iRobot Verro 500 Support Question
iRobot Verro 500 Support Question
Find answers below for this question about iRobot Verro 500.Need a iRobot Verro 500 manual? We have 1 online manual for this item!
Question posted by alain1reg on October 31st, 2022
Parts For Irobot Verro 500
hiWhere can I get the part #9 called the filter screen for my pool vacuum cleaner IRobot Verro 500. I live in Canada.Thank you
Current Answers
Answer #1: Posted by SonuKumar on October 31st, 2022 8:55 PM
SonuKumar
Member since:
May 9th, 2021 Points: 16,596,890
Member since:
May 9th, 2021 Points: 16,596,890
https://www.tomcatparts.com/product-category/irobot-verro-500-parts/
https://www.primepoolmarket.com/category_s/11138.htm
Please respond to my effort to provide you with the best possible solution by using the "Acceptable Solution" and/or the "Helpful" buttons when the answer has proven to be helpful.
Regards,
Sonu
Your search handyman for all e-support needs!!
Related iRobot Verro 500 Manual Pages
Product Manual - Page 2
...If the supply cord is damaged, it from the power outlet before removing the cleaner from the pool. Mishandling the unit can result in order to avoid hazards. The connection to ...while people are swimming in the pool all the time.
Do not leave the cleaner in the pool.
Safety Notes
WARNING: Your cleaner should be consistent with water.
iRobot Verro Owner's Manual The unit must...
Product Manual - Page 3
...pool cleaner ON if it in the rain. Allow the cleaner to remain in the pool for future reference. The floating power cord must be locked in water. www.irobot.com
Cautions
Please read this manual completely before operating your cleaner.... Do not leave your pool cleaner. Do not use the floating power cord to lift Verro from the pool. Retain the safety and operating instructions for 15...
Product Manual - Page 4
... rain. Tip Periodically straighten the floating power cord with the Detangler.
iRobot Verro Owner's Manual The fine filter bag is not kept clean, Verro will not clean properly and will result in a dry place out of direct sunlight at www.irobot.com) when the pool contains a significant quantity of large debris (leaves, etc.), such as when...
Product Manual - Page 5
Table of Contents
Anatomy 6 Parts List 7 Using Verro 8 - 10 How Verro Works 11 Cleaning the Filter Bag 12 - 13 Maintenance and Adjustment 14 - 18 Troubleshooting 19 - 20 Customer Care 21
www.irobot.com
Product Manual - Page 7
... Tabs
www.irobot.com Pump Motor 3. Body Assembly 9. Filter Screen 10. Bottom Lid Assembly 14. Handle Assembly 15. ON button 22. Drive Motor 4. Drive Belt 7. Drive Track 8. Side Plate 11. 22
17
16
19 20 21
24
Parts List
1. Handle Lock Mechanism 5. OFF button 20. Light 21. Filter Bag 13. Power Supply (Transformer) 17. Vacuum Intake...
Product Manual - Page 8
...Uncoil the floating power cord and spread it over the surface of the water.
3
Place Verro in the water and rock it is right side up and level.
4 Place the Power ... the handle. Each time Verro cleans the pool, reverse the direction of the pool. Let Verro settle to escape. Ensure that it from the pool. 3.5m/12ft
iRobot Verro Owner's Manual
Using Verro
1 Position the handle ...
Product Manual - Page 9
... the Power Supply.
Push and rotate clockwise
6 Ensure the Power Supply at least 12 feet from the pool and plug it will vary based on the Power Supply will illuminate and Verro will start Verro;
www.irobot.com ON: Green button turns robot ON. OFF: Red button turns robot OFF. Once the plug is...
Product Manual - Page 10
... allow the motors to unlock it from the power outlet before removing the cleaner from the pool.
10 Unplug the Power Supply from the water. Never leave the Power Supply plugged in when Verro is lifted.
10 iRobot Verro Owner's Manual Rotate counter-clockwise and pull to unlock
12 Use the floating power cord to...
Product Manual - Page 11
... than 500 microns in size.) The force of the water being pumped up through the bottom of water per minute through a filter bag that they can be vacuumed up, along with all the way from the bottom to the walls and bottom of your pool all of the other loose dirt and debris. www.irobot...
Product Manual - Page 12
...
Towel
12 iRobot Verro Owner's Manual
Towel
3 Unlock and remove the bottom panel by pushing the two locking tabs toward the sides of the water pumped through the filter bag to prevent scratching the robot's shell).
Cleaning the Filter Bag
Verro uses the force of the robot. If the filter bag becomes clogged, Verro will not be...
Product Manual - Page 13
If this does not remove all visible dirt, machine wash the bag using cold water on the support bars.
www.irobot.com 13 Do not machine dry.
