Dell PowerEdge 2500 Support Question
Dell PowerEdge 2500 Support Question
Find answers below for this question about Dell PowerEdge 2500.Need a Dell PowerEdge 2500 manual? We have 4 online manuals for this item!
Question posted by shawnaboref on August 29th, 2014
How To Set Up Raid 5 On Dell Poweredge 2500
The person who posted this question about this Dell product did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.
Current Answers
Related Dell PowerEdge 2500 Manual Pages
Console
Redirection
(.pdf) - Page 10
PXE = System Setup = PXE Boot
© 2001
Dell Computer Corporation
Dell Computer Corporation
Printed in the U.S.A. Dell DELL Dell Computer Corporation
Dell Computer Corporation
Rack-to-Tower
Conversion Guide (.pdf) - Page 2
... proprietary interest in severe injury.
Trademarks used in this document is strictly forbidden. A00 Information in this text: Dell and the DELL logo are trademarks of data and tells you make better use of Dell Computer Corporation is subject to change without the written permission of your computer.
February 2001
P/N 9D082 Rev. NOTICE...
Rack-to-Tower
Conversion Guide (.pdf) - Page 3
... document provides instructions for installing a 1 x 2 backplane kit to add provisions for up to two additional 1-inch small computer system interface (SCSI) hard-disk drives in a Dell™ system's peripheral bay.
1 x 2 Backplane Kit Contents
The 1 x 2 backplane kit includes the following items:
• A 1 x 2 backplane attached to the system board
Before You Begin
WARNING...
Rack-to-Tower
Conversion Guide (.pdf) - Page 4
Removing the Peripheral Bay
removable peripheral bay
thumbscrew
1-2
1 x 2 Backplane Kit Installation Guide
www.dell.com | support.dell.com
Removing the Peripheral Bay 1 Remove the front fan assembly (see "Removing the Front Fan Assembly" in your Installation and Troubleshooting Guide). 2 Disconnect the interface ...
Rack-to-Tower
Conversion Guide (.pdf) - Page 5
... bay. Remove both inserts. 4 While grasping the peripheral bay handle, slide the peripheral bay backward and lift the bay straight up to release the insert. Set the peripheral bay on a tower system. NOTE: The drive cage can be inserted into the peripheral drive bay until two of the holes on the...
Rack-to-Tower
Conversion Guide (.pdf) - Page 6
www.dell.com | support.dell.com
Figure 1-2. Installing the Peripheral Bay 1 Reconnect the interface cable to the peripheral bay with four screws (two on the top and two on the ...
Rack-to-Tower
Conversion Guide (.pdf) - Page 8
...This cable has one connector on one connector to set up your operating system documentation for information on how ...of the cable to a Peripheral Component Interconnect (PCI) SCSI or PCI RAID controller card.
1-6
1 x 2 Backplane Kit Installation Guide To connect the...kit, locate the nonterminated 68-pin SCSI cable.
www.dell.com | support.dell.com
NOTICE: The I2C cable must be routed over...
SCSI
Cable Strain-Relief Bracket Installation (.pdf) - Page 10
Dell DELL
Dell Computer Corporation
Printed in Malaysia. Dell Computer Corporation
www.dell.com | suppor t.dell.com
© 2001
Dell Computer Corporation
Printed on recycled paper.
SCSI
Backplane Daughter Card Installation (.pdf) - Page 1
Dell™ Systems
ACTIVATING THE INTEGRATED RAID CONTROLLER
www.dell.com support.dell.com
SCSI
Backplane Daughter Card Installation (.pdf) - Page 2
... hazardous situation which , if not avoided, may result in this text: Dell, the DELL logo, and PowerEdge are registered trademarks of Dell Computer Corporation; A00 Information in minor or moderate injury. Dell Computer Corporation disclaims any manner whatsoever without notice. © 2001 Dell Computer Corporation. Reproduction in any proprietary interest in this document is...
SCSI
Backplane Daughter Card Installation (.pdf) - Page 3
... Guide
This document explains how to activate your system Installation and Troubleshooting Guide. CAUTION: See "Protecting Against Electrostatic Discharge" in the safety instructions in your Dell™ system's integrated PowerEdge™ Expandable RAID 3/Di controller (PERC 3/Di). Activating the Integrated...
SCSI
Backplane Daughter Card Installation (.pdf) - Page 4
www.dell.com | support.dell.com
Figure 1-1. The socket has two alignment keys that allow the memory module to lock the memory module into the socket.
8 Install the RAID hardware key in its socket on each end of this socket.
The latches on the system board (see Figure 1-1). Installing the RAID Controller Memory Module
memory...
SCSI
Backplane Daughter Card Installation (.pdf) - Page 5
Installing the RAID Battery RAID battery
Activating the Integrated RAID Controller
1-3 Figure 1-2.
Figure 1-3. Installing the RAID Hardware Key
9 Install the RAID battery: a Hook the front edge of the RAID battery assembly into the slot near the system board, then snap the clip on the back edge of the battery assembly into place so the battery lies flat (see Figure 1-3).
SCSI
Backplane Daughter Card Installation (.pdf) - Page 6
c Install the peripheral bay. www.dell.com | support.dell.com
b Connect the battery cable to their power sources and turn them on. 12 Install the RAID software. For more information, see the system information label on the system board (see the RAID controller software documentation provided in the system Installation and Troubleshooting Guide.
10 Replace...
Similar Questions
