Amana NTW4600YQ Support Question
Amana NTW4600YQ Support Question
Find answers below for this question about Amana NTW4600YQ.Need a Amana NTW4600YQ manual? We have 4 online manuals for this item!
Question posted by Terencejacobs on January 1st, 2014
Washer
The washer seem like it is stuck on draining but there is no lights and the lid is not locked
Current Answers
Related Amana NTW4600YQ Manual Pages
Installation Instruction - Page 2
...Drain hose with clamp
Inlet hoses with flat washers...drain
Drain Protector Part Number 367031 Connector Kit Part Number 285835
LOCATION REQUIREMENTS
Select proper location for your washer in the top of the washer. Tools needed:
Parts needed: (Not supplied with washer...Alternate parts: (Not supplied with washer)
Adjustable or open end wrench ...possible "washer walk". Install your washer to 19...
Installation Instruction - Page 3
...: 28" (710 mm) from bottom of washer.
DRAIN SYSTEM
Drain system can be purchased separately.
Floor drain system requires a Siphon Break Kit (Part Number 285834), 2 Connector Kits (Part Number 285385), and an Extension Drain Hose (Part Number 285863) that may be installed using a floor drain, wall standpipe, floor standpipe, or laundry tub. install no more space for...
Installation Instruction - Page 4
... and a separate ground wire is used, it at this appliance be provided. it and make sure lid is adequate. n To minimize possible shock hazard, the cord must be plugged into a mating, 3...upright position. n Check with local codes and ordinances. NOTE: To avoid floor damage, set washer onto cardboard before moving it must be in accordance with a qualified electrician if you start: ...
Installation Instruction - Page 5
... already in picture) or over end as shown in case you need additional parts with clamp.
For a floor drain, remove the preinstalled drain hose form as shown. IMPORTANT: 4.5" (113 mm) of laundry tub.
Be sure to drain port
Remove tape from washer lid, open lid and remove cardboard packing tray from tray. See "Tools and Parts".
6. Attach...
Installation Instruction - Page 6
... inlet hoses to inlet valves. Screw on washer. Damage can result.
Repeat with flat washers (not provided). You may enter washer. Do not use tape or sealants on water faucets to check for a few seconds through hoses into a laundry tub, drainpipe, or bucket to remove the drain hose form from the end of which hose...
Installation Instruction - Page 7
... washer.
15. Check levelness of washer about 1/2" (13 mm) from the washer cabinet.
HELPFUL TIP: You may want to prop up front of front using lid, as needed.
When washer ...Recheck levelness of washer. Tighten leveling feet
Jam nut
With washer in its final location, place a level on leveling feet tightly against washer cabinet.
Secure drain hose
Laundry Tub
Standpipe
Wall
...
Installation Instruction - Page 8
... have all of powdered or liquid detergent and pour it into washer basket or detergent dispenser (on some models). Start washer and allow to see what was skipped. q Dispose of washer.
Close lid.
q Remove protective film from back of /recycle all parts are on washer. 16. Be sure you have correct electrical supply and recommended...
Use and Care - Page 2
WASHER SAFETY
2
Use and Care - Page 3
... at the beginning of your past agitator-style washer. Sensing
This washer will only unlock after this light is lit, the lid is paused. And, sometimes, you must be opened . Lid Locked
To allow for details. Check the "Cycle Guide" for higher spin speeds, the lid will lock and the Lid Locked light will turn on when in fill could take...
Use and Care - Page 4
... spin speeds, the lid will lock and the Lid Locked light will unlock briefly before filling. The wash time is normal. Press and hold for your laundry load. Items need to resume the cycle. This is determined by regulating incoming hot and cold water.
press again to the wash cycle as the washer rinses and moves the...
Use and Care - Page 5
...linens, synthetics
Casual Heavy
No-iron fabrics, cottons, perm press, linens, synthetics
Casual Regular
Lightly soiled no -iron fabrics such as needed. Use this cycle for loads that best fits... Low Low Low High
Use this
cycle to the way garments are cold.
5 Similar to drain washer after cancelling a cycle or completing
a cycle after power interruption. NOTE: Use mesh garment bags ...
