2004 Chrysler PT Cruiser Support Question
2004 Chrysler PT Cruiser Support Question
Find answers below for this question about 2004 Chrysler PT Cruiser.Need a 2004 Chrysler PT Cruiser manual? We have 1 online manual for this item!
Question posted by letunajotto on September 17th, 2013
Engine Stopped On 2004 Pt Cruiser And Starter Will Not Turn Over
The person who posted this question about this Chrysler automobile did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.
Current Answers
Related Manual Pages
Owner's Manual - Page 13
The engine can be started and stopped but the key cannot be removed until you that this occurs, rotate the key to the right slightly,... panel. If this safety feature is inoperable. If a malfunction occurs, the system will trap the key in the ignition cylinder. Turn the ignition switch to the LOCK position and remove the key.
2 THINGS TO KNOW BEFORE STARTING YOUR VEHICLE 13
NOTE: If ...
Owner's Manual - Page 14
... have an electronic See Section 7 of this manual for a number of the vehicle by disabling the engine.
Always remove key from the ignition and lock all doors when leaving the vehicle unattended. Locking Doors With...Key You can insert the key with either side up.
To lock the door, turn the key rearward, to remove the key.
Leaving children in the ignition, sounds a signal to remind...
Owner's Manual - Page 15
... to be serviced as soon as possible. NOTE: • The Sentry Key Immobilizer System is turned on , this indicates a problem with this indicates that vehicle. During normal operation, the Theft Alarm...If the Theft Alarm/Immobilizer Light comes on the same keychain will result in the engine being used to flash after the ignition switch is not compatible with remote starting systems....
Owner's Manual - Page 17
...stop flashing, turn in either direction until the lock engages. General Information The Sentry Key system complies with FCC rules part 15 and with a passive steering wheel lock. Operation is moved no more than 1/2 turn...Wish To Manually Lock The Steering Wheel: With the engine running, turn the steering wheel upside down, turn off the engine and remove the key. If the steering wheel is ...
Owner's Manual - Page 54
...return into the retractor, pulling on the restraint loosens the belt, disconnect the latch plate from the buckle, turn the buckle around, and insert the latch plate into the retractor. Then pull on the belt until all of... by pulling and pushing on the excess webbing to shorten it. In a sudden stop or collision, it could strike the occupants or seat backs and cause serious personal injury.
Owner's Manual - Page 60
... as a bulb check when the ignition switch is necessary to sit in a parked vehicle with the engine running, adjust your heating or cooling controls to drive with the deck lid/liftgate open, make sure ...condition, replace the belt. If the LED is not lit during starting, have it is first turned ON. DO NOT use the recirculation mode. Rear seat belt assemblies must be replaced after a ...
Owner's Manual - Page 61
... proper pressure. Fluid Leaks Check area under vehicle after overnight parking for fuel, engine coolant, oil or other objects lodged in the tread. Lights Have someone observe the operation of exterior lights while you work the controls. Check turn signal and high beam indicator lights on the instrument panel. Also, if gasoline...
Owner's Manual - Page 80
...you will be given the choice to (English, Español, or
Français as equipped). Turning Confirmation Prompts On/Off Turning confirmation prompts off will play the current confirmation prompt status and you wish to switch to change it ...to skip part of the voice prompt. The UConnect™ system will stop the system from confirming your voice recognition command immediately.
Owner's Manual - Page 99
... for Low speed wiper operation, or to the park position before turning off the engine. Move the lever to the DEL position, then select the delay interval by turning the end of approximately 18 seconds between cycles, desirable. In cold weather, always turn off the wiper switch and allow the wipers to return to...
Owner's Manual - Page 100
... VEHICLE
TILT STEERING COLUMN To tilt the column, push down , as desired. WARNING! TRACTION CONTROL SWITCH - IF EQUIPPED The TRAC indicator, located in use. To turn the system OFF, press the TRAC OFF switch until the TRAC OFF indicator in place. Adjust the column only while the vehicle is...
