Home » Dodge » Other » 2013 Dodge Durango

2013 Dodge Durango Support Question

Find answers below for this question about 2013 Dodge Durango.
Need a 2013 Dodge Durango manual? We have 3 online manuals for this item!

Dodge Overview Questions Manuals Reviews Videos Research

Question posted by Anonymous-166666 on August 6th, 2020

Damaged Key

What can cause my key 2 go to stop working and when I try to start with push start I get damaged key reading

I Know the Answer!

I have the same question
Request More Information

Current Answers

Answer #1: Posted by INIMITABLE on August 6th, 2020 1:30 PM

This answer was accepted by the poster of the original question.

INIMITABLE

Member since:
April 3rd, 2020

Points: 2,077,740

1,090
points

Here is a video guide to solve that

https://youtu.be/omPsxdMuJNw

I hope this is helpful? PLEASE "ACCEPT" and mark it "HELPFUL" to complement my little effort. Hope to bring you more detailed answers

-INIMITABLE

Related Manual Pages

Owner's Manual - Page 20

... parked vehicles in the OFF or ACC ignition position. Key-In-Ignition Reminder Opening the driver's door when the Key Fob is in the ignition and the ignition switch position is placed in ACC or ON/RUN (engine stopped) will cause the reminder chime to "Starting Procedures" in the ACC or ON/RUN mode. With...

Owner's Manual - Page 48

...Push the window switch down firmly to the second detent to open . Window Lockout Button The Window Lockout button on the rear doors, press the Window Lockout button. WARNING! Resetting The Auto Up Feature Should the Auto Up feature stop working... and continue to close the window. 46 THINGS TO KNOW BEFORE STARTING YOUR VEHICLE NOTE: If the window runs into any obstacle during Auto...

Owner's Manual - Page 82

... deployed. Enhanced Accident Response System If A Deployment Occurs In the event of an impact causing air bag deployment, if The Advanced Front Air Bags are not good indicators of •... 80 THINGS TO KNOW BEFORE STARTING YOUR VEHICLE where the SABIC inflates. vehicle speed and damage are designed to impact functions after deployment. until the ignition key is deploy on the nature...

Owner's Manual - Page 240

... have the system checked by simply reactivating it indicates there is not recomDoing so could cause an ACC system failure or mended. Although the vehicle is still drivable under normal conditions... Radar Sensor In Front Of Vehicle" occurs, try activating ACC again later, following a key message occurs frequently (e.g. Doing so may be temporarily unavailable. more than once on cycle...

Owner's Manual - Page 258

...OFF" message for as problem, causing the "SERVICE PARK ASSIST SYSlong as bicycle carriers, trailer you turn it on again, even if you cycle the ignition key. Furthermore, once you turn ParkSense&#...174; off, it remains off until • Use the ParkSense® switch to scratch or damage them. The sensors must not be displayed in the system not working...

Owner's Manual - Page 317

... automatic transmission control systems. The light will illuminate when the key is required. 4 WARNING! Malfunction Indicator Light (MIL) The Malfunction Indicator Light (MIL) is part of your typical driving cycles. The vehicle should be serviced if the light stays on could cause damage to ON/RUN, have the condition checked promptly. This could...

Owner's Manual - Page 333

...; Damaged Key • Key not programmed • Park Assist Disabled • Automatic high beams on • Automatic high beams off • Service All Wheel Drive System • All Wheel Drive System in Park • Memory system unavailable - Not in neutral • ECO - UNDERSTANDING YOUR INSTRUMENT PANEL 331 • Remote start active - Fuel Saver Indicator...

Owner's Manual - Page 337

... occur until light goes off . Cycle the ignition key when the vehicle has completely stopped and the shift lever is flashing when Do In.... road operation). If a problem is detected, the light will cause the temperature gauge to normal, turn off - the engine is ... reading does not return to pass H, the indicator will sound light comes on while driving, safely pull over and stop the...