Use and Care - Page 6
...: Follow the manufacturer's instructions to your laundry
2. USING YOUR WASHER
1. Loose change, buttons, or any small object can pass under the agitator and become trapped, causing unexpected sounds.
■■ Sort garments by recommended cycle, water temperature, and colorfastness.
■■ Separate heavily soiled garments from lightly soiled.
■■ Separate delicate...
Use and Care - Page 7
... bleach or Oxi products in the same cycle with warm water until the washer has completed filling, press the START/Pause/Unlock Lid button to dispenser
(on load. Lift the lid and add the measured recommended amount of the basket. Load laundry into the basket or on some models)
Load garments in loose piles...
Use and Care - Page 8
...and pastels Durable garments Heavy soils
Warm
Some cold water will be cooler than what your previous washer provided. Filling is sensed.
You will be added, so this will hear the hum of ...was spinning at high speed. 7. Suggested Fabrics
Dark colors that bleed or fade
Light soils
Press the START/Pause/Unlock Lid button to filling. Small will add a low amount of the spin prior to...
Use and Care - Page 9
... settings sometimes (not exclusively cold water washes), because they do not use to the bleach compartment. NOTE: This washer does not include inlet hoses. See the "Installation Instructions" for cleaning.
Close the washer lid.
WASHER CARE
Recommendations to use this cycle with a damp cloth and towel dry. Never use more liquid chlorine bleach than...
Use and Care - Page 10
... back of detergent for a medium-size load.
10 Place inlet hoses and drain hose inside washer. REINSTALLING/USING WASHER AGAIN
To reinstall washer after non-use washer again: 1. Plug in new location. TRANSPORTING YOUR WASHER
1. Close lid and place tape over edge and into washer basket.
7. If washer will be moved during freezing weather, follow "Winter Storage Care" directions...
Use and Care - Page 11
...laundry tubs, drain pipe, water pipes,
drain. Pull drain hose from washer cabinet and properly secure it to basket could unbalance washer.
Check that the washer...the floor and locked. Check household plumbing Water can cause basket to the washer. TROUBLESHOOTING
First... sound. Tighten fill-hose connection.
Humming
Fill light is added to be level with periodic gurgling or...
Use and Care - Page 12
...correct Check drain hose for washer to run or fill, washer stops working or wash light remains on (indicating that the washer was unable...drain opening. To remove extra water in basket, and add detergent. stop draining and spinning.
12 Close lid and press START/Pause/Unlock Lid. attach to possibly avoid a service call. Replace any clogs from drain
standpipe farther than normal. Washer...
Use and Care - Page 13
...by mixing types of load items. Use the recommended cycle for the fabrics being washed. Washer is less efficient at rinsing when load is tightly packed.
TROUBLESHOOTING
First try the solutions ... . Load with air flow during the final spin. Add only 1 or 2 additional garments after washer has started . Select the Rinse/Spin cycle.
Load garments in loose heaps evenly around the basket ...
Use and Care - Page 14
... threads in the fabric softener dispenser. Lid Locked light is flashing
The lid is complete. A cycle was stopped or paused using dispensers. The lid will damage fabrics.
Wash like colors together... manufacturer's directions based on top of bleach dispenser when loading and unloading washer. The washer may take several minutes if washing large loads or heavy fabrics.
14
Sharp...
Similar Questions
Nfw7300ww02 Amana Front Load Washer Will Not Spin Fast.
NFW7300WW02 front load washer will not spin fast enough to remove the water with a normal size load ...
NFW7300WW02 front load washer will not spin fast enough to remove the water with a normal size load ...
(Posted by rtdk 3 years ago)
Amana Washer Model Number Ntw4600yq Ww
Washer will not fill. I disconnect the lid lock cause it kept flashing
Washer will not fill. I disconnect the lid lock cause it kept flashing
(Posted by Otheahc 8 years ago)
It Fills When It Goes Into The Wash Cycle The Washer Stops The Light Flashes, It
(Posted by teresapoland9 10 years ago)
When Washer Goes Into Cycle To Fill And Then The Lid Lock Is Suppose To Engage
When you start washer the fill light comes on and then the lid lock is suppose to engage and then fi...
When you start washer the fill light comes on and then the lid lock is suppose to engage and then fi...
(Posted by Cindymbrister 10 years ago)