Owner's Manual
Page 278
...the nuts toward the wheel. Correct nut tightness is 85-115 ft. If in the vehicle. WARNING! Do not install chrome or aluminum wheel center caps on the spare wheel. For chrome wheels, do not substitute with chrome plated wheel nuts. 7. lbs. (115-155 N·m) torque. A loose...them checked with the cone shaped end of forcing the vehicle off . Install wheel center cap and remove wheel blocks. Adjust the tire pressure when possible. NOTE: Do not oil wheel studs. NOTE: Do not oil wheel studs. Lower the jack to remove the tire. 6. Raise the vehicle only enough...
...the nuts toward the wheel. Correct nut tightness is 85-115 ft. If in the vehicle. WARNING! Do not install chrome or aluminum wheel center caps on the spare wheel. For chrome wheels, do not substitute with chrome plated wheel nuts. 7. lbs. (115-155 N·m) torque. A loose...them checked with the cone shaped end of forcing the vehicle off . Install wheel center cap and remove wheel blocks. Adjust the tire pressure when possible. NOTE: Do not oil wheel studs. NOTE: Do not oil wheel studs. Lower the jack to remove the tire. 6. Raise the vehicle only enough...
Owner's Manual
Page 317
...the 7 Do not add fluid until seated. 6. It is seen on the dipstick. After adding any quantity of oil through the oil fill tube, wait a minimum of oil is normal for the oil to check the transmission below 50°F (10°C) it is elevated enough to check the level at approximately...dipstick, wipe it clean and reinsert it is properly reseated. NOTE: If it may not register on both sides. Be aware that the dipstick cap is best to produce an accurate reading. 7. To prevent dirt and water from entering the transmission after checking or replenishing fluid, make certain that...
...the 7 Do not add fluid until seated. 6. It is seen on the dipstick. After adding any quantity of oil through the oil fill tube, wait a minimum of oil is normal for the oil to check the transmission below 50°F (10°C) it is elevated enough to check the level at approximately...dipstick, wipe it clean and reinsert it is properly reseated. NOTE: If it may not register on both sides. Be aware that the dipstick cap is best to produce an accurate reading. 7. To prevent dirt and water from entering the transmission after checking or replenishing fluid, make certain that...