Tv1 Is Now Tv2 But Remote Won't Work. Neither Remote

today i changed my tv's around so the tv that used to be tv1 is now tv2 just on the other side of the wall. now remote won't work, i have put 2nd tv on chanel 77 and i'm still not getting a picture, where as before i moved it it all worked.

I Know the Answer!

I have the same question
Request More Information

Current Answers

Answer #1: Posted by BeckiBwithDISH on October 18th, 2011 4:01 PM

This answer was accepted by the poster of the original question.

BeckiBwithDISH

Member since:
December 23rd, 2010

Points: 144,270

1,110
points

There are a few things that you can try.

1. Reset the receiver

2. Go to the TV1, pres menu 6-1-5. For TV, change that to 60 or 73. Then try to put your TV2 on 60 or 73. If this does not work, please send me an email at [email protected].

to program your remote, go to TV1, press the system info button on the right hand side of the receiver. With the TV2 remote, hold down the SAT button until all lights light up on the top of the remote. Press a number 1-9 then press the # pound button, then record.

If any of this does not work, please email me!!

Becki Barned

DISH Network Customer Service

[email protected]

Becki Barned
DISH Internet Response Team
[email protected]

Dish Network Knowledge Base Results

We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!

Tech Portal : Features : Connectivity Overview
...you have a router with your remote and even pay your receiver connected? You do not need any additional equipment to use features on screen Caller ID, ...getting your bill through the Customer Support Application (CSA). You can get all features on your receiver. Is the receiver close to update Pay-Per-View records, and avoid the monthly TV2 Receiver Access fee, using...
722 : Error 002
... been moved if...the System Info screen. Use the wiring diagrams located ...” to the wall hand tight? ...TV1 location. Connector Color Code Chart Reconnect the correct cable coming from the satellite dish connected hand tight? Was there a significant change...remote and select System Setup, Installation, and System Info. is the icon in the room or to the TV1 location leaving the TV2 remote...
Tech Portal : 3750 : Errors & Troubleshooting
... wall is connected to the TV. TV2 OUT. If using RCA cables. The TV input source must download PPV and/or DOD events. If video shows from a working ...works in TV mode on the DISH remote. (TV, ANT A, PIP1, S-Video, AUX, VIDEO 2, CHAN99, AUX, VIDEO 2, etc.) Change channels on the receiver. Unable to order PPV and/or DOD events because the events may not be switched using the TV...