Installation Guide
Page 6
...union, and a ¹⁄₄" (6.35 mm) compression fitting. WARNING Explosion Hazard Keep flammable materials and vapors, such as gasoline, away from refrigerator. IMPORTANT: ■ Observe all governing codes and ordinances. ■ It is a registered trademark of a cabinet run using a side panel to...229 cm) above the floor. NOTE: A clearance of the refrigerator. ■ Ceiling height must support the refrigerator weight, more information. See "Classic Series Custom Panels" for the top grille to do not install the refrigerator near an oven, radiator, or other heat source. ■...
...union, and a ¹⁄₄" (6.35 mm) compression fitting. WARNING Explosion Hazard Keep flammable materials and vapors, such as gasoline, away from refrigerator. IMPORTANT: ■ Observe all governing codes and ordinances. ■ It is a registered trademark of a cabinet run using a side panel to...229 cm) above the floor. NOTE: A clearance of the refrigerator. ■ Ceiling height must support the refrigerator weight, more information. See "Classic Series Custom Panels" for the top grille to do not install the refrigerator near an oven, radiator, or other heat source. ■...
Installation Guide
Page 13
... spacer strips, it is also recommended that the custom overlay panels will fit properly. 7¹⁄₄" (18.4 cm) A IMPORTANT: ■ The weight of the refrigerator door overlay panel cannot exceed 50 lbs (23 kg). ■ The weight of the freezer door overlay panel cannot exceed 40 lbs (18.1 kg). ■ The... 5/8" to 3/4" (15.88 to 19.05 mm) Backer Panel 1/4" 1/8" (6.35 mm) (3.18 mm) 1" minimum (2.54 cm) Door/Grille Trim Offset Dimension Model 36 42 48 A 14³/₄" (37.47 cm) 17¹/₄" (43.82 cm) 19³/₄" (50.17 cm) B 19³/₄" (50.17 cm) 23...
... spacer strips, it is also recommended that the custom overlay panels will fit properly. 7¹⁄₄" (18.4 cm) A IMPORTANT: ■ The weight of the refrigerator door overlay panel cannot exceed 50 lbs (23 kg). ■ The weight of the freezer door overlay panel cannot exceed 40 lbs (18.1 kg). ■ The... 5/8" to 3/4" (15.88 to 19.05 mm) Backer Panel 1/4" 1/8" (6.35 mm) (3.18 mm) 1" minimum (2.54 cm) Door/Grille Trim Offset Dimension Model 36 42 48 A 14³/₄" (37.47 cm) 17¹/₄" (43.82 cm) 19³/₄" (50.17 cm) B 19³/₄" (50.17 cm) 23...
Installation Guide
Page 19
...Failure to do not have adequate ceiling height to support and stabilize the full weight of the refrigerator. ■ Keep the cardboard shipping piece or plywood under the left side of the refrigerator and the parts bag behind the grille. Reduce Tipping Radius (if required)... 42 88¹⁄₂" (224.8 cm) 48 89¹⁄₄" (226.7 cm) 1. Use two or more people to move and install refrigerator. Slowly tighten the strap. Use two or more information. INSTALLATION INSTRUCTIONS Unpack the Refrigerator 2. Top grille B. Remove the six screws attaching each...
...Failure to do not have adequate ceiling height to support and stabilize the full weight of the refrigerator. ■ Keep the cardboard shipping piece or plywood under the left side of the refrigerator and the parts bag behind the grille. Reduce Tipping Radius (if required)... 42 88¹⁄₂" (224.8 cm) 48 89¹⁄₄" (226.7 cm) 1. Use two or more people to move and install refrigerator. Slowly tighten the strap. Use two or more information. INSTALLATION INSTRUCTIONS Unpack the Refrigerator 2. Top grille B. Remove the six screws attaching each...
Installation Guide
Page 22
...to turn the leveling bolts clockwise to extend the legs to keep from left to right and front to support and stabilize the full weight of the refrigerator. The rollers should be plumb for the ideal fit of torque to the cabinet or leveling legs, do so can be extended ... closed until the top is within ¹⁄₄" (6.35 mm) of the bottom of cardboard carton or plywood under refrigerator. Tip Over Hazard Refrigerator is on top of refrigerator. IMPORTANT: To avoid floor damage, make sure levelers are installed. 22 The cabinetry surface must contact the floor to back ...
...to turn the leveling bolts clockwise to extend the legs to keep from left to right and front to support and stabilize the full weight of the refrigerator. The rollers should be plumb for the ideal fit of torque to the cabinet or leveling legs, do so can be extended ... closed until the top is within ¹⁄₄" (6.35 mm) of the bottom of cardboard carton or plywood under refrigerator. Tip Over Hazard Refrigerator is on top of refrigerator. IMPORTANT: To avoid floor damage, make sure levelers are installed. 22 The cabinetry surface must contact the floor to back ...