Craftsman 28910 Support Question
Craftsman 28910 Support Question
Find answers below for this question about Craftsman 28910 - Lt 2000 20 HP 42" Lawn Tractor.Need a Craftsman 28910 manual? We have 1 online manual for this item!
Question posted by pdworley on July 19th, 2013
Engine Running Problem
When I depress the clutch/brake after starting, the engine dies, why?
Current Answers
Related Craftsman 28910 Manual Pages
Operation Manual - Page 1
..., read and understand this equipment. Operator's Manual
CRRFf$14RH°
LAW TRACTO
20.0 HP,*42" Mower Electric Start Automatic Transmission
Model No. 917.28910
• EspaSol, p. 34
03131
This product has a low emission engine which operates differently from previously built engines.
Sat
SEARS, ROEBUCKAND
CO., HOFFMAN ESTATES,
Visit our Craftsman website:www.sears.com/craftsman
IL...
Operation Manual - Page 4
... extremely flammable and the vapors are often attracted to neutral and coast downhill.
• Avoid starting, stopping, or turning on the slopes slow
and gradual. Operation on all movement on a
slope...tion for weight limits for small children.
• Never carry children, even with
the engine running.
Tall grass can affect the stability of control and tip-over the edge or if ...
Operation Manual - Page 5
... seriously injured or interfere with manufacturer's recommended parts, when necessary.
• Mower blades are sharp. machine
in a closed
• Keep all times until...Check brake operation frequently.
Replace gas cap and tighten securely. Clean oil or fuel
spillage and remove any adjustments or repairs
with the engine running....Avoid starting, stopping, or turning on a slope.
Operation Manual - Page 10
... tractor,
check to see "TO TRANSPORT" in the Service and Adjustments section of this manual). See "TO LEVEL
MOWER" in the
Operation section of this manual).
10
Verify that are shown for replacing motion and mower blade drive belts in the
Service and Adjustments section of this
_fCHECKLIST
Before you start the engine.
,/Be sure brake...
Operation Manual - Page 11
...ENGINE ON ENGINE START
PARKING
_ E21 { j.,
BRAKE
MOWER HEIGHT
MOWER LIFT
LIGHTS ON
FUEL
BATTERY
REVERSE
FORWARD
CRUISE CONTROL
CLUTCH/BRAKE PEDAL
®@®@@
ATTACHMENT CLUTCH DISENGAGED
ATTACHMENT CLUTCH ENGAGED
DANGER, KEEP HANDS AND FEET AWAY
KEEP AREA CLEAR
SLOPE HAZARDS
(SEE SAFETY RULES SECTION)
FREE WHEEL (Automatic Models only)
Failure to the tractor and/or engine...
Operation Manual - Page 12
...- Used to raise and lower the mower or other powered attachment while in reverse.
(H) LIGHT SWITCH - Used
for starting and controlling engine speed.
(E) ATTACH M ENT CLUTCH LEVER =Used to engage the mower blades, or other attachments mounted to your tractor.
(B) CLUTCH/BRAKE
PEDAL -Used for starting the engine.
(C) PARKING BRAKE- KNOW YOUR TRACTOR
READ THIS OWNER'S MANUAL AND SAFETY...
Operation Manual - Page 13
..." position and remove key.
Start tractor with the engine running , any position other than full speed
(fast) reduces engine's operating efficiency. • Full speed (fast) offers the best mower
performance. lever to leave the seat without first setting the parking brake will shut off the engine. 1. The operation of any adjustments or repairs. Depress clutch/brake pedal (B) all the way...
Operation Manual - Page 14
... MOWER
Your tractor is at the back of this section of manual). 2.
Start mower blades by the operator to the blade tip with an operator presence sensing switch. ing brake and clutch/brake pedal. • Slowly move motion control lever to desired height. I --
......
}7
TO OPERATE ON HILLS
,_WARNING"
Do not drive up or down
hills with the engine running...
Operation Manual - Page 15
...Tires can lose traction with the attachment
engaged. USING THE REVERSE SYSTEM - tion.
3.
With engine running, turn the ignition key clockwise to engine
"ON" position. TRANSMiSSiON ENGAGED
TRANSMISSION DISENGAGED
NOTE: To protect hood from damage when transporting your tractor.
15
ment clutch engaged, should only be sure to disengage transmission by placing freewheel control in...
Operation Manual - Page 16
... engine problems, the fuel system should change engine oil, seethe Maintenance section in this manual).
16 Usefresh fuel next season. Placethe motion control leverin
neutral. Allow one minute using ethanol or methanol) can damage the fuel system of filler neck. Place motion control lever in operating position, depress
clutch/brake pedal and set parking brake.
3. Do not run...
Operation Manual - Page 17
... lever in neutral position, slowly disengage clutch/brake pedal.
_/I, CAUTION: At any trapped...running . This will plug mower and leave undesirable clumps.
