Clifford Matrix RS Support Question
Clifford Matrix RS Support Question
Find answers below for this question about Clifford Matrix RS.Need a Clifford Matrix RS manual? We have 1 online manual for this item!
Question posted by Karendiaz679kd on November 12th, 2014
I Have A Clifford Xl 500 And Need A Replacement Remote And Someone To Program
Went to stereo king and they said you are no longer a company. I want to buy a new remote for my 98 Honda accord
Current Answers
Answer #1: Posted by TommyKervz on January 25th, 2015 8:23 PM
TommyKervz
Member since:
January 10th, 2013 Points: 17,776,813
Member since:
January 10th, 2013 Points: 17,776,813
Buy the replacement remote control below
http://www.amazon.com/Clifford-904100-Replacement-Remote-Transmitter/dp/B000WCJLTC
Related Clifford Matrix RS Manual Pages
Owners Guide - Page 2
... any Directed® unit (hereafter the "unit"), excluding without limitation the siren, the remote transmitters and the associated sensors and accessories, carry a one-year warranty from the date ...warranty
Directed Electronics, Inc. ("Directed®") promises to the original purchaser to repair or replace with a comparable reconditioned model any unit with a legible copy of the bill of sale ...
Owners Guide - Page 3
... ➤ Your full name and address ➤ Authorized dealer's company name and address ➤ Type of alarm installed ➤ Year...automobile ➤ Installation receipts
trademarks and copyrights
Bitwriter™, Clifford®, Code Hopping™, DEI®, Directed®,... THE MANUFACTURER DOES OFFER A LIMITED WARRANTY TO REPLACE OR REPAIR THE CONTROL
MODULE AS DESCRIBED ABOVE....
Owners Guide - Page 4
... System 11 Valet Take-Over 12 Timer Mode 13 StarterGuard Anti-Grind Circuitry 14 Disabling the Remote Engine Starting System 14 Smart Power Up II 15 Programming Options 15 Glossary of contents
Limited Lifetime Consumer Warranty i What Is Included 2 Important Information 2
System Maintenance 2 Your Warranty 3 FCC/ID Notice 3 Caution 3 Transmitter Functions 4 Standard...
Owners Guide - Page 5
... system, please review this owner's guide carefully prior to using your remote start keyless entry system. Your remote is included
➤ The control module ➤ Two four-button transmitters... warranty. You can print additional or replacement copies of your system. This system must be installed by accessing the Clifford website at www.clifford.com.
➜ system maintenance
The ...
Owners Guide - Page 6
When the battery begins to weaken, operating range will be reduced and the LED on the remote will not be completely filled out and returned within 10 days of purchase. It is not returned. Make sure you receive the warranty registration from ...
Owners Guide - Page 7
... and panic function are usually controlled by pressing this button. Button
This button usually controls remote control chirp muting and an
optional auxiliary output (such as trunk release, is controlled by...
for less than one second
before arming or disarming. The transmitter initially comes programmed with the Standard Configuration, but may also be customized by pressing
for
1.5 ...
Owners Guide - Page 8
... or partially enclosed area or when having the vehicle serviced, the remote engine starting system must be observed at all remote control transmitters to assure that you have
added to your system
&#...THE VEHICLE. Button
An optional convenience or expansion option that the system does not unintentionally remote start the vehicle via a command signal from children all times:
➤ Due ...
Owners Guide - Page 9
... starting module must be removed or the installer must be performed by an authorized dealer in accordance with the authorized dealer to fix the problem. ➤ After the remote engine starting module has been installed, contact your authorized dealer to its intended mode of the vehicle periodically checked, wherein the vehicle must...
Owners Guide - Page 10
...once to arm the optional starter interrupt automatically (called Passive Mode). The system can also be programmed to confirm arming of the system.
YOU MUST IMMEDIATELY CEASE THE USE OF THE UNIT AND ...SEEK THE ASSISTANCE OF AN AUTHORIZED DEALER TO REPAIR OR DISCONNECT THE INSTALLED REMOTE ENGINE STARTING MODULE. While the
system is armed, the LED status indicator will also prevent the
...
Owners Guide - Page 11
... doors lock automatically at the same time that the system will
flash twice to indicate that the system is programmed on .
➜ disabling the starter interrupt without a transmitter
If your remote transmitter is programmed for Passive Locking. The
horn will honk twice (if connected) and the parking lights will re-engage the starter...
