Electrolux EIFLW55HIW Support Question
Electrolux EIFLW55HIW Support Question
Find answers below for this question about Electrolux EIFLW55HIW - 27" Front-Load Washer.Need a Electrolux EIFLW55HIW manual? We have 6 online manuals for this item!
Question posted by micnices on March 4th, 2011
How To Remove Drain Pump?
theres no manual avilable for this model,so if anyone can help do thank you
Current Answers
Related Electrolux EIFLW55HIW Manual Pages
Complete Owner's Guide (English) - Page 5
... period of up to 30 minutes, if the washer has not been manually turned off during operation, the washer must be removed. If the washer is equipped with local codes. Do not use ...
• Do not combine laundry products for use or mix liquid chlorine bleach with 3-prong grounded plug
resulting in 1 load unless specified on carpet.
Before loading, unloading or adding items, ...
Complete Owner's Guide (English) - Page 7
... with these basic steps:
1.
A B
C
D DRAIN PUMP Your washer is common to the dispenser. (See page 10-11.)
2. HIGH SPEED MOTOR A powerful motor is a normal part of the operation of the washer. E. E
D. This is used to drive the drum to high spin speeds to the washer. (See page 9.)
6. Sort laundry into your pump is being locked
or unlocked...
Complete Owner's Guide (English) - Page 8
... tie strings and sashes, and remove non-washable trims and ornaments. ...WASHER 1.
Place delicate and small items such as bras, hosiery and baby socks in other loads and cause skin irritation.
2.
8 Operating Instructions
Operating Your Washer
BEFORE USING YOUR WASHER
Read the important instructions in this Use and Care Guide before operating your washer.
Sort laundry into loads...
Complete Owner's Guide (English) - Page 9
Add laundry load to help balance the load.
Combine large and small items in this guide for safe, successful stain removal instructions.
4. Large items should not be tightly packed. Add 1 or 2 similar items to washer. The washer can be fully loaded, but the items should close easily. The door should not be more than half the total wash load. Operating...
Complete Owner's Guide (English) - Page 10
... too quickly could result in front load washers.
Use the cap or scoop provided by the detergent manufacturer to the "Main Wash powder only" detergent chamber. liquid only" cup. powder only" chamber when not using liquid detergent. Add laundry products to the "Main Wash - liquid only" chamber. Remove liquid cup when using powder detergent...
Complete Owner's Guide (English) - Page 16
...blends with this cycle.
To add a cold water rinse prior to quickly wash small, lightly soiled loads in 18 minutes. To minimize wrinkling, the warm/warm and sanitize/cold temperatures are available with ...no spin selection.
SPIN ONLY Use the spin only cycle anytime you want to drain water from the washer and spin out the load or as a follow-up to the no -iron finish. The eco friendly ...
Complete Owner's Guide (English) - Page 19
The indicator will prewash for the cycle will automatically advance to remove excess dirt and detergent.
NOTE
To change the options once the cycle has begun... is not available with that cycle is selected. The water will drain and the load will be remembered and recalled each time that cycle.
See step 5 in "Operating Your Washer" section in this option is selected in the middle of the...
Complete Owner's Guide (English) - Page 26
... vehicle (RV) antifreeze to prevent pressure build-up in compartments and dry compartments. To remove antifreeze from hoses.
3.
WINTERIZING INSTRUCTIONS
1. Disconnect hoses from water supply and drain water from washer after storage, run empty washer through a complete cycle using detergent. Drain any time. 26 Care & Cleaning
OUTSIDE
• When washing is stored in an area...
Complete Owner's Guide (English) - Page 27
...to wash water to remove detergent residue.
• Add liquid fabric softener to Common Problems 27
Common Washing Problems
Many washing problems involve poor soil and stain removal, residues of lint ... final rinse.
• Dry load in dryer. • Remove lint with lint brush
or roller.
• See Operating Your, steps 1 and 2.
• Do not overload washer. • Use correct temperature
...
Complete Owner's Guide (English) - Page 28
... • Use liquid detergent or
use chlorine bleach to remove rust stains.
Wrinkling
• Overloading the washer. • Incorrect wash cycle for
wash load.
Stiff, harsh fabrics.
• Undissolved detergent. • Some granular detergents
can combine with hard water minerals to clear lines.
• Drain water heater occasionally.
• For an ongoing problem, install...
Complete Owner's Guide (English) - Page 29
... be loose. Stop washer and check drum.
been removed during the spin cycle. Stop washer and rearrange wash load. OPERATING Washer does not start.
...pump. OCCURRENCE NOISE
High pitch "jet engine" noise. This is probably out of up to help balance the load.
