Whirlpool WVI75UC6DS Support Question
Whirlpool WVI75UC6DS Support Question
Find answers below for this question about Whirlpool WVI75UC6DS.Need a Whirlpool WVI75UC6DS manual? We have 2 online manuals for this item!
Question posted by Artevd on January 7th, 2019
Fan And Lights Malfunction.
After cleaning my island mount range hood, the fan and lights are not working. I used a spray to clean the grease on the outside of the range hood. I never touched or dealt with any of the wiring connection. The electrical box does not show a circuit short. What could have happened
Current Answers
Answer #1: Posted by BusterDoogen on January 7th, 2019 1:10 PM
BusterDoogen
Member since:
October 30th, 2011 Points: 28,565,447
Member since:
October 30th, 2011 Points: 28,565,447
Observe all governing codes and ordinances.
Ensure that the electrical installation is adequate and in
conformance with National Electrical Code, ANSI/NFPA 70 (latest
edition), or CSA Standards C22.1-94, Canadian Electrical Code,
Part 1 and C22.2 No. 0-M91 (latest edition) and all local codes
and ordinances.
If codes permit and a separate ground wire is used, it is
recommended that a qualified electrician determine that the
ground path is adequate.
A copy of the above code standards can be obtained from:
National Fire Protection Association
1 Batterymarch Park
Quincy, MA 02169-7471
CSA International
8501 East Pleasant Valley Road
Cleveland, OH 44131-5575
A 120 volt, 60 Hz., AC only, 15-amp, fused electrical circuit is required.
If the house has aluminum wiring, follow the procedure below:
1. Connect a section of solid copper wire to the pigtail leads.
2. Connect the aluminum wiring to the added section of
copper wire using special connectors and/or tools
designed and UL listed for joining copper to aluminum.
Follow the electrical connector manufacturer's recommended
procedure. Aluminum/copper connection must conform with
local codes and industry accepted wiring practices.
Wire sizes and connections must conform with the rating of
the appliance as specified on the model/serial rating plate.
The model/serial plate is located behind the filter on the rear
wall of the range hood.
Wire sizes must conform to the requirements of the National
Electrical Code, ANSI/NFPA 70 (latest edition), or CSA
Standards C22. 1-94, Canadian Electrical Code, Part 1 and
C22.2 No. 0-M91 (latest edition) and all local codes and ordinances. Go to page 14 for the schematic
I hope this is helpful to you!
Please respond to my effort to provide you with the best possible solution by using the "Acceptable Solution" and/or the "Helpful" buttons when the answer has proven to be helpful. Please feel free to submit further info for your question, if a solution was not provided. I appreciate the opportunity to serve you!
Related Whirlpool WVI75UC6DS Manual Pages
Use & Care Guide - Page 1
IMPORTANT : LIRE ET CONSERVER CES INSTRUCTIONS. POUR UTILISATION RÉSIDENTIELLE UNIQUEMENT.
LI32MA/W10674117A
FOR RESIDENTIAL USE ONLY. 36" (91.4 CM) ISLAND-MOUNT CANOPY RANGE HOOD
Installation Instructions and Use & Care Guide
For questions about features, operation/performance, parts, accessories or service, call: 1-800-253-1301 or visit our website at www.whirlpool.com
In ...
Use & Care Guide - Page 2
...4 Location Requirements 4 Venting Requirements 5 Electrical Requirements 6
INSTALLATION INSTRUCTIONS 7 Prepare Location 7 Assemble Range Hood 8 Install Range Hood 8 Make Electrical Connection 9 Install Duct Covers 10 Complete Installation 11
RANGE HOOD USE 12 Range Hood Controls 12
RANGE HOOD CARE 13 Cleaning 13
WIRING DIAGRAM 14
ASSISTANCE OR SERVICE 15 In the U.S.A 15 In Canada...
Use & Care Guide - Page 3
...or cleaning the unit, switch power off the burner. Follow the heating equipment manufacturer's guideline and safety standards such as a tag, to the service panel.
■ Installation work and electrical wiring must ...THE RISK OF FIRE, USE ONLY
METAL DUCTWORK. Heat oils slowly on fan or filter.
■ Use proper pan size. WARNING: TO REDUCE THE RISK OF A RANGE TOP
GREASE FIRE:
■ Never...
Use & Care Guide - Page 4
...
brackets, rubber seals, and LED lights installed. ■ Metal grease filter ■ 60 - 4.2 x 8 mm screws ■ 4 - 3.5 x 6.5 mm screws ■ 2 - 2.9 x 3 mm screws ■ 4 - 5 x 45 mm screws ■ T10 Torx®† adapter ■ T20®† Torx® adapter ■ 2 -
Given dimensions provide minimum clearance. If this range hood must be attached to support 80...
Use & Care Guide - Page 5
...range hood filter surface: D-A-C=B
C.
The specified CFM varies from gas cooking surface, suggested 36" (91.4 cm) max. To vent through the top of the vent system. Hood height: 24" (61.0 cm) min. from locale to the outside...Venting Methods
This island hood is available ...use the damper supplied with the range hood. The chimney extension replaces the chimney shipped with the range hood...
Use & Care Guide - Page 6
...wire using special connectors and/or tools designed and UL listed for joining copper to aluminum. Aluminum/copper connection must conform with local codes and industry accepted wiring practices.
■ Wire sizes and connections ... m)
The following example falls within the maximum vent length of the range hood.
■ Wire sizes must conform with National Electrical Code, ANSI/NFPA 70 (latest ...
Use & Care Guide - Page 7
... height and the range hood height maximum before the range hood is installed.
■ Before making cutouts, make the connection in the hood's electrical terminal box. for wire access.
2. The line for exhaust vent.
■ Range hood is to mark the mounting screws, wire access and duct hole locations on the ceiling at the marked centerline. Disconnect power.
2. Use a pencil to be...
Use & Care Guide - Page 8
... 1. Attach the air deflector to the range hood using
4 mounting screws.
Notched end
A B
A. Continue with "Range Hood Installation" in this range hood only with the notches at the bottom and attach to the upper horizontal support using 16 - 4.2 x 8 mm screws.
3. Optional
NOTE: Your range hood can work with this range hood to the ceiling.
B
A
A
C
C
A. NOTE: To make...
Use & Care Guide - Page 9
...light bulbs are secure in death or electrical shock. 1. Use caulk to do so can result in terminal box using UL listed wire connectors.
8. Terminal box C. UL listed wire connectors
E. NOTE: Use only with range hood cord connection... relief
C. Connect ground wire to do so can result in their sockets. 11. Tighten strain relief screw. 9. A
4. Mounting screws
Connect Vent System ...
Use & Care Guide - Page 10
...outside of the assembled duct covers.
3. Secure the upper duct covers together with 2 - 3.5 x 6.5 mm screws.
A
A. 