Question posted by elham3 on August 2nd, 2011
Electrolux Wave- Touch Range's Display Lights Up Automatically With A Beep Sound
I have an electrical Electrolux wave touch range. The control panel automatically lights up with a beep sound and goes on for hour. No matter what I do, it does not stop. It happens mostly at night. Can't get enough sleep.
Current Answers
Answer #1: Posted by OnlineOutreachSpecialist on August 2nd, 2011 11:39 AM
OnlineOutreachSpecialist
Member since:
March 30th, 2011 Points: 2,848,290
Member since:
March 30th, 2011 Points: 2,848,290
Unfortunately from what you have described, sounds like you have a faulty control board. Depending on how old the unit is you may have a limited warranty on this unit or the parts. Contact your manufacturer first before moving forward. Otherwise, if you are not home to watch the appliance, I would turn the circuit breaker off to the unit for safety reasons.
Online Outreach Specialist
Similar Questions
Controls, Display, Lights And Fan Are Not Working.
Unit's lights flickered a bit for a week or so, then unit shut itself off once but the switch for th...
Unit's lights flickered a bit for a week or so, then unit shut itself off once but the switch for th...
(Posted by jtdonnelly 7 years ago)
Frigidaire Ffgf3047ls Gas Range Control Pad
I was adjusting the time on the oven control pad and the right side of the panel pushed in. I assume...
I was adjusting the time on the oven control pad and the right side of the panel pushed in. I assume...
(Posted by todort22 10 years ago)
Control Panel On Electrolux Range Ew30s6cgs Not Working. Power Supply Is Good
After quick power outage electroxlux slide in range has no power. Cooktop only shows blue dashes for...
After quick power outage electroxlux slide in range has no power. Cooktop only shows blue dashes for...
(Posted by marlenedmott 10 years ago)
Display Light To Dim On My Microwave
(Posted by Mariemh 11 years ago)
My Control Panel Stops Responding To Touch While Cooking.
It seems that heat from the vent under the panel is heating the panel to a point it is damaging it. ...
It seems that heat from the vent under the panel is heating the panel to a point it is damaging it. ...
(Posted by csback 12 years ago)