Cobra CXT425 Support Question
Cobra CXT425 Support Question
Find answers below for this question about Cobra CXT425.Need a Cobra CXT425 manual? We have 1 online manual for this item!
Question posted by erykahrichardson477 on February 16th, 2017
Won't Change Stations
my walkie talkies will no longer change stations
Current Answers
Related Cobra CXT425 Manual Pages
CXT425_MANL - Page 1
... week 773-889-3087 (phone). www.cobra.com (on the go.
to operate your microTALK radio. English and Spanish. Contact Your Local Dealer
© 2009 Cobra Electronics Corporation™ 6500 West ... website:
www.cobra.com
Nothing Comes Close to a Cobra®
English
TWO-WAY RADIO MODEL
CXT425
Nothing Comes Close to your belt, purse or backpack. Customer Assistance
For Assistance in...
CXT425_MANL - Page 2
... Electronics
Corporation, USA. Cobra Electronics Corporation™ is pushed, it sends out radio frequency
(RF) signals. Channel Up Button 6. Channel Numbers
Maximum range may violate...6. Scan Icon 9. Memory Location Number 11. The device is based on General Mobile Radio Service (GMRS) frequencies which require a Federal Communications Commission (FCC) license. Important: FCC...
CXT425_MANL - Page 3
... mail postage prepaid to extreme temperatures. Remove belt clip by releasing belt clip latch and sliding clip up on full charge: 12 hours. Handle the radio gently.
Replace battery compartment cover and belt clip.
They may not be recycled or disposed of trouble-free service
if cared for recycling.
Insert batteries...
CXT425_MANL - Page 4
...radio is always in the charging well longer than that. Plug 120-volt adapter into the microphone.
4. If charging light is low, the Battery Low icon
will flash in Standby mode, ready to receive
incoming transmissions.
Both radios must be used in desktop charger: 1. Your microTALK radio...no transmissions for 10 seconds, the radio will
automatically switch to Battery Save mode...
CXT425_MANL - Page 5
...while the Talk or Call buttons are GMRS only.
Auto Squelch/Maximum Range
•
Your microTALK radio is used only to terrain and conditions. Volume
•
Rotate the On/Off Volume knob.
...charts. When using Channels 1 through 7 and 15 through 14 operate exclusively on low power. Both radios must be visible on high power, the Hi icon will be tuned to the same channel to ...
CXT425_MANL - Page 6
... maximum range extender off:
Press and release the Light/Max Range button or change channels. Speaker/Microphone/ To attach a speaker/microphone:
Charge Jack
1. Insert the ... Standby mode.
6
Introduction
Operation
Customer Assistance Warranty
Speaker/Microphone/Charge Jack
•
Your microTALK radio can reduce the range of the
signal can be displayed.
See page 6 for a wall ...
CXT425_MANL - Page 7
...setting and return to other users
on any point to return the radio to 00 on at the same time. When your microTALK radio. Press the Enter/Hi•Low button to enter the new setting...following order:
Mode/Lock Button
Set CTCSS Privacy Codes Set DCS Privacy Codes Set NOAA All Hazards Radio Channel Set VOX On/Off Set VOX Sensitivity Level Set Memory Locations Set Channel Scan Set CTCSS ...
CXT425_MANL - Page 8
...or off : 1. To set the VOX
sensitivity level to NOAA All Hazards Radio
channels transmitting in your voice and avoid transmissions
triggered by background noise. Press ...when All Hazards Radio is turned on or off .
3. Press the Mode/Lock button to proceed to change All Hazards Radio channels.
10
Introduction
Operation
Customer Assistance Warranty
Hazards Radio Icon Channel Buttons...
CXT425_MANL - Page 9
... channel.
7. Press the Enter/Hi•Low button. Press the Enter/Hi•Low button to change the setting.
3. The DCS icon and privacy code numbers will flash on the display. Choose one...
Memory Icon
(0 through 38) for the channel. Upon release of the Talk button, the radio will be shown on the channel/privacy code displayed before you entered mode functions.
Operation
Mode ...
CXT425_MANL - Page 10
... mode functions.
The channel numbers will be reprogrammed at any buttons for 15 seconds, your radio will automatically return to the beginning of the following :
a. Press the Enter/Hi•... and proceed to select the memory location (0 through 9). Channel Scan
•
Your microTALK radio can be shown on the channel/privacy code displayed before you do not press any time it...
CXT425_MANL - Page 11
... button to proceed to set memory location scan (see below for 10 seconds. Your radio will continue to set privacy code scan on the channel that channel/privacy code and return... you will transmit on the channel/privacy code on which you last received a
transmission. Your radio will automatically return to communicate on the channel/privacy code that was displayed before you entered mode...
CXT425_MANL - Page 12
...Talk button while scanning, but more than 10 seconds after 10 seconds of no activity, radio will continue to
10 programmed Memory Locations. b. c. Mode/Lock Button Scanning Locations Channel Buttons...not receiving a transmission), you may de-program any button within 10 seconds, your radio, the scan memory locations option will automatically return to Standby mode on the channel/privacy...
CXT425_MANL - Page 13
... the
new setting and return to other party that you press a button or
Mode/Lock Button change keystroke tones:
1. A = Channel No.
Press the Mode/Lock button to enter the new ...;
FRS/GMRS Frequency Allocation and Compatibility
Important: Please note that your radio will hear when
you release the Talk button. To change a setting. Press the Channel Up or Channel Down button to the...
CXT425_MANL - Page 14
... information.
23 This will be issued a call sign by way of a traceable carrier such as United Parcel Service (UPS) or Priority Mail to avoid loss in transit. Please contact your radio. For licensing information and application forms, please call 773-889-3087 for station identification when operating this product.
The device is
subject...
CXT425_MANL - Page 15
...™ is repaired or replaced under warranty. Cobra will be at its option, defective microTALK radios, chargers, products or component parts upon delivery to the length of a sales receipt. This ... for any product damaged by the first consumer purchaser, provided that its Cobra microTALK radios and charger, and the component parts thereof, will , without limitation, damages resulting ...
Similar Questions
Limited Range Of Channels
Seems I can only access 09,14, 16, 28, 70, 88 and 1019. The unit did work finebefore but for some re...
Seems I can only access 09,14, 16, 28, 70, 88 and 1019. The unit did work finebefore but for some re...
(Posted by gomilne 2 years ago)
What Is The Best Channel For Cobra Cxt235 And How To Connect It? Thanks
(Posted by brixtonjilldulaygula 2 years ago)
Microtalk Cxt400 Radios Not Transmitting
We cannot hear transmissions, but can see the TX transmission indicators
We cannot hear transmissions, but can see the TX transmission indicators
(Posted by clutter 7 years ago)
Both Radios Work Fine. Then One Of The Radios Turns Off And Did Everything Possi
one of the radios turns off by itself. NOTHING I can do makes it turn on again. After a few days its...
one of the radios turns off by itself. NOTHING I can do makes it turn on again. After a few days its...
(Posted by eagleb926 7 years ago)