Question posted by jankuder0505 on June 28th, 2012
Dish Network Remote For Tv2 Not Working
Current Answers
Answer #1: Posted by MarkHDISH on June 28th, 2012 7:11 PM
To reprogram the remote to the receiver:
Take TV2 remote to TV1 location
Press menu twice on TV1 remote
On TV2 remote, press the "SAT" button one time
On TV2 remote, press record 3 times
This readdresses the remote to the receiver.
http://www.mydish.com/support/remote-buttons
Please contact me if you need additional assistance.
Thank You
Mark Haakenson
Social Media Representative
DISH LLC
3 pm – 11 pm Sunday though Thursday
Mark Haakenson DISH Social Media
Dish Network Knowledge Base Results
We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!-
Tech Portal : (choose receiver model) : How To : Interactive Features
..., 811: Go to System Setup, then TV Enhancements. 211, 211k, 322, 411, 512, 522, 622, 625, 722, 722k: Go to System Setup, Installation, then TV Enhancements. Select Done or Save. To get back to Dish , press the DISH button on the remote or tune to that channel. Press the Select button to change to channel 100 or access Dish through the... -
Tech Portal : (choose receiver model) : How To : Setting Timers
...current season) on this channel New Episodes: timer fires for new episodes of event (current season) on this box. The message may be canceled. With the new event highlighted in the buffer. Press Select on the remote to and select Timers. Change...getting a search result of all of their recording if the programmer extends the end time due to overtime or other tuner will interrupt the TV... -
Tech Portal : 3750 : Errors & Troubleshooting
..., Themes, Search, and Channel Locks. Enhanced Locals channels are not blocked. Knowledge of 30 minutes. If not, you have been cleared. message, go to the TV? If there are faulty surge protectors, local power outages or an off the receiver for assistance. There should be billed once. Press Menu on the remote. Select Locks. Go to next...