Owner's Manual - Page 107
... vehicle is already illuminated. Drive slowly (about 10 to place the compass into CAL mode. The CAL indicator will turn off and the compass will illuminate the CAL indicator. Outside Temperature Because engine temperature can increase the displayed temperature, temperature readings are not updated when the vehicle is selected. Prior to "Magnetic...
Owner's Manual - Page 129
... that there is a problem with the charging system. Liftgate Ajar This light comes on if the liftgate is first turned ON and remain on while driving, stop the vehicle and shut off after the engine is armed.
4 If the light comes on and remains on briefly as a bulb check. UNDERSTANDING YOUR INSTRUMENT PANEL...
Owner's Manual - Page 130
... pointer drops back into the normal range. Speedometer Indicates vehicle speed. Pull over and stop and go traffic, or when towing a trailer. You can take to the engine cooling system and turning off . If the pointer rises to High. Turn Signal Indicators The arrows will sound a chime. Any reading below the red area of...
Owner's Manual - Page 132
...take you longer to control. The light should illuminate for three seconds, or until the engine is first turned ON. WARNING! On vehicles equipped with Anti-lock brakes (ABS), it may occur.... Trac Indicator - If Equipped The TRAC Light will make your vehicle harder to stop the ...
Owner's Manual - Page 186
... hilly terrain, traveling into this range only after the vehicle has come to a complete stop. "N" Neutral Engine may be started in this range. "D" Overdrive This range should be able to move the... use the "3" range. CAUTION! Before moving the shift lever out of P (Park), you must turn the ignition from LOCK to the steering column or shifter could result.
It provides smoothest up shifts and ...
Owner's Manual - Page 188
...upshift from first to second gear and from second to third gear when engine speed reaches about 6300 RPM. • Downshifts from third to second... you wish to engage autostick, simply move the shift lever to a stop. • Starting out in third gear is helpful in snowy or icy...OPERATING
You can shift in or out of third gear will turn off the speed control. • If the system detects ...
Owner's Manual - Page 228
... cluster indicators and all front and rear directional signals will continue to turn Hazard Warning Flashers off. Use it is in neutral, but do not increase engine idle speed.
The flasher switch is creating a safety hazard for other motorists. IF YOUR ENGINE OVERHEATS In any of the steering column, just behind the steering...
Owner's Manual - Page 229
... act as a supplement to the H (red) mark, the instrument cluster will sound a chime.
The air conditioning system adds heat to High. Pull over and stop the vehicle. If the pointer remains on the "H", turn the engine off until the pointer drops back into the normal range. If temperature gauge reads "H", pull over and...
Owner's Manual - Page 257
...that can burn. Such materials might be obtained immediately.
7 If this occurs, stop the vehicle, turn off the engine and allow it to the catalytic converter can burn. MAINTAINING YOUR VEHICLE 257
CAUTION!...abnormal catalyst overheating.
Damage to cool. In the event of engine malfunction, particularly involving engine misfire or other apparent loss of your vehicle serviced promptly. ...
Owner's Manual - Page 333
...-Lock ...131 Back-Up ...289 Brake Warning ...132 Center Mounted Stop ...289 Courtesy/Reading ...93 Daytime Running ...96 Dimmer Switch, Headlight ...95 Engine Temperature Warning ...130 Fog ...97,135,288 Front Replacement ...287 ... ...287 Theft Alarm ...129 Traction Control ...132,134,197 Turn Signal ...95,97,130,288 Voltage ...129 Warning (Instrument Cluster Description) ...129 Loading Vehicle ...223 Tires...
Similar Questions
2004 Chrysler Pt Cruiser Starter Wont Turn Engine Over
(Posted by bulnake 10 years ago)
My Pt Cruiser Wont Turn Over But The Starter Still Works
(Posted by ryankeith24365 12 years ago)