Owners Guide - Page 12
... switch. Valet Mode is located. Be sure to work normally. In Valet Mode, the starter interrupt cannot be activated, even with the remote, but all convenience functions (door locks, remote engine starting, etc.) will turn the ignition off . Turn the ignition off and repeat the process. To override the starter interrupt:
Turn...
Owners Guide - Page 13
... warm up the engine, as well as the vehicle's parking lights must be connected.
➜ remote engine starting
This feature allows you to remote starting the vehicle.
To stop Panic Mode at any time, press
. note: In order for...the fan blower must be set to the desired level prior to remotely start the vehicle:
1.
➜ panic mode
If you are threatened in the ignition.
Owners Guide - Page 14
... engine if the system receives any of the following shut-down the remote start system
While the vehicle is running during remote engine starting operation, the system will monitor the vehicle and will start 3 seconds after
the parking lights flash. see
Programming Options section of time (either 12, 24, or 60 minutes - When...
Owners Guide - Page 15
... operation.
This feature is pressed during remote start and turn off the engine, press and release
on the
transmitter (or press and...shutdown toggle switch is put into the OFF position.
➤ The pre-programmed run until the pre-programmed time elapses
or a shut-down input is received. (See the previous Remote
Engine Starting section for a complete list of time, but would like to ...
Owners Guide - Page 16
... directed electronics, inc.
13 The engine may be allowed to ensure that
Timer Mode has been entered. This feature helps to run for its pre-programmed time
period, or it can be used in open areas, never in an enclosed area such as a garage. important!
Start the vehicle by pressing
again...
Owners Guide - Page 17
...start position. note: Anti-grind circuitry only works when the remote engine starting system is operating the motor and the starter interrupt relay is turned to the start... position during remote engine starting unit to be exited by turning the ignition on with the remote transmitter by pressing
.
2. To exit Timer Mode:
Timer ...
Owners Guide - Page 18
... will still be installed in a location of your choice. The switch can be programmed to allow the vehicle to the OFF position.
Check with the factory default settings ...disarm, and Valet Mode. programming options
Programming options control your installer for 12, 24, or 60 minutes when remote started or in Valet Mode. This system's programming options are listed below, ...
Owners Guide - Page 19
...and controls all system functions. Passive Locking can only be selected when the system has been programmed for Passive Mode.
➤ The horn honk confirmations for this feature on, the doors... or constant. Your system can be programmed on , the horn must be programmed to either flash or to turn on the parking lights constantly during the entire remote start operation.
➤ Passive Mode ...
Owners Guide - Page 21
..." tracking and geo-fencing capabilities. Power Trunk Release: The system's auxiliary output can be programmed to lock the doors automatically 30 seconds after the ignition has been turned off . This...using the remote. Domelight Supervision: The domelight will roll
18
© 2001 directed electronics, inc. If the factory release is turned off .
The system can also be programmed to ...
Owners Guide - Page 24
... for one second.
The LED will turn on the ignition.
To unlock/disarm using your remote
➤ To disarm the system press
for the location of the system. The starter interrupt...Valet switch within 10 seconds. To activate Panic Mode
➤ Press and hold
for the programmed amount of Shutdown Switch
© 2001 directed electronics, inc.
21 Turn the ignition back...
Similar Questions
Replace Remote Concept 200 For 1999 Rav4
I have a Clifford Concept 200 on my 1999 Rav4. I need to replace the remote control. Which is the be...
I have a Clifford Concept 200 on my 1999 Rav4. I need to replace the remote control. Which is the be...
(Posted by azchad108 2 years ago)
Remote
my remote has a new battery, it lights up but isn't working with the lock system and alarm for the c...
my remote has a new battery, it lights up but isn't working with the lock system and alarm for the c...
(Posted by oscargeerkenjr 2 years ago)
Clifford Xl 500 Not Chirping.
H, I have a clifford xl 500 car alarm and it arms, disarms and the alarm will sound. However there i...
H, I have a clifford xl 500 car alarm and it arms, disarms and the alarm will sound. However there i...
(Posted by keven3707 9 years ago)
Where To Buy A Replace Remote For Clifford Intelliguard 700-iq. Please Send Info
(Posted by Anonymous-147541 9 years ago)
How Can I Get A Replacement Remote For Clifford Ace 300
(Posted by woodsgirlmarilyn 10 years ago)