How To Reprogram 6.4 Remote To Receiver

The person who posted this question about Dish Network did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.

I Know the Answer!

I have the same question
Request More Information

Current Answers

Answer #1: Posted by CheriTDISH on May 1st, 2012 2:25 PM

This answer was accepted by the poster of the original question.

CheriTDISH

Member since:
December 23rd, 2010

Points: 149,620

1,110
points

Hi, Cheri Torres with DISH's Social Media Team here. I would be happy to help you get your remote reprogrammed to your receiver. Please follow the instructions I list here in order to get the remote readdressed. I hope this helps and if you have further questions or concerns feel free to email me at [email protected]. Thanks!

Instructions for addressing the remote to the receiver

1. Enter the system info screen. You can do this by pressing the system info button on the front right side of your receiver.

2. Press and hold down the SAT button on the remote until all the lights on the remote are lit.

3. Press any number 1-15 on your remote keypad.

3. Press the pound(#) button once.

4. Press the record button 3 times on the remote.(The number you select should show up on the system info screen next to primary remote address.)

5. Select done on your remote and test the functionality of the remote.

Cheri Torres
Social Media Team
DISH L.L.C.

Dish Network Knowledge Base Results

We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!

Tech Portal : Connectivity : Phonex Easy Jack 2
... the link up is no dial tone, there may need to reprogram the link code on the extension unit. If two lines are Data... of same phone cord into an A/C electrical outlet near the satellite receiver. Do I use at an extension unit, try other A/C power ...will blink red. They reduce signal strength. They do not use remote to see if they are caller ID compatible. You must be ...
Tech Portal : (choose receiver model) : Remotes : (choose remote)
... pick up. Reprogram the mode to its' instructions. The light will ensure you are doing the Power Scan correctly. If still no operation, it may use 0 as a "learning" remote because of the... that the code works try several different functions for the piece of the remote and Mode buttons or lights at the receiver . mode button for the device, for about six seconds) until you ...
Tech Portal : Remotes : How To
... Verify you have an unobstructed LOS and is displayed beside the correct selection. Backup / Restoring Data Backing Up Remote/Receiver Data Verify you have an unobstructed LOS and is configured correctly. Backup My Settings Now . Maintain unobstructed LOS while the green progress bar fills. to ...