Dish Network Moving Tv To A Different Cable Connection Remote Wont Work

The person who posted this question about Dish Network did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.

I Know the Answer!

I have the same question
Request More Information

Current Answers

There are currently no answers that have been posted for this question.
Be the first to post an answer!

Remember that you can earn up to 1,100 points for every answer you submit. The better the quality of your answer, the better chance it has to be accepted.

Dish Network Knowledge Base Results

We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!

Tech Portal : 222 : Errors & Troubleshooting : Audio, Same on Both TVs
.... Tuesday May 27 2008 © Is the video the same on both TV audio cables connected to Video, Same on the receiver. If this takes approximately 5 minutes Place the receiver in standby... the Hard Drive on a 721, this step was previously performed move to reset and power on the receiver is incorrect and has both TVs? Verify fixed, if not, continue. Audio, Same on . ...
Tech Portal : Remotes : Address to Receiver
... other codes listed for that device until you find a code to work the TV for that equipment. We do have limited functionality with our remotes. You may provide partial function, or respond differently than the button's titled function. Please contact the manufacturer of TV, VCR, DVD or stereo equipment. Some codes may refer to this...
Tech Portal : (choose receiver model) : Remotes : (choose remote) : Address to other equipment
... and release the Mode button until you find a code to work the TV for that the mode light is not lit when the channel up under the correct mode. Try several different functions for basic functions but will power off. If using a gray button remote, program it does not operate a device. Power then press...