Shake or brush excess dirt and sand from items before washing
LCD displays DEMO MODE. If sound continues, washer...
Complete Owner's Guide (English) - Page 30
... clogged.
sealing washers provided. Wrong detergent.
Drain hose standpipe is not hot enough. Increase standpipe height to allow proper spinning. Water collects in the house. Oversudsing. Rearrange load to at least 23.6" (60 cm). open hot and cold faucets.
Use a low-sudsing, high efficiency detergent. Too much detergent.
high to help balance the load. Warm...
Installation Instructions (All Languages) - Page 4
...least resistance for laundry hose connection. DO NOT cut , remove, or bypass the grounding prong. The faucets MUST be located so the power supply cord is accessible when the washer is properly grounded....MUST be plugged into an appropriate, copper wired receptacle that is not recommended. Drain system requirements
Power cord with a properly grounded three prong grounding type receptacle. ...
Installation Instructions (All Languages) - Page 7
... base and shipping plug for play. Temporarily remove door tape. 2. CAUTION
EXCESSIVE WEIGHT HAZARD
To avoid back or other injury, have more than one person move the washer to within 4 feet (1 m) of cardboard to help prevent washer damage during any future moves. Carefully return the washer to children.
1. Open washer door and remove everything from
the drum. 3.
Installation Instructions (All Languages) - Page 10
... drain hose. CABLE TIE
Power cord with the cable tie (provided in your new washer. 8. Carefully slide the washer to ensure the power is off at a circuit breaker/fuse box. 5.
Remove and discard door tape. 6. Continue wrapping it around the hanger and snap it in a location near the washer for stability. It contains valuable and helpful...
Wiring Diagram (All Languages) - Page 2
...loading door can access the Install cycle through this menu until you get to display language selection. The drain pump will show "INSTAL PASS!" This is a free position. FACTORY RESET 1. 1¼"x2" display models...from the start position. Exiting Diagnostic Mode To return the washer to normal operation:
a) Unplug the power cord, wait...remove all articles are now set back to perform.
Wiring Diagram (All Languages) - Page 3
... Refer to test (13). Refer to test (10) Refer to test (12). Refer to test (12). Unclog the drain pump. E21 Water not pumping out fast enough. E52 Bad signal from tacho generator. E5C High Voltage experienced by overloading. E94 Main Board control problem....low EA5 Main Voltage sensing failure EAE Line safe relay sensing failure EF1 Clogged drain pump. Advise customer to test (4).
Wiring Diagram (All Languages) - Page 4
...correct the problem, Go to close? Remove the pump and check for restrictions.
2. Replace the pressure sensor.
Yes. No. Yes. No. Check the drain hose for blockage. Can you hear the...Is the incoming water pressure above 4.5 inches? 2. Does water enter the washer continuously?
3. Is the loading door closed?
2. Yes. Replace the inlet valve assembly.Pressure switch checks good...
Product Specifications Sheet (English) - Page 1
.... Perfect for leading brand front load washers with normal cycle times less than 60 minutes. 3As tested on conventional wood floor construction with vinyl floor covering. 4Energy efficiency based on D.O.E. Island White - PN # ESTACKIT Drain Hose Extension Kit -
Vent Hoods
Dishwashers / Kitchen Cleanup
Refrigerators
Freezers
Washers / Dryers Under Counter
electroluxappliances.com...
Product Specifications Sheet (English) - Page 2
...reserve the right
to change specifications or discontinue models without optional 15" drawer pedestal, or stacked ...Allow 1" clearance between hot and cold.
• Drain required with matching Electrolux Dryer in with standpipe diameter ... be installed in . Electrolux Major Appliances, N.A. Front Load Washer
EIFLW55H IW
Front Load Washer Specifications
• Product Weight - 237 Lbs.
•...
Similar Questions
Activate Clean Tub Cycle On My Electrolux Front Load Washer
how do I manually activate the clean tub cycle on my Electrolux front load washer
how do I manually activate the clean tub cycle on my Electrolux front load washer
(Posted by suesmet20 2 years ago)
How To Remove Water Drain Pump From Electrolux Frontload Washer
(Posted by walBillk 9 years ago)
How To Clean Cold Water Filter Electrolux Front Load Washer
(Posted by franksteve3 10 years ago)
How To Change The Drain Pump On Eifls55iiw?
how ot remove fron panel and access the pump?
how ot remove fron panel and access the pump?
(Posted by ppruszynski 10 years ago)
Where Is The Drain Pump For The Electrolux Eiflw44hmb Located
(Posted by Carman55 11 years ago)