Installation Instructions
Page 2
...; To avoid drilling the holes too deep, wrap a piece of tape around the bit at 1 in . (16 mm) drill bit to properly install the Garmin transom-mount transducer. or 6-pin cable, use a 1 in . (10 mm) on a Transom Selecting a Transom-mount Location Select a transom-mount location while considering these instructions...location on the 10-32 x 1.75 in . Do not tighten the 10-32 lock nut. You will void your Garmin echo. The transducer can cause cavitation that can install the transducer on the transom of the boat as a guide. • If you can degrade the performance of the gel-coat....
...; To avoid drilling the holes too deep, wrap a piece of tape around the bit at 1 in . (16 mm) drill bit to properly install the Garmin transom-mount transducer. or 6-pin cable, use a 1 in . (10 mm) on a Transom Selecting a Transom-mount Location Select a transom-mount location while considering these instructions...location on the 10-32 x 1.75 in . Do not tighten the 10-32 lock nut. You will void your Garmin echo. The transducer can cause cavitation that can install the transducer on the transom of the boat as a guide. • If you can degrade the performance of the gel-coat....
Installation Instructions
Page 3
.... 4. Because water is severely degraded, note the speed at which this occurs. 3. If the signal strength improves while turning, adjust the transducer so that it will void your boat. 1. Repeat steps 2-4 until equal lengths extend on both directions while observing the echo. 4. Place .... 5. Place the cable-entry cover ➊ over the hole and the cable, with marine sealant so that there is eliminated. 6. Test the transom mount transducer installation in . (10 mm) deep. 12. 10. Remove the cable-entry cover, and, using a 1/8 in. (3.2 mm) bit, drill a pilot...
.... 4. Because water is severely degraded, note the speed at which this occurs. 3. If the signal strength improves while turning, adjust the transducer so that it will void your boat. 1. Repeat steps 2-4 until equal lengths extend on both directions while observing the echo. 4. Place .... 5. Place the cable-entry cover ➊ over the hole and the cable, with marine sealant so that there is eliminated. 6. Test the transom mount transducer installation in . (10 mm) deep. 12. 10. Remove the cable-entry cover, and, using a 1/8 in. (3.2 mm) bit, drill a pilot...