AIWA TS-W60 Support Question

Find answers below for this question about AIWA TS-W60.
Need a AIWA TS-W60 manual? We have 1 online manual for this item!

AIWA Overview Questions Manuals Reviews Videos Research

Question posted by kire1634 on January 14th, 2013

Power On However No Sound

The power light is on however there is no sound comming through the speaker.

I Know the Answer!

I have the same question
Request More Information

Current Answers

There are currently no answers that have been posted for this question.
Be the first to post an answer!

Remember that you can earn up to 1,100 points for every answer you submit. The better the quality of your answer, the better chance it has to be accepted.

Related AIWA TS-W60 Manual Pages

User Guide - Page 1

... contact your set) in case of difficulty. TS-W60 U Serial No. Model No. aiwa Active Speaker System (Powered Subwoofer) TS-W60 pg. 2 OWNERS RECORD For your convenience, record the model number and serial number (you will find them when you can adjust the frequency range of the sound reproduced by the powered subwoofer. • Two-way connection to...

User Guide - Page 2

... makes it possible for safe and correct operation. speaker terminals. • Dynamic Bass System TS-W60 adopts a Dynamic Bass System in which port (1), duct (1), and air cavity (2) compose an acoustic bandpass filter in front of this structure, the bass reproduction limit is extended and sounds higher than middle range frequencies are extremely hot, cold...

User Guide - Page 3

...sound, the powered subwoofer should be hazardous. • When you are not going to use strong solvents, such as the recorded information may be erased or some noise may damage it and thus be placed on flowing to the unit even if the power...disconnecting the AC cord, always grasp the plug. CONNECTIONS Connect the speaker cords before connecting the AC cord. Keep away magnetic items Keep ...

User Guide - Page 4

... jack on the stereo system side a to the INPUT 1 (FROM SUPER WOOFER TERMINAL) jack on the powered subwoofer b with the supplied connecting cord. 2 Set the INPUT SELECT switch to the INPUT 2 (FROM SPEAKERS OUT) terminals on the powered subwoofer b with the value specified on the stereo system. B Connecting a stereo system with typical L and...

User Guide - Page 5

... the powered subwoofer, do not set the volume of the stereo system so high that the sound is ...lights up. 2 Start playback on the floor and the graphic equalizer is set to its position and the graphic equalizer setting of the connected stereo system. 1 Press the POWER button. ADJUSTING THE VOLUME BALANCE Adjust the volume balance between the powered subwoofer and the left and right speakers...

User Guide - Page 6

... Hz and under. Depending upon the room or the characteristics of the other speakers. Set to complement the sound range of the right and left speakers, sound from either INPUT 1 or INPUT 2. While the AUTO POWER switch is set to OFF, the power is turned on or off if no signal is automatically turned on when...

User Guide - Page 7

... ohms (at 60 Hz INPUT 2: 9 V/4.4 kilo ohms (L and R) (at 60 Hz) Frequency response 35 Hz 200 Hz Speaker type Bass reflex type Speaker unit 20 cm (8 in.) (Magnetically shielded type) Power requirement AC 120 V, 60 Hz Power consumption 55 W Dimensions (w/h/d 295 x 340 x 430 mm 11 5/8 x 13 1/2 x 17 in.) Weight 11.5 kg (25 lbs 6 oz...