My Dish Tv Remote Set Up Tv But Won't Let Me Use The Receiver

The person who posted this question about Dish Network did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.

I Know the Answer!

I have the same question
Request More Information

Current Answers

Answer #1: Posted by BusterDoogen on July 20th, 2014 5:31 PM

This answer was accepted by the poster of the original question.

BusterDoogen

Member since:
October 30th, 2011

Points: 28,565,407

1,100
points

Make sure you have the source set to satellite or cable according to your carrier.

I hope this is helpful to you!

Please respond to my effort to provide you with the best possible solution by using the "Acceptable Solution" and/or the "Helpful" buttons when the answer has proven to be helpful. Please feel free to submit further info for your question, if a solution was not provided. I appreciate the opportunity to serve you!

Dish Network Knowledge Base Results

We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!

Tech Portal : 942 : Install : 942 Initial Install
...find digital off -air channels can be on the HDTV and 942 using the TV1 audio/video outputs, and attach the UHF remote antenna and an active phone line to connect the off -air ...the receiver will address itself to Remote Control 2’s random address and the pop-up message asking you cannot see a picture, make sure that you want to program the TV in the 73-125 range if set the remote TV(s), ...
PocketDISH Troubleshooting, How To, and FAQ.
...DISH Network satellite receiver (with RCA outputs) to the PocketDISH using RCA cables. Connect an RCA output of a DISH Network receiver to the AV in : record from the bottom of the satellite receiver. * The AV402E cannot record analog video through the analog RCA connections. Power on the remote Settings...you have a unit with Archos on a TV or audio device AV500E Connect the docking station...
Tech Portal : (choose receiver model) : Remotes : 6.4 : Features
... programming the TV or VCR codes. Use a small screw driver or a paper clip to operate a second DISH Network satellite receiver (via UHF and IR, in AUX mode allows customers to program the AUX mode button to carefully change the setting. Use the SYS INFO button on the receiver. IR/UHF Pro Band B Supported on the remote control. Note...