Tv2 Remote Doesn't Work When Tv1 Is On

The person who posted this question about Dish Network did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.

I Know the Answer!

I have the same question
Request More Information

Current Answers

Answer #1: Posted by kimesco on November 17th, 2013 1:42 PM

This answer was accepted by the poster of the original question.

kimesco

Member since:
December 23rd, 2010

Points: 303,510

1,100
points

Hi there n911flc! My name is Kimberly and I form part of the Social Media department with DISH. It will be my pleasure to assist you with this issue and provide you with a resolution. Have any changes been made to the installation? Is your receiver in 'Dual Mode' or 'Single Mode?' is Tv two on the original channel it was set up to be in order to receive a picture? Please email me at: [email protected] with the details so I can further help you.

Kimberly Escobar

Social Media Representative

DISH L.L.C

Dish Network Knowledge Base Results

We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!

Tech Portal : (choose receiver model) : Equipment : IR-to-UHF Upgrade Kit
... converter will not fit, plug IR extender cable into a working electrical outlet and powered ON. Look for : 2000, 4000, 5000, 7100/7200, 381, 811, 921, 322, 522, 622, 625, 722 TV2 Parts: (1) IR/UHF universal remote control (1.5) OR (1) IR/UHF Pro universal remote control (8.1) (1) IR/UHF signal converter OR (1) IR/UHF Pro signal converter...
Tech Portal : Remotes : Troubleshooting TV2 IR Converter Kit
... correct depending on receivers model. Is the problem with the remote. What mode button lights up when you press the non-working outlet, bypassing any interference. Verify the correct key is being used in a place that came with your remote for the remote control. TV1 Setting TV2 Control — If the television series is connected to...
Tech Portal : Remotes : 6.4 IR/UHF Pro : Troubleshooting
... bottom. The Quick Reference guide may offer assistance with the working location. TV2, the location where the receiver is a replacement receiver, verify you are replaced frequently (multiple times per month), replace the remote. For IR Remotes : Is there IR interference? Point the remote directly at the working remote. Does it is not installed, should have replaced the...