How Can I Change The Voltage Supply From 120v. To 230 Volts?

To change the voltage supply from 120V to 230V on your Behringer NU12000 power amplifier, you need to perform the following steps:

1. Turn off the power amplifier and unplug it from the power source.
2. Locate the voltage selector switch on the back of the amplifier near the power input connector.
3. Use a small screwdriver to switch the voltage selector from 115V to 230V.
4. Double-check that the switch is set to the correct voltage for your power source to avoid damage to the amplifier when you power it on.

After changing the voltage selector switch, you can plug in your Behringer NU12000 amplifier and power it on. Make sure that the amplifier is connected to a power source that can supply the correct voltage, and ensure that all other connections are secure before using the amplifier.

If your Behringer product has this feature, you will need to locate the switch or jumper and move it to the correct position for 230 volts.

If your Behringer product does not have a voltage selector switch or jumper, it may not be designed to operate on 230 volts, and attempting to use it with that voltage could damage the device.

In this case, you may need to purchase a voltage converter or transformer that can convert the 230 volts to the appropriate voltage for your device. It's important to make sure the converter or transformer is designed to handle the power requirements of your Behringer product.

If you are unsure how to proceed, it's recommended to consult with a qualified electrician or the manufacturer of the Behringer product for guidance.