Owner's Manual - Page 447

... on the brake pedal. Using Fob With Integrated Key (Tip Start) NOTE: Normal starting of REVERSE only after the vehicle has come to start, the starter will continue to 15 seconds, then repeat the "Normal Starting" procedure. The starter motor will disengage automatically in the passenger compartment. 5 Damage to the transmission may occur if the following...

Owner's Manual - Page 453

...Damage to the transmission may occur if the following precautions are not observed: • Shift into PARK only after the vehicle has come to a complete stop . • Shift into or out of PARK. CAUTION! STARTING...the transmission into PARK, turn the engine OFF, and remove the key fob. WARNING! • Unintended movement of a vehicle could injure those in PARK, securing the vehicle...

Owner's Manual - Page 465

...after WARNING! restarting the engine if the key is move the shift lever out of PARK with the brake motion. The engine can be started in this range. Make sure the transmission... movement and possible injury or damage. PARK before leaving the vehicle. Check by locking the • Your vehicle could move the shift lever out of PARK. STARTING AND OPERATING 463 When parking on...

Owner's Manual - Page 467

... brake pedal or the shift lever. • Do not leave the key fob in or near the vehicle (or in a location accessible to children... lever all the way forward and to the left until it stops and is dangerous for a number of PARK, you have engaged... gear range, as this can damage the drivetrain. Children should be in the ACC or ON/ RUN position. STARTING AND OPERATING 465 WARNING! (Continued...

Owner's Manual - Page 492

...STARTING AND OPERATING WARNING! (Continued) • Do not leave the key fob in or near the vehicle (or in a location accessible to roll and cause damage or injury. Failure to do so may roll and cause damage...Roll Mitigation (ERM), and Electronic Stability Control (ESC). All five of these systems work together to leave the transmission in various driving conditions. Also, your vehicle, or ...

Owner's Manual - Page 655

...the front fog lamp bulb with them together to the front fog lamp connector. Remove the two push-pins from the back of the the slots in contact with any oily surface, clean the ... An incorrect bulb size or type may overheat and cause damage to disengage the lamp from the keyed opening on the back front fog lamp housing. Rear Tail, Stop, Turn Signal, And Backup Lamps 1. Align the index...

Owner Manual - Page 48

.... Push the window switch down for an press the Window Lockout button again. To reset Auto Up: you to be reset. To disable the window controls on the rear doors. 46 THINGS TO KNOW BEFORE STARTING YOUR VEHICLE Resetting The Auto Up Feature Window Lockout Button Should the Auto Up feature stop working, the...

Owner Manual - Page 333

...Key • Damaged Key • Key not programmed • Park Assist Disabled • Automatic high beams on • Automatic high beams off • Service All Wheel Drive System • All Wheel Drive System in N Press 4 Low 4 Fuel Saver Indicator • To Tow Vehicle Safely, Read...in Park • Memory system unavailable - Insert Key and Turn to Run • Memory 1 profile set ...

Owner Manual - Page 492

.... 490 STARTING AND OPERATING WARNING! (Continued) • Do not leave the key fob in or near the vehicle (or in a location accessible to children), and do not leave the ignition of these systems work together to enhance vehicle stability and control in various driving conditions. failure to do so may roll and cause damage or...

User Guide - Page 13

... assistance on how to open the door. NOTE: The ENGINE START/STOP button should only be removed or inserted with Keyless Enter-N-Go™, remove the ENGINE START/STOP button by inserting the Key Fob in this condition, damage could occur to the Start position. CAUTION! • • If your vehicle battery becomes low or dead, your...

User Guide - Page 14

...cause you and others to the ON/RUN position. • With remote start or run for the parking brake. Children should be in a location accessible to unlock the driver's door automatically, then press the Start/Stop... switch. x • To drive the vehicle, with a valid Keyless Enter-N-Go™ Key Fob within five seconds. WARNING! • Do not start , the ...

User Guide - Page 94

... Key Fob to complete this procedure. • Turn the ignition switch to the ON/RUN position, but do not start the engine. • Press and hold the transfer case N (Neutral) button for four seconds, until the light next to the N symbol starts to blink, indicating shift in PARK. Damage from the powertrain and will stop...