Bosch WFL2090UC Support Question
Bosch WFL2090UC Support Question
Find answers below for this question about Bosch WFL2090UC - Axxis Series 24" High Efficiency Washer.Need a Bosch WFL2090UC manual? We have 4 online manuals for this item!
Question posted by roussey77 on September 23rd, 2012
Water Left In Water Machine
Water will not completely empty after wash cycle
Current Answers
Related Bosch WFL2090UC Manual Pages
Use & Care Manual - Page 3
... and control panel 19 Cleaning the drum 19 Cleaning the detergent dispenser 19 Cleaning the drain pump 20 Cleaning water inlet strainers 22 Descaling the washing machine 23
Customer Service 23
Troubleshooting Minor Faults 24
Installation Instructions
Installation, Connection and Transport 26 Safety information 26 FactoryĆsupplied equipment 26 Dimensions 28 Installation area...
Use & Care Manual - Page 4
...BOSCH washers ...wash water. Read all hot water faucets and let the water flow from the eletrical supply before using your washing machine, follow basic precautions, including the following.
1. Do not wash articles that you understand and have been previously cleaned in, washed in, soaked in subsequent wash loads causing skin irritation.
15. Do not touch the loading door if washing at high...
Use & Care Manual - Page 5
...washing machine until you do not lean on the top of the washing machine.
23. SAVE THESE INSTRUCTIONS
5 21. Do not climb onto the washing machine and do not understand. Close the washing machine water...35.
b. Make sure that you
are using. the washing machine has been installed
according to the electrical power supply.
24. To reduce the risk of the detergent(s), cleaning aid...
Use & Care Manual - Page 6
... soiling, amount of suffocation from plastic film and folding cartons. Intended Use
Your washing machine is disabled. Disposal Information
Disposing of your old appliance
Old appliances are not worthless rubbish!
All packaging materials are suitable for high efficiency and frontĆloading washers. - Disposing of the packaging
The shipping package has protected your new appliance...
Use & Care Manual - Page 9
About Your Washing Machine
The washing machine offers the following standard features: - High Spin Speeds, up to 1,000 rpm, remove
more water from testing procedures, the first washing cycle should be carried out without agitator - q Pull out the detergent dispenser up to the washing machine are open. q Pour approx. 1 litre / 1 ¾ pt of water into chamber II. q Close the detergent ...
Use & Care Manual - Page 11
... shorts with grass and soil stains.
- Typical stains - Sorting laundry according to one week.
- Skin fat, cooking oils / fat, sauces, mineral oil,
wax (containing fat / oil).
- First, dab soapy water onto the stain. Several washing cycles may sometimes be required in order to remove stubborn / dried in washing machine if the care label says "Do Not...
Use & Care Manual - Page 19
... completely. q Rinse the detergent dispenser under hot
running water....water or a mild, nonĆabrasive cleaning agent. coins, paper clips, needles, nails):
q Use a chlorineĆfree cleaning agent. Never use solvents to leftĆover debris (e.g. Follow the manufacturer's instructions. d
Always disconnect the appliance from the mains before cleaning. Never clean the washing machine...
Use & Care Manual - Page 21
... II. q Attach and close the cover plate. q Remove any residual water or lint from inside the pump and clean the pump.
q Carefully remove the pump cap.
Clean any loose debris / lint from the threads of water into the drain during the next wash cycle: q Pour 1 litre / 1 ¾ pt of the pump cap and pump...
Use & Care Manual - Page 30
... appliance for the first time and must be moved freely.
q Completely remove transport bolts 1 and 2 (bolts, washers and bushes).
q Store the transport bolts 1 and 2 with washer and bush attached.
30 q Completely remove transport bolt 3 (bolt, spring, washer and bush) by reaching through the open washing machine door and pulling the drum forwards slightly. Removing the transport bolts...
Installation Instructions - Page 7
...: Turn on the water completely, and check whether connection points are under full water pressure.
CAUTION
The connection...washer and the drainage point: Maximum 110 cm // 43 inches.
Drainage into standpipe or wall drain. Connection options A Cold water connection and B Hot water connection (max. 140 °F // 60 °C)
min. 10 mm
Water drainage
CAUTION
Do not bend or pull the water...
