Home » Canon » Printers » Canon PIXMA MG3222

Canon PIXMA MG3222 Support Question

Find answers below for this question about Canon PIXMA MG3222.
Need a Canon PIXMA MG3222 manual? We have 2 online manuals for this item!

Canon Overview Questions Manuals Reviews Videos Research

Question posted by faustsab on July 27th, 2015

What's Its Ip Address

I want to use my Mac IPad to wireless connect to my PIXMA MG 3222 printer. The instructions ask for an IP Address of the printer. Where can I find it?

I Know the Answer!

I have the same question
Request More Information

Current Answers

Answer #1: Posted by Odin on July 27th, 2015 4:30 PM

This answer was accepted by the poster of the original question.

Odin

Member since:
April 10th, 2010

Points: 41,236,700

1,090
points

Printers don't have IP addresses; computers do. Your IP address is assigned by your Internet Service Provider. If its a "dynamic" IP, it will continually change. Phone your ISP for details.

Hope this is useful. Please don't forget to click the Accept This Answer button if you do accept it. My aim is to provide reliable helpful answers, not just a lot of them. See https://www.helpowl.com/profile/Odin.

Related Canon PIXMA MG3222 Manual Pages

Setup Guide - Page 2

Network Connection Wireless Connection Preparation for the printer. Setup Guide This guide provides information for setting up a network connection for Connection Printer Setup Connection Using WPS Troubleshooting

Setup Guide - Page 3

..." mode, WEP or TKIP cannot be used as your printer to prepare an access point. Notes on Wireless Connection • Make sure that the LED ﬂashes as shown in the illustration below . b Printer Setup 1. Make sure that the computer is connected to the access point (A) (or wireless network router) you want to connect your personal information to a third...

Setup Guide - Page 4

... the WPS button, refer to the access point. 3. For details on the printer ﬂashes while searching for about 3 seconds, then changes to Page button (A). 2. When wireless connection is complete, the LED lights up for or connecting to the access point manual. c Connection Using WPS 1. Make sure that the (blue) Wi-Fi lamp on the access...

Setup Guide - Page 5

... on ? Press and hold the Maintenance button on the printer (for a while, then conﬁgure WPS settings again. Wait for about 5 seconds). 3. Make sure that the LED ﬂashes as shown in the illustration above. Troubleshooting WPS  E>2>1 The error appears when wireless connection setup was not completed within 2 minutes after pressing...