Dyson DC07 Support Question
Dyson DC07 Support Question
Find answers below for this question about Dyson DC07.Need a Dyson DC07 manual? We have 2 online manuals for this item!
Question posted by kjkost on November 13th, 2011
No Suction When Using Attachments.
My vacuume is working on the floor settings but when I try to use the attachments there is NO suction. There is almost a reverse suction, and I can hear air rushing out from somewhere on the vacuum.
Current Answers
Related Dyson DC07 Manual Pages
User Guide - Page 1
Owner's Manual
Please read this guide carefully before use.
User Guide - Page 2
Important safety instructions Assembling your DCO7 Using your DCO7 Using the tools Emptying the clear binTM Cleaning the lifetime filter Where to look for blockages Warranty and customer care
Page 2 4 6 8
10 12 14 16
Dyson Helpline contact us on 1-866-693-9766
3 Contents
Owner's Manual
Please read this guide carefully before use.
User Guide - Page 3
Floor tool Supplied with certain models only, or available as an accessory. If you need assistance during assembly or operation, please call the Dyson Helpline on 1-...
User Guide - Page 4
... the cord safely by winding counter-clockwise around the cord winders and securing with the cord clip.
5 You may need to press firmly and should hear a 'click' sound.
4 Push the brush and stair tools securely into the storage holes on the back of machine. Fit the crevice tool into place...
User Guide - Page 5
...is intended for the floor surface before using the tools. 2 ...set to install the proper outlet. Fine dust such as plaster dust or flour should be vacuumed in small amounts.
2
Switching on/off switch.
3
3 To start vacuuming...reverse the
plug. The wand cap should only be closed when not using...This plug will hear a loud 'ratchet' warning noise.
Using your DCO7
Using your foot and...
User Guide - Page 6
... cord winders and the wand securely in an upright position before adjusting the setting.
1 Bare floors Brushbar does not turn until you begin to room, ensure it is in...
Your DCO7 should be lifted by using the carry handle. Please note: The brushbar will not turn for delicate rugs and hard/bare floors.
2 Carpets Brushbar turns for normal carpet cleaning. Using your DCO7
1
2
Transporting your...
User Guide - Page 7
...are attached to the machine.
2
1
Attaching tools 1 Press the quick-draw hose
release to detach the hose/ wand from the machine. 2 Slide the wand to the end of the floor ...air powered brushbar ensures effective removal of the tools directly on to optimize pick-up without sticking. Using the tools
Using the tools
Choosing the right tool
The tools allow you to clean surfaces above the floor...
User Guide - Page 8
Reversed wand mode
Reverse the wand and click into the end of the hose, pressing the wand release button to reach areas. CAUTION • ...handling in hard to ensure a correct fit. The hose will stretch all the way to the end of the stairs.
9
Use tools for stair cleaning. Using the tools
Hose mode
Press the wand release button and remove the wand. Fit one of the tools on to the top...
User Guide - Page 10
.... A Press the bin release catch to click the catches into place. CAUTION • Do not use detergents.
• Do not immerse any build-up the front and rear catches and push down to...remove the clear bin.
Rinse only the clear bin -
To reassemble the clear bin, place on the floor with water.
C Holding the carry handle, put the cyclone assembly inside the clear bin, line up of...
User Guide - Page 11
... electrical outlet before removing filter. Failure to rinse this filter. it does not require rinsing or replacement. B Lifetime post-motor filter This is regularly used for vacuuming very fine dust such as plaster dust or carpet fresheners, you when to rinse your pre-motor filter, circle your two 6-monthly rinses on 1-866...
User Guide - Page 12
...sure the filter is completely dry before replacing in cold water and rinse thoroughly.
CAUTION • Do not use detergent. • Do not put in a washing
machine or dishwasher.
4 Rinse the blue foam pad ... clear.
6 Leave in place.
13
CAUTION • Rinse in cold water only. • Do not use the machine
without the filter in a warm place to secure. CAUTION • Do not dry in an ...
Parts List - Page 2
...;90240506 CLUTCH COVER ASSY
11 DY‐90020006 TORX SCREWS
12 DYR‐2000
BRUSH BAR ASSY (Units with Rug/Floor Selector)
12 DYR‐2005
BRUSH BAR ASSY (Units without Rug/Floor Selector)
13 DY‐90544109 SOLEPLATE AY,SIL/YEL
13A DY‐90544104 SOLEPLATE AY,PUR/RED
13B DY...
Parts List - Page 10
...
79
DYR‐5400
CREVICE TOOL,SILVER
80
DYR‐5200
STAIR TOOL,SILVER
81
DYR‐5300
BRUSH TOOL,SILVER
82
DY‐90413614 FLOOR TOOL,SLVR/LVNDR
86
DY‐90343101 WAND CAP,YELLOW
86A DY‐90343104 WAND CAP,RED
86B DY‐90343105 WAND CAP,LAVENDER
87...
Similar Questions
All Of A Sudden My Dyson Dc07 Is Making A Very Loud Noise When I Use It.
The suction is still great but it much such a loud noise when I use it I scare all the family pets. ...
The suction is still great but it much such a loud noise when I use it I scare all the family pets. ...
(Posted by rae2nd 11 years ago)
I Have A Dc07 And It Doesnt Seem To Be Suctioning.
I have a DC07 and it doesnt seem to be suctioning.
I have a DC07 and it doesnt seem to be suctioning.
(Posted by jenngabel 11 years ago)
Brush Stopped Working On Dc24 Tried The Whole Resetting Thing, What Do I Do Next
Took brush head apart cleaned, returned still not working!
Took brush head apart cleaned, returned still not working!
(Posted by Xjulesxb 11 years ago)