7 Turn the filter bag so that the felt surface is on the inside out and rinse away any accumulated debris with a hose. Make sure the tabs...
Product Manual - Page 14
... filter bag assembly. (p. 12)
3 Locate the side of direct sunlight at 877.855.8593. Important: Failure to properly store Verro will be happy to provide assistance.
1 Unplug the Power Supply. (Please keep your robot looking good for years to unlock it . Please read these instructions carefully before proceeding.
Maintenance and Adjustment
Rinsing Verro iRobot...
Product Manual - Page 15
Side Plate
5 Note the arrangement of the drive belts and drive tracks and then remove the front and rear brush rollers. www.irobot.com 15 Wheel Tube
PVA Brush
End Hub
6 Remove the end hubs from the rollers.
7 Pull the brushes off the wheel tubes. If the brushes ...
Product Manual - Page 16
...tracks.
16 iRobot Verro Owner's Manual If you have difficulty climbing the walls of the robot, remove the four screws that hold on its drive wheel. When this happens, Verro may move more...provide assistance.
1 Place Verro upside down on a towel and remove the filter bag assembly. (p. 12)
2 On each side of the pool. You may have any difficulty, please call our customer care representatives at...
Product Manual - Page 17
...in your pool in the handgrip so that reduces any tendency for external damage. If the cord does become twisted. Detangler location
1 Unplug the floating power cord from the Power Supply. 2 Place Verro so ...use the Detangler to untwist it untwists as you can walk away from it .
www.irobot.com 17 Verro is designed to rotate in a way that it manually. However, if the cord tangles ...
Product Manual - Page 18
... to the robot. 3 Lift off the outlet top. 4 Clean any debris from the propeller and shaft. 5 Replace the outlet top and reinstall the screws. 18 iRobot Verro Owner's Manual
Product Manual - Page 19
...
Many problems with Verro are available separately from the pool.
cleaning cycle
The floating power cord Plug the floating power cord into a GFCI outlet. If rinsing the filter bag by a dirty or clogged filter bag.
Always turn the locking collar
Power Supply
clockwise to operate at least 12 feet from www.irobot.com). Verro depends on...
Product Manual - Page 20
... its twisted floating power cord
20 iRobot Verro Owner's Manual
is not getting caught.
of the pool. Consider repositioning the Power Supply to untwist the cord. (p. 17) stuck on which it may
get caught.
Troubleshooting (cont...)
Problem
Verro does not cover the entire pool
Likely cause
What to do
The filter bag needs to be Clean...
Product Manual - Page 21
... our web site at 877.855.8593 iRobot Customer Care Hours: • Monday - Friday 9AM - 7PM Eastern Time • Saturday 9AM - 6PM Eastern Time
www.irobot.com 21 Should you . We would like to hear from you still need assistance, call our customer care representative at www.irobot.com for support tips, frequently asked...
Product Manual - Page 22
...
Verro Accessories: Mesh Filter Bag Fine Filter Bag iRobot Verro Storage Caddy
Visit our website to change. Register your iRobot®Verro™ today. Shipping and handling not included.
© 2007 iRobot Corporation, 63 South Avenue, Burlington, MA 01803. Cover photo © Veer Incorporated 2002 - 2005. All rights Reserved.
3000a.07 iRobot is a registered trademark and Verro...
Similar Questions
Irobot Verro 500 Outlet Cover
IRobot Verro 500 outlet cover
IRobot Verro 500 outlet cover
(Posted by Anonymous-174235 10 months ago)
Parts Needed For Irobot Verro 500
I live in Quebec and need bags for my irobot verro 500.Also I would need part 39: wich is a blue U s...
I live in Quebec and need bags for my irobot verro 500.Also I would need part 39: wich is a blue U s...
(Posted by Lparadis27651 10 months ago)
Irobot Verro 500 And 600 Pulley
Hello,Looking to get irobot Verro 500 pulley (2x), where can I purchase them in Canada?
Hello,Looking to get irobot Verro 500 pulley (2x), where can I purchase them in Canada?
(Posted by fairwood8 1 year ago)
Tune Up For Irobot Verro 500
Where if possible can i send my iRobot Verro 500 to be tuned up ?If this is not possible do you have...
Where if possible can i send my iRobot Verro 500 to be tuned up ?If this is not possible do you have...
(Posted by lynedenis 2 years ago)
Part Irobot 500
I need a part for my IRobot 500. It's the two small straps inside the robot. I leave in Montreal, Ca...
I need a part for my IRobot 500. It's the two small straps inside the robot. I leave in Montreal, Ca...
(Posted by 5mars 11 years ago)