2004 Dodge Durango Support Question
2004 Dodge Durango Support Question
Find answers below for this question about 2004 Dodge Durango.Need a 2004 Dodge Durango manual? We have 1 online manual for this item!
Question posted by niemibrian on May 16th, 2013
I Have 2 Questions About Engine Trouble I Have Two Codes P0404 C1604 Help??
The person who posted this question about this Dodge automobile did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.
Current Answers
Related Manual Pages
Owner's Manual - Page 4
...THIS MANUAL Consult the table of contents to service, remember that the new owner will help assure safe and enjoyable operation of your new vehicle. The detailed index, at the ...vehicle. 4 INTRODUCTION
INTRODUCTION This manual has been prepared with the assistance of service and engineering specialists to cause cancer and birth defects or other reproductive harm. It is interested in this ...
Owner's Manual - Page 8
... And Pregnant Women ...37 ▫ Seat Belt Extender ...37 ▫ Driver And Right Front Passenger Supplemental Restraint System (SRS)-Airbags ...38 ▫ Child Restraint ...50 Engine Break-In Recommendations ...62 Safety Tips ...62 ▫ Exhaust System ...62 ▫ Safety Checks You Should Make Inside The Vehicle ...63 ▫ Safety Checks You...
Owner's Manual - Page 9
...bag with either side up. CAUTION!
SENTRY KEY - IF EQUIPPED With this system, an electronically coded ignition key sends a signal to thieves. The dealer must be cut by the dealer. If ...A WORD ABOUT YOUR KEYS The double sided keys may be inserted into the locks with a bar code label affixed to run for integrated keys. NOTE: Integrated keys (key and key fob combined) must ...
Owner's Manual - Page 10
..., all the transmitter buttons are disabled for all of the keys provided with remote starting systems. Use of these systems may cause vehicle starting the engine may result in the system electronics. NOTE: The Sentry Key Immobilizer System is required for about 3 seconds when the ignition switch is first turned to...
Owner's Manual - Page 16
... from the OFF position to disable or enable: 1. Within 30 seconds, press the driver's door lock switch in the ON position ( Do not start the engine ). 5. If necessary, repeat the above steps. 8. This feature will be locked automatically by the Automatic Door Lock feature. • The vehicle is in the Off...
Owner's Manual - Page 17
Within 30 seconds, press the driver's door lock switch in the ON position (do not start the engine). 5. Child Protection Door Lock To provide a safer environment for children riding in the rear seat, the rear doors of your seat belt (fastening the seat ...
Owner's Manual - Page 23
... you have a programmed transmitter, contact your seat belt (Fastening the seatbelt will remain in program mode up to the ON position ( Do not start the engine ). 5. Turn the ignition to six additional fobs. 13. The chime is heard release both the LOCK and UNLOCK buttons, simultaneously.
9. A single chime will be programmed...
Owner's Manual - Page 24
... run until snug. Make sure not to pry the two halves of the transmitter apart. If you touch a battery, clean it with your fingers. The engine will flash for unauthorized operation. Remove and replace the batteries. 24 THINGS TO KNOW BEFORE STARTING YOUR VEHICLE
Battery Replacement The recommended replacement battery is...
Owner's Manual - Page 25
... alarm will set . After the alarm is set, the security light will flash at starting the engine, the system will sound when you unlock the doors. however, you can be disarmed with the...you use the power door locks or use the Keyless Entry transmitter to start a vehicle, the engine will flash rapidly to exit. NOTE: If the security light stays on continuously during vehicle operation, ...
Owner's Manual - Page 34
... engaged with the seatback latch by pushing rearward on the anchorage release button to release the anchorage, and then move it up or down to help position the belt away from the normal emergency locking mode to make sure that serves you best. When sitting in the second row has a seat...
Owner's Manual - Page 36
... least three times within the first 60 seconds of the ignition switch being turned to turn off the engine. A single chime will sound to the OFF position and buckle the driver's seat belt.
2. 36...The following steps must occur within 10 seconds, ending with the seat belt buckled. 4. Start the engine and wait for more than 10 seconds and the vehicle speed is unbuckled for the Seat Belt ...
Owner's Manual - Page 46
... the vehicle. When the ORC detects a collision requiring the airbags, it takes to restrain the driver and front passenger. The bags then quickly deflate while helping to blink your control of the airbag. The driver's front airbag gas is removed, the fault will occur which turns on collision severity and occupant...