Operating, Care, Installation - Page 5
... intended purpose.
25. Do not bypass any service. all laundry chemicals and aids in this washing machine until you
are sure: a. Failure to install, maintain and/or operate the washing machine according to the manufacĆ turer`s instructions may occur. The washing machine must be used for water, drain, electrical power and grounding are tight and not leaking...
Operating, Care, Installation - Page 6
...60 °C)
tap water and conventional laundry detergents and additives that are suitable for high efficiency and frontĆloading washers. - Please ask your old appliance
Old appliances are nonĆpolluting and recyclable. Avoid using too much detergent. Environmental Protection / Conservation Issues
Your washing machine uses water, energy and detergent efficiently, thereby protecting...
Operating, Care, Installation - Page 9
...;Axis, Tumble Action Wash System,
without laundry in the machine. Before beginning to use any special detergents for the first time: q Make sure the voltage the washing machine
is to avoid excessive foaming in the wash). q Do not load any water left over from fabrics to reduce drying time and energy - 4 Fabrics and 5 Temperature Settings - 3 special cycles - 3 additional functions...
Operating, Care, Installation - Page 11
.... Sorting laundry according to remove persistent/dried in washing machine if the care label says "Do Not Wash" or the DO NOT WASH
symbol - Ú - Bibs.
- Working clothes such as overalls or baker's and butcher's aprons.
Subsequently wash the items of clothing using the appropriate program.
First, dab soapy water onto the stain. Sometimes several washing cycles may be...
Operating, Care, Installation - Page 15
... avoid creasing, when the clothing cannot be taken out of the washing machine immediately upon completion of the cycle. If both buttons for Power Wash and Quick Wash are pressed, only Quick Wash is used , regardless of the position of the detergent are activated in the water after the final rinse. In the Permanent Press, Delicates and Hand...
Operating, Care, Installation - Page 21
To prevent unused detergent from flowing into the drain during the next wash cycle: q Pour 1 litre/1 ¾ pt of water into chamber II. q Attach and tighten the pump cap. q Attach and close the cover plate. q Select the Drain program.
21
Operating, Care, Installation - Page 24
... not completely drained.
Water is not washed away. The thread of electric shock!
The ready control light flashes.
LintĆproducing laundry was selected...water drainage pipe or drain hose. Replace the drain hose.
24 Power failure. Close the loading door (a click should be opened. Press the Start button. Water does not enter the machine Water tap not turned on water...
Operating, Care, Installation - Page 25
... Add a more suitable program. Unsatisfactory washing result. Select a more appropriate amount of...waterĆinsoluble residues that may appear as light spots on the laundry.
For safety reasons, the highĆspeed final spin cycle was not spun
Large items of detergent next time.
of the detergent dispenser.Use detergent recommended for high efficiency and frontĆloading washers...
Operating, Care, Installation - Page 26
... Canada, in the pump or water inlet hose(s) must be installed:
- If any residual water in accordance with caution. Water supply hoses (cold and hot water). To drain the water hose(s) refer to damage the washing machine. Check to make sure that is located in an area exposed to these instructions the washer shall be drained.
To drain...
Operating, Care, Installation - Page 32
... of the hose and insert end of washer and the drainage point: Maximum 110 cm / 43 inches. CAUTION
The connection points are watertight.
Drainage into standpipe or wall drain. Height difference between the placement area of hose into a siphon
q After the connection: Turn on the water completely, and check whether connection points are...
Similar Questions
Bosch Axxis Series Was20160uc Can You Use Bleach
(Posted by Johnyazz 10 years ago)
Why Does Water Remain In My Softner Compartment At The End Of The Wash Cycle?
am using HE softner
am using HE softner
(Posted by donboy51 11 years ago)
E13 Error On A Bosch 500 Series Front Load Washer
(Posted by Kelloggrk 11 years ago)
Water Pouring From Soap Dispenser And Door
(Posted by jgrape77 11 years ago)
My Nexxt 300 Washing Machine Will Not Power On And I Cant Remove Access Panel
i have tried checking power supply all connections and checked that the machine is level. still no...
i have tried checking power supply all connections and checked that the machine is level. still no...
(Posted by volsfann 12 years ago)