Anyone Has Advices And Tutos For Mounting 445 On C3 Picasso?

Prepare the mounting location. The amplifier should be mounted in a secure location that is not exposed to heat, moisture, or vibration. A good location is behind the dashboard or in the trunk.

Mark the mounting holes. Use the amplifier as a template to mark the four screw holes on the mounting surface.

Drill the mounting holes. Use a drill bit that is slightly smaller than the screws that will be used to mount the amplifier.

Mount the amplifier. Insert the screws through the mounting holes and into the amplifier. Tighten the screws securely.

Secure the amplifier with cable ties. Push two of the included cable ties through the two mounting loops near each end on the bottom panel. Use the cable ties to securely attach the amplifier to the vehicle's frame or chassis.

Connect the power and signal wires. Connect the power wires to the amplifier's power terminals. Connect the signal wires to the amplifier's input terminals.

Ground the amplifier. Connect the amplifier's ground wire to a good ground point on the vehicle.

Here are some additional tips for mounting the Alpine KTP-445A:

Use a level to make sure that the amplifier is mounted level.

Use washers under the screws to prevent the screws from stripping the mounting holes.

Use a rubber mat or other insulator under the amplifier to prevent it from vibrating.

Make sure that the amplifier is not in contact with any hot or moving parts.

I hope this helps! Let me know if you have any other questions.