Owner's Manual - Page 63
...question regarding belt or retractor condition, replace the belt. Have a competent mechanic inspect the complete exhaust system and adjacent body areas for cuts, frays and loose parts. If there is a properly maintained engine...63
• It may be necessary to sit in a parked vehicle with the engine running for lubrication or oil change. Open seams or loose connections could permit exhaust ...
Owner's Manual - Page 130
...programmed HomeLink button. Similar to this sequence a third time to complete the programming. For questions or comments, please contact HomeLink at www.homelink.com or 1-800-355-3515. NOTE... Programming steps 6-8 to complete the programming of the garage door opener (or other rolling code equipped device), repeat this Canadian law, some U.S. gate operators are 30 seconds in which...
Owner's Manual - Page 192
... winter months, make sure the air intake, located directly in hot weather especially when towing a trailer, additional engine cooling may be protected with a non-filming cleaning solution (vinegar and water works very well) will help prevent contaminates (cigarette smoke, perfumes, etc.) from sticking to raise the boiling point of window fogging. 192...
Owner's Manual - Page 218
... damage or injury. Don't leave the key in a vehicle unattended is dangerous for example, repeated brake applications with the engine off), the brakes will still function with some loss of reasons. Children should be certain to aid the driver in Park... brake or the gear selector lever. Also be warned not to prevent wheel lockup and help avoid skidding on slippery surfaces.
Owner's Manual - Page 248
...) in an open area with proper maintenance. If spark knock persists, lighten the load, or engine piston damage may not be covered under the New Vehicle Warranty. They contain carbon monoxide, a ...fuels or additives is deadly. Follow the precautions below to help prevent spark knock. Have the exhaust system inspected every time Never run the engine in a closed area, such as a garage, and ...
Owner's Manual - Page 279
... times to be raised. • Apply the parking brake firmly before jacking. • Never start the engine with the vehicle on a jack. • Do not let anyone sit in the vehicle when it is...it is down. WHAT TO DO IN EMERGENCIES 279
WARNING! Carefully follow these tire changing warnings to help prevent personal injury or damage to your vehicle: • Always park on or near a roadway...
Owner's Manual - Page 289
...will usually be performed. • If the "Malfunction Indicator Light" is flashing while the engine is required.
7 MAINTAINING YOUR VEHICLE 289
ONBOARD DIAGNOSTIC SYSTEM - OBD II Your vehicle is...Malfunction Indicator Light" on the "Malfunction Indicator Light." It will also store diagnostic codes and other information to the emission control system.
This system monitors the performance of...
Owner's Manual - Page 362
...729-1240 Customer Assistance For The Hearing Or Speech Impaired (TDD/TTY) To assist customers who has access to help protect you have purchased a service contract for the Deaf) equipment at 1-800-521-9922. Service Contract You may... stands behind any service contract that is not responsible for any questions about your vehicle delivery date. It is not a manufacturer's Service
Similar Questions
What Does The Light On The Dashboard Thatlookslike An Engine Mean On An 07 Dodg
durango mean
durango mean
(Posted by joannalaret 9 years ago)
Engine Removal
should I raise the body from frame to remove and install engine
should I raise the body from frame to remove and install engine
(Posted by nikkitabor 10 years ago)
How To Fix Problem Indicated By P0068 Obd2 Code On 2005 Dodge Durango
2005 Dodge Durango SLT, 4.7L with 208,000 miles. Displaying P0068 code which appears to be the prima...
2005 Dodge Durango SLT, 4.7L with 208,000 miles. Displaying P0068 code which appears to be the prima...
(Posted by pf6476 10 years ago)
Considering Engine Swap.. But Have Questions
I currently have a 04 dodge Durango with the 5.7 hemi motor and I have found a 07 dodge Durango that...
I currently have a 04 dodge Durango with the 5.7 hemi motor and I have found a 07 dodge Durango that...
(Posted by Anonymous-109138 11 years ago)
Throttle Body Butterfly Valve And Fuel Pump Relay Clicking After Engine Shut Dow
after engine shut down, the fuel pump relay circuit stays active. I pulled the fuel pump fuse... not...
after engine shut down, the fuel pump relay circuit stays active. I pulled the fuel pump fuse... not...
(Posted by jpkassebaum5 12 years ago)