How To Set A Dish Network Signal On New Tv

The person who posted this question about Dish Network did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.

I Know the Answer!

I have the same question
Request More Information

Current Answers

Answer #1: Posted by BeckiBwithDISH on May 16th, 2014 5:59 PM

This answer was accepted by the poster of the original question.

BeckiBwithDISH

Member since:
December 23rd, 2010

Points: 144,270

1,100
points

I hope that you have gotten this resolved but if not, I am happy to help you! Are you getting an error message on your TV? Is your receiver connected the same way it was on the last TV? Please email me at [email protected] for further assistance!

Becki Barned
DISH Internet Response Team
[email protected]

Dish Network Knowledge Base Results

We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!

Tech Portal : (choose receiver model) : Remotes : Other Remotes : EZ Remote
...your off -air antenna, follow these instructions you set up a new TV code in satellite mode by pressing TV again and try the other than the receiver, TV or VCR. You cannot clear the programmed codes ... Not available for the next time you wanted. The TV light flashes. TV light stays on . See the User's Guide that receive an IR signal. Before you can do this repeatedly to scan through ...
Tech Portal : 722 : Event Timers
...had a lower priority than other events being recorded over by signal loss or power failure. The highest priority is already another timer set a new timer. * When creating a DVR Timer, select Protect and... for Deleted, Done, Stopped, Skipped next to Preferences, then Record Plus. for "New Episode" Priority - Select the Protect Event option. Done: The timer has completed. ...
Tech Portal : 811 : Video Black, Blue, None, Snow
...; © Do not confuse the “No Signal” or “Unusable Signal” message with distorted video? Properly installed quality cables will display a black screen if the receiver settings were changed to the correct video source. Continue Tune the TV to the receiver menu settings. If no video, continue cycling through remaining TV video input sources. (Customer may not...