Move motion control lever to the right ofthe tractor. wheel control in engaged position (See
"TO TRANSPORT"
in the tractor seat, start engine. Sitting in this procedure with engine off and parking brake set parking brake...
Operation Manual - Page 19
... worn, bent or damaged blades. Remove blade bolt by the manufacturer of your tractor does not function as described, repair the problem immediately. • The engine should not start unless the
brake pedal is fully depressed, and the attachment clutch control is in the seat. Install new blade with the ignition switch in the ROS "ON" position...
Operation Manual - Page 21
... from tractor and mower. of
your tractor unless the engine and transmission are covered to keep water out. With engine cool, remove filter and plug fuel line sections.
2. S'teering System, Dash,
! Water in fuel line
with automotive type wax. Clean out chaff and debris
CLEANING
• Clean engine, battery, seat, finish, etc. Debris can restrict clutch/brake pedal...
Operation Manual - Page 22
...remove the front link (E) and rear lift links (C) from under tractor.
03042tex
22
Disconnect spark plug wire from rear mower bracket (D) - Have a tight grip on level surface and engage parking brake. 1.
Place motion control lever in neutral position. 3. Depress clutch/brake pedal fully and set parking brake. 2. remove retainer springs and washers.
IMPORTANT: If an attachment other...
Operation Manual - Page 25
.... Engage parking brake. Install belt through stationary idler (A) and clutching idler (B). 6. Make sure belt is
held in the Assembly section of tractor and roll
belt onto engine pulley (E). 3.
Pull belt away from centerspan idler (C). 6. Install belt on level surface.
Remove mowerfromtractor
(See"TO RE-
Remove belt from mower. Pull freewheel control out...
Operation Manual - Page 27
...starting. • Check wiring. TO REMOVE HOOD & GRILLASSEMBLY 1.
See "PURGE TRANSMISSION" in fuse. ENGINE...seat pan to negative (-) terminal with 20 amp automotive-type plug-in the ...engine and liftoffoftractor. 4. When replacing hood, be sure to run poorly, stop running, or prevent it should not be connected first to compensate for service or replacement, it from tractor...
Operation Manual - Page 28
... up all dirt, grease, leaves, etc. Run engine at the end of this manual). 3.
Rust and/or dirt in your gasoline will cause problems.
• If possible, store your tractor with new spark plug(s). IMPORTANT:
Never cover tractor while
engine and exhaust areas are still warm.
28 TRACTOR
Remove mower from tractor for a period of time, clean it to...
Operation Manual - Page 29
...to Sears service center
PROBLEM Will not start
Hard to start
Engine will not turn over
CAUSE
CORRECTION
1 Out of fuel. 2 Engine not "CHOKED" properly. 3 Engine flooded.
4 Bad ...Engine valves out of adjustment.
8 Contact a Sears or other qualified service center.
1 Clutch/brake pedal not depressed. 1 Depress clutch/brake pedal.
2 Attachment clutch is engaged.
2 Disengage attachment clutch...
Operation Manual - Page 30
... Faulty operator-safety presence
run when operator
control system. leaves seat with atta=
chment clutch engaged
1 Recharge or ...wiring, switches and connections. Engine continues to Sears service center
PROBLEM
CAUSE
CORRECTION
Engine clicks but will not start
Loss of power
1 Weak...out of adjustment.
Excessive vibration
15 Engine valves out of mower
housing.
4 Clean/replace air ...
Operation Manual - Page 32
...) position before stopping engine.
1 Reverse operation system (ROS) 1 Turn ignition key to Sears service center
PROBLEM Battery will not charge
Loss of drive
Engine "backfires" when turning engine "OFF" Engine dies when tractor is shifted into reverse... to ROS "ON"
is not "ON" while mower or other
position. shipment or servicing.
5 Axle key missing.
5 Install axle key at rear wheel. ...
Similar Questions
Question About Oil.
What kind of engine oil should I use in this lawn tractor?
What kind of engine oil should I use in this lawn tractor?
(Posted by kprice3103 8 years ago)
Can I Use A Clear Fuel Filter On My 17.5 Hp. Craftsman Lawn Mower With A Fuel
pump
pump
(Posted by khaywta 9 years ago)
Craftsman 28908 - Lt 2000 19.5 Hp/42' Lawn Tractor
do you have a manual for this mower? Thank you
do you have a manual for this mower? Thank you
(Posted by oneangelsrest 12 years ago)
I Have A Craftsman 25336, Lt 2000 In Germany.
Is there a service to call in Germany ? Motor statrs perfect, driving forward and backward is o.k., ...
Is there a service to call in Germany ? Motor statrs perfect, driving forward and backward is o.k., ...
(Posted by AndreasRuppel 13 years ago)
What Is The Next Step To Engine Start After Replacing Battery And Spark Plug
(Posted by jjbutterfield1 14 years ago)