Dish Remote Won't Program For Sat

The person who posted this question about Dish Network did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.

I Know the Answer!

I have the same question
Request More Information

Current Answers

Answer #1: Posted by kimesco on April 23rd, 2014 11:57 AM

This answer was accepted by the poster of the original question.

kimesco

Member since:
December 23rd, 2010

Points: 303,510

1,100
points

My name is Kimberly and I form part of the Social Media Department with DISH. It is a pleasure to help you. If your remote is currently not allowing you to access your guide and change channels please make sure that your remote is on the correct mode which is, Satellite Mode. How do you know if the remote is on SAT mode? You can find out by pressing any button on the remote and pay attention to the four mode buttons located at the top pf the remote and check to see if the SAT clear button is the one that lights up. If your remote is on SAT mode but is still not changing channels it will most likely need to be readdressed to the receiver. Follow this link for detailed information on how to address your remote to the receiver http://www.mydish.com/support/remote-control?WT.svl=contentarea If you have additional questions please feel free to reach me at: [email protected]

Kimberly Escobar

Social Media Representative

DISH L.L.C

Dish Network Knowledge Base Results

We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!

Tech Portal : (choose receiver model) : Remotes : (choose remote)
... remote because of flashes. Aim both remotes at the desired equipment. Note: Any button on the DISH remote that equipment. To verify that the code works try several different functions for that is programmed ...will blink off after each digit is not applicable for the 7100/7200 or the 721) SAT button (about six seconds) until all mode button backlights come on , then release. This ...
Tech Portal : HD Monitors : HD34-300, Features
... same time because the two signals interfere with a DISH DVI cable, pressing the SAT button on the 8.0 UHF Pro Remote Control will return to tone down blaring commercials. POP also lets you unfreeze the picture it on , pressing the SAT button will begin displaying satellite programming. Sleep and Wake Timers Sound Logic™ Audio Leveling...
Tech Portal : 222k : Errors & Troubleshooting : Video Distorted (Poor Quality)
...or ANT B. In order to view your DISH remote control to cycle through remaining TV video input sources. (You may be addressed to watch satellite programming. If this is connected from the receiver ...Home Distribution coax output to the TV Video input. How is placed back into satellite mode by pressing the SAT button ...