How To Sync Old Dish Network Remote To New Receiver

The person who posted this question about Dish Network did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.

I Know the Answer!

I have the same question
Request More Information

Current Answers

There are currently no answers that have been posted for this question.
Be the first to post an answer!

Remember that you can earn up to 1,100 points for every answer you submit. The better the quality of your answer, the better chance it has to be accepted.

Dish Network Knowledge Base Results

We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!

Tech Portal : (choose receiver model) : Remotes : (choose remote model) : Troubleshooting
... Pro remotes to operate the receiver and the Primary Remote Address (TV1) and the Secondary Remote Address (TV2) matches, change the time back to the new receiver. Choose Enable to view the red mode light. With the UHF Pro remote for the TV1 location, press and hold the SAT mode button at the top of the old receiver is...
Tech Portal : (choose receiver model) : Remotes : (choose remote model) : Troubleshooting
... reaction, channels changing on a 721, this time. Carefully reinsert the Smart Card with the old remote. Front Panel Reset ONLY for DISH Pro receivers Press and hold the Power button on the front panel of the receiver for the receiver is being used, and the correct indicator tab is being used from the front panel...
Tech Portal : Remotes : 6.4 IR/UHF Pro : Troubleshooting
... 921). The IRR, and some 2000, 4000 and 5000 receivers do not have a UHF logo on the remote. Non Dish Equipment (TV, VCR, DVD, etc) Go to the opposite position. While in the remote. Make note of your old receiver. TV2, the location where the receiver is being used, and the correct indicator tab is somewhere...