatic lock mode, allow seat belt to retract fully to its stowed position and the retractor will...
Owner's Manual - Page 47

... with a lap/shoulder belt, or a lap belt and top tether strap. 1. Place the child safety seat in the third row center seating position. Push down on the child seat while pulling on the loose end of webbing. Lengthen the lap belt. Make sure the tongue is held securely in place. Route the tongue and...
Owner's Manual - Page 48

... tether strap anchor kit. Other manufacturers offer the tether strap as shown in a second row seating position with the tether strap installed to the rear floor by using a tether anchor kit (613D74), available at no charge from any Ford dealership. You can attach a tether strap anchor bracket to the tether anchoring point as...
Owner's Manual - Page 49

... ever removed, the hole(s) in the floor must be anchored to lap/shoulder belts for the third row, following the five steps above, or to automatic locking mode. RWARNING If the anchor bolt(s) is installed, follow these steps to the previous section on Installing Child Safety Seats. Install the child safety seat in the seat...
Owner's Manual - Page 50

...Seat (If equipped) The second row bench seat may include an optional built-in every state and province. Children must be used only by children who are below the shoulder harness slots in the seatbacks with this child seat snugly around your child is the law in child safety seat...20 pounds), always use a rear facing infant or convertible seat because a child of that size is to be properly ...
Owner's Manual - Page 58

...shoulders and remove the child. RWARNING Always fasten the protector flap snaps when stowing your child seats to Figure 8. The seat can now be used by an adult. 2. 3. 56 Refer to prevent the child seat cushion from the built-in child seat: 1. ... the headrest. Refer to Figure 6. 2. 3. To stow the built-in child seat: 1. To remove the child from rotating forward in a collision.
Owner's Manual - Page 59

... be replaced. Built-in child seats not in use during a collision, Ford recommends replacing it should be inspected and replaced if either damage or improper operation is frayed, or if the buckle and tongue are damaged and/or do not need to operate properly, they may be removed, machine-washed, and air-dried...
Owner's Manual - Page 120

...the previous illustration. Remove any twist, then insert the tongue end of the detachable anchor into the detachable anchor until the latch re-engages. (A slight downward pressure on the bench seat seatback will re... the safety belt, be installed in the first row behind the front seats on the latch.) 139 The two passenger bench or bed seat must be sure it is not twisted. The latch...
Owner's Manual - Page 161

... and off. 180 and push the left hand side of headphones in the display when the rear seat controls are available on all Aerostar models. The rear seat radio controls are turned off . NOTE: Rear seat control volume can be set no higher than current radio setting unless speakers are located behind the driver...

Similar Questions

Intermittent Beeping Noise When Starting 1996 Ford Aerostar Van
What causes an intermittent beeping noise when the van is started? It lasts about 1/2 a minute and t...
(Posted by meyerandrewb 2 years ago)
1996 Ford Aerostar Van Transfusion
why does transmision shift into nutral while driving in drive
(Posted by garlicsautee 10 years ago)
Ask a New Question
Use the box below to post a new question about this Ford automobile .
Points & Prizes
  • You can earn points for nearly everything you do on HelpOwl.com
  • You can trade in those points for gift cards at leading retailers such as Amazon.com and Walmart
  • It's that simple!
See How it Works
Create a Free Account

Ford Manuals

Find free 1996 Ford Aerostar manuals and user guides available at ManualOwl.com. Try out our unique manual viewer allowing you to interact with manuals from directly within your browser!

Ford Reviews

View thousands of Ford user reviews and customer ratings available at ReviewOwl.com.

Contact Information

Complete Ford customer service contact information including steps to reach representatives, hours of operation, customer support links and more from ContactHelp.com.

Scoreboard Ratings

See detailed Ford customer service rankings, employee comments and much more from our sister site.

Ford Recalls

Find comprehensive Ford recall information updated hourly on RecallOwl.com.