Cobra 25 LTD Support Question
Cobra 25 LTD Support Question
Find answers below for this question about Cobra 25 LTD.Need a Cobra 25 LTD manual? We have 1 online manual for this item!
Question posted by esandlin817 on April 27th, 2017
Where Are The Finals In Cobra 25 Ltd St?
Replaced final in my cobra 25 ltd st over 20 year ago but radio finally gotten to old to work very good. but cannot remember where or what the final looked like. Think it had 25 stamped or written on it. Cannot remember what it looked like. any help?????
Current Answers
Answer #1: Posted by Troubleshooter101 on May 3rd, 2017 5:25 AM
Troubleshooter101
Member since:
September 30th, 2015 Points: 2,927,030
Member since:
September 30th, 2015 Points: 2,927,030
http://www.angelfire.com/fl2/cbradiorepair/cobramods.htm
cobra 29 Ltd Super Modulation Modification
http://www.714xpress.net/25ltd_sch.html
cobra Radios Super Swing Mods...
cobra 25 Ltd And Gtl, Uniden Pc66: Remove And Replace Tr1 W/2sc2999 D4 And D6 W/schotty
on The Cobra 25 And Uniden 66, Tr1 Can Be Found Near The Rear Of The Radio In Front Of The Heatsink To The Right Of The Final And Left Of The Antenna Jack.
diodes Can Be Found In The Center Of The Radio 2.5 Inches Back From The Front Panel. You Will See A Trimmer Can And A Small Board Standing On Edge D4 And D6 Are In Front Of These Parts.
thanks
Please respond to my effort to provide you with the best possible solution by using the "Acceptable Solution" and/or the "Helpful" buttons when the answer has proven to be helpful. Please feel free to submit further info for your question, if a solution was not provided. I appreciate the opportunity to serve you!
Troublshooter101
Related Cobra 25 LTD Manual Pages
25LTDST - Page 1
Cortland Street Chicago, IL 60707
PRINTED IN HONG KONG
©COBRA ELECTRONICS CORP. 1997
480-205-P-001 OPERATING INSTRUCTIONS FOR YOUR
40 CHANNEL
CITIZENS BAND 2-WAY MOBILE RADIO
Model
25 LTD ST
Cobra Electronics Corporation 6500 W.
25LTDST - Page 2
... of Part 2 of an FCC-issued general Radio-Telephone OperatorÕs License. It literally ÒpunchesÓ your Cobra radio, even though the FCC no longer requires you to obtain an operators license.
1 How To Use Your
Citizens Band
2-Way Mobile Radio
Model 25 LTD ST
Contents
Page
The CB Story 1
SoundTracker System 1
Specifications 2,3
Installation
Location 4 Mounting...
25LTDST - Page 3
...COBRA 25 LTD ST has a vastly superior receiver which includes noise blanker circuitry and an automatic noise limiter. Channel
1 2 3 4 5
6 7 8 9 10
11 12 13 14 15
16 17 18 19 20...reception. RF type. Specifications
FREQUENCY RANGE
The COBRA 25 LTD ST transceiver represents one of the most advanced AM twoway radios ever designed for your Cobra CB radio. Adjustable for PA (Not Supplied)
40 26...
25LTDST - Page 4
... will interfere with good electrical contact (remove paint) may be mechanically strong and also provide a good electrical connection to the...most convenient location in your vehicle, hold the COBRA
radio with the driver or passengers in the desired position...and star washers. Installation (Cont.)
3. Before installing the CB radio, visually check the vehicle battery connections to mark the ...
25LTDST - Page 5
...radio technician for help in less than normal transmit and receive range when compared to 12-volt DC power converter that has been specially designed for applications where the maximum possible distance is not required.
The electrical noise may be used. Consult your transceiver for CB... COBRA 25 LTD ST has an automatic noise limiter, in a boat, consult your COBRA dealer. Cobra ...
25LTDST - Page 6
...In the PA mode, incoming CB transmissions will be heard through the PA speaker. This allows you to monitor messages when you are not inside your radio is activated. BRT/DIM SWITCH... the transmit and PA
modes. This will be slightly stronger than the average receiver noise. S-METER. CB-ANL/PA SWITCH: Selects the mode of the incoming signal
during receiving. CH.19/CH.9/NORMAL SWITCH....
25LTDST - Page 7
...connector permits connection
of the DC power to prevent acoustic feed-back.
Turn the radio ON by depressing the button labeled ST. Operation (Cont.)
13. Operation (Cont.)
3. Set DELTA-TUNE CONTROL to ...to the PA Speaker Jack when this unit is automatically disconnected.
The PA/CB should be connected properly. Set the RF GAIN CONTROL fully clockwise.
4. Leave ...
25LTDST - Page 8
...for Public Address
1. Depress push-to receive.
HOW SOUNDTRACKER WORKS On Reception-"Cuts Noise Coming In" With a normal CB, distant signals fall below the squelch level and are controlled by the ratio of the CB.
The result is rotated clockwise, activity on the rear ... properly connected to -noise ratio, the better the sound.
The higher the signal-to the radio before transmitting.
25LTDST - Page 9
... 13.8 VDC
required to channel Identify your radio and antenna, contact the installer. Do not...-19
10-20 10-21 10-22 10-23 10-24 10-25 10-26 ... the fuse in noisy areas.
Maintenance and Adjustment
The COBRA CB transceiver is properly plugged in.
4. Refer to do ...Cobra products.
(773) 889-3087
24 hours a day, 7 days a week. The following , then if necessary, replace parts only with replacements...
25LTDST - Page 10
...CB to the Cobra factory. Please allow approximately 3 to 4 weeks before sending your unit to promote illegal activities. 4. You are not allowed to eat and sleep. • Make long trips more
than five minutes at www.cobraelec.com or by reporting drunk and reckless drivers.
16
If You Think...; Suggest good spots to use your CB. 6. You may be returned.
2.
How Your CB Can Serve...
25LTDST - Page 11
...St., Chicago, IL 60707 Call 773-889-3087, or fax 773-622-2269 for credit card orders
Allow 4 to 6 weeks for warranty service. Offer valid in Continental U.S.
This warranty may also have other damages; including, without charge, repair or replace, at your local Cobra CB... these fine accessories at its COBRA citizens band (CB) radio, and the component parts thereof, will , without ...
Similar Questions
Why Is Busy Display On Every Channel? Plus No Comeback Received For Radio Check
(Posted by myaces1 9 months ago)
No Transmit
my cobra 25 ltd quit transmitting,the transmit led even went black on trans,but green still on recie...
my cobra 25 ltd quit transmitting,the transmit led even went black on trans,but green still on recie...
(Posted by kennyhupp 10 years ago)
No Transmit Cobra 25
my cobra 25ltd just went dead on transmit side,what part must likely died?
my cobra 25ltd just went dead on transmit side,what part must likely died?
(Posted by kennyhupp 10 years ago)