Dell PowerVault TL2000 Support Question
Dell PowerVault TL2000 Support Question
Find answers below for this question about Dell PowerVault TL2000.Need a Dell PowerVault TL2000 manual? We have 15 online manuals for this item!
Question posted by scato on August 29th, 2011
Unlock
how do you unlock the magazine when it says HOST LOCKED? I need to load tapes
Current Answers
Answer #1: Posted by DellProSupport on August 29th, 2011 12:36 PM
DellProSupport
Member since:
June 13th, 2011 Points: 19,090
Member since:
June 13th, 2011 Points: 19,090
The HOST LOCKED error is due to the software reserving the HOST. If you are using say BACKUP EXEC you would go to DEVICES-then right click on the Library and then click on UNLOCK
Related Dell PowerVault TL2000 Manual Pages
Dell PowerVault ML6000 Encryption Key Manager
User's Guide - Page 9
... must use a power screwdriver to :
|
v Encryption-capable LTO 4 and LTO 5 Tape Drives
v Cryptographic keys
v Digital certificates
Who Should Read this Book
Convention bold
constant width
...an attention notice, but is intended for storage and security administrators responsible for the installation and operation of storage devices and networks.
Italicized words or characters represent...
Dell Model TL2000/TL4000 Tape Library- User's
Guide - Page 27
...lock and
label storage location
USB port Library Control Board (LCC) LED
Serial port
Ethernet port Tape drive LED
Service Tag/Serial Number Fan vents
Description
The shipping lock...tag and serial number on a USB device. Data encryption is green, it ...host application or host server.
When the LED is supported with library code 4.50 or greater.
Encryption
The LTO Ultrium 5 Tape...
Dell Model TL2000/TL4000 Tape Library- User's
Guide - Page 30
..., or one LC Fibre Channel connector. Each tape drive in the library is not recommended as follows:
Table 1-3. Maximum Library Storage Capacity and Data Transfer Rate
Maximum library storage capacity and maximum data transfer rates are compatible with SAS-1 or SAS-2 cables.
1-8 Dell PowerVault TL2000 Tape Library and TL4000 Tape Library User's Guide The SFF-8088 SAS...
Dell Model TL2000/TL4000 Tape Library- User's
Guide - Page 192
... slot status
90
Accessor load not reached Cartridge Present sensor
91
No activity after Load command
92
Timeout while loading tape
93
No activity after load command
94
Timeout drive Unload
95
Drive terminated unsuccessfully
96
Tape not ejected at robot... Operator Control Panel and the Web User Interface.
8-10 Dell PowerVault TL2000 Tape Library and TL4000 Tape Library User's Guide
Dell Model TL2000/TL4000 Tape Library- User's
Guide - Page 270
... buffer is independent of the location of the subsystem remains available for transferring data between several devices located between a channel path and a drive caused when a unit check occurs during an I -2 Dell PowerVault TL2000 Tape Library and TL4000 Tape Library User's Guide Direct current.
concurrent.
contingent connection.
A part being able to perform an operation...
Dell Model TL2000/TL4000 Tape Library- User's
Guide - Page 272
...tape storage technology developed by ensuring that identifies a program, device, or system to reduce the effects of LTO technology enables compatibility between a supported host and the library.
Incompatible Magazine: This message appears on the SCSI bus.
interface. An interface might be the host system or the tape control unit. I -4 Dell PowerVault TL2000 Tape...needed...program load. ...
Dell Model TL2000/TL4000 Tape Library- User's
Guide - Page 273
...applicable. A storage device whose contents are not lost when power is under ...loaded. microdiagnostic utility. In a network, a point at which changes the meaning.
offline.
OPER. Glossary I /O device with a linear current density in a part of an elongated, uniformly wound solenoid that can store and retrieve a cartridge's historical usage and other I/O devices. A tape...
Dell Model TL2000/TL4000 Tape Library- User's
Guide - Page 274
...PowerVault TL2000 Tape Library and TL4000 Tape Library User's Guide A variable that is a performance improvement over traditional SCSI because SAS enables multiple devices...cartridges between the drive/library and the host processor.
Reliability, availability, and serviceability.
... for communication between the cartridge storage slots and the drive. In addition, SAS drives ...
Dell Model TL24iSCSIxSAS 1Gb iSCSI to SAS -
User's Guide - Page 10
...
Preface
Thank you read the following as tape drives understand on to ensure connectivity between a network, which utilizes the Ethernet protocol, and peripherals that storage devices such as it will guide you through ... an interface between LTO SAS drives installed in a Dell PowerVault TL24iSCSIxSAS and the network. Figure 1 iSCSI Topology
Page 8
Dell Model TL24iSCSIxSAS 1Gb iSCSI to SAS...
Dell Model TL24iSCSIxSAS 1Gb iSCSI to SAS -
User's Guide - Page 64
...Small Computer Systems Interface A protocol to 255 characters long. This allows data storage devices to SAS User's Guide Rev.C Local area network. Page 62
Dell Model TL24iSCSIxSAS 1Gb... data at speeds up to change than software loaded from a central point. IP-protocol classes or devices which uniquely identifies a connection between two iSCSI devices. A computer network within a limited area.
...
SCSI Reference Guide - Page 14
...2-3. TL4000 Tape Library SCSI element addresses for I/O Station, storage slots, and drive slot
Upper Left Magazine ⇐ Front of TL4000 Tape Library &#...Magazine
Slot 30 4125
(0x101D)
Slot 29 4124
(0x101C
Slot 27 4122
(0x101A)
Slot 26 4121
(0x1019)
Slot 25 4120
(0x1018)
Slot 23 4118
(0x1016)
Slot 22 4117
(0x1015)
Slot 21 4116
(0x1014)
2-6 TL2000 and TL4000 SCSI Reference TL4000 Tape...
SCSI Reference Guide - Page 76
... Address
Reserved
SValid
Invert
Reserved
ED
Medium Type
Source Storage Element Address
Primary Volume Tag Information
(MSB)
Reserved... Type
Identifier (Omitted if DVCID = 0 in the library (aka Tape Drive). When set this element up to now. This flag will be...Transfer Element contains a cartridge when the Full bit is the device that stores user data on the cartridges in CDB)
(LSB...
SCSI Reference Guide - Page 108
...a move from one storage element to the tape drive. The Write... unloaded by a host command to the tape drive, prior to... receiving the Move Medium command, the media changer will issue an Unload command to the data transfer element or vice versa. Adjust the time-out value if larger data chunks are sent.
6-2 TL2000 and TL4000 SCSI Reference Therefore, the time-out value needs...
Dell PowerVault TL4000 Failover Configuration
Guide - Page 9
...hosts. Failover Reference Configuration 6:
One host with dual port SAS HBA and one Dell PowerVault™ with a single SAS drive
In this configuration is a means to maintain the data storage...performance issues due to the sharing of the HBAs fails. Dell PowerVault™ TL4000/TL2000 Failover Guide
Multiple Host Failover configuration
(two hosts, two FC switches, and 2 FC drives)
Main Path
...
Dell Model TL24iSCSIxSAS 1GB iSCSI to SAS
bridge iSCSI initiators - Page 2
Connect to the TL2000/TL4000 from the Host Server 9 If you are using Windows Server 2008 Core Version 9 If you are using a Linux Server 10
Guidelines for Configuring Your Network for iSCSI 11 Linux Host Setup ...12 Avoiding duplicate iSCSI devices discovered by RH5 12 Avoiding duplicate iSCSI devices discovered by RH4 13 Viewing the status...
Dell Model TL24iSCSIxSAS 1GB iSCSI to SAS
bridge iSCSI initiators - Page 9
... username and password. 11) Repeat step 7 for each controller. 12) Go to the TL2000/TL4000 from . 2) Click Service Start; then select When Booting. 3) Select Discovered Targets...Data Digest and Header Digest: Optionally, you are connected and show a status of multipathing I/O, the host server must connect to both iSCSI ports
on to the target:
iscsicli PersistentLoginTarget * * * * ...
Dell Model TL24iSCSIxSAS 1GB iSCSI to SAS
bridge iSCSI initiators - Page 10
...-3(02-May-2006 TARGET NAME : iqn.1984-05.com.dell:powervault.6001372000f5f0e600000000463b9292 TARGET ALIAS : HOST ID : 2 BUS ID : 0 TARGET ID : 0 ... for PersistentLoginTarget. Sample output from the Linux command line as a storage device. If you are using a Linux Server
If you configured CHAP ... did not configure CHAP authentication, you do not need to the operating system as shown below. is ...
Setting Up Your iSCSI Bridge - Page 2
Connect to the TL2000/TL4000 from the Host Server 9 If you are using Windows Server 2008 Core Version 9 If you are using a Linux Server 10
Guidelines for Configuring Your Network for iSCSI 10 Linux Host Setup ...12 Avoiding duplicate iSCSI devices discovered by RH5 12 Avoiding duplicate iSCSI devices discovered by RH4 13 Viewing the status...
Setting Up Your iSCSI Bridge - Page 9
... on to connect from the Host Server
If you are using CHAP authentication, enter the CHAP username and password. is the target name as a storage device. 9) If you are using...Optionally, you want to the target:
iscsicli PersistentLoginTarget * * * * where is 0x2 to the TL2000/TL4000 from .
To enable 10) Mutual CHAP, select and enter the Mutual CHAP username and password...
Manual - Page 11
... "Add", and then "Next". After the iSCSI initiator on a Microsoft cluster, click "Finish". After selecting whether the host is displayed, highlight it can be used to perform discovery of the I/O controllers, tape hardware devices, and other storage devices to the system where Backup Exec will allow for
SEPTEMBER 2008
11 Jumbo frame sizes will be...
Similar Questions
How To Physically Remove Tape From Device Dell Tl2000
(Posted by amaea10 9 years ago)
Powervault Tl4000 Tape Magazine Will Not Lock
(Posted by Omarachar 9 years ago)
Power Fault Tl2000 Can Not Load Tape To Drive
(Posted by Cernopie 10 years ago)
Dell Powervault 124t Remove Magazine When Not Powered On
(Posted by KEVINQw 10 years ago)