How To Set Up 2nd Remote Dish Network

The person who posted this question about Dish Network did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.

I Know the Answer!

I have the same question
Request More Information

Current Answers

There are currently no answers that have been posted for this question.
Be the first to post an answer!

Remember that you can earn up to 1,100 points for every answer you submit. The better the quality of your answer, the better chance it has to be accepted.

Dish Network Knowledge Base Results

We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!

Tech Portal : Remotes : Buttons & Images
... connected properly. Record Button - Note: RECOVER only works if the remote control has been set the remote to change the remote control address. The following setup is not applicable on using the PIP...you 've set up the remote to skip ahead again. Note: Press any remote control button other mode buttons light Press desired prefix key to limit search ( 0 for a 2nd TV, 1 for a 2nd VCR, ...
Tech Portal : 622 : Errors & Troubleshooting : Error 008
... Phone System. Continue Is the phone line connected directly to the receiver. Press Menu on the remote Select System Setup, Installation, Broadband Setup, then Network Setup. Go to Off-line troubleshooting. Try...the adapter. Go to another receiver's modem . If Remote is selected, the receiver is not listed on -line? If the device was set for 30 seconds and plug back in . Select Reset...
Tech Portal : 612 : Errors & Troubleshooting : Error 018
...the receiver to the receiver. Go to Off-line troubleshooting. If the device was set for Remote and is connected to another receiver's modem? After that time, check the purchase info...If using a router, gateway or switch. Please contact your Internet connection. Press Menu on the remote Select System Setup, Installation, Broadband Setup, then Network Setup. Go to the network. Unplug ...