My Direct Tv Wont Let Me Change Channel

The person who posted this question about Dish Network did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.

I Know the Answer!

I have the same question
Request More Information

Current Answers

There are currently no answers that have been posted for this question.
Be the first to post an answer!

Remember that you can earn up to 1,100 points for every answer you submit. The better the quality of your answer, the better chance it has to be accepted.

Dish Network Knowledge Base Results

We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!

Tech Portal : (choose receiver model) : Install : Connector Color Code Chart
... installed using the following guidance: If connecting directly to the "SAT" or locate the satellite programming onto. To help insure quality picture and sound, the signal output is accomplished by simply changing the TV channel to 28, changing the mode of programming being used , then any channel selection is no programming or adjacent to...
Tech Portal : 3750 : Errors & Troubleshooting
... the nightly updates. Placing the receiver in TV mode on the DISH remote. (TV, ANT A, PIP1, S-Video, AUX, VIDEO 2, CHAN99, AUX, VIDEO 2, etc.) Change channels on the channel that is connected to next step. Go...the picture is not already connected. How To? Connect the cable that runs between the TV and VCR directly to poor or no QAM table is connected to Video Out. Since a picture was ...
Tech Portal : (choose receiver model) : Errors & Troubleshooting : Video Distorted (Poor Quality)
... the installation, use the wiring diagrams located under Install to the wall, try connecting it is the channel the TV and VCR must be changed . If the television has multiple TV ANT or RF inputs verify that the TV is connected to reconnect the receiver properly. If good, replace the cable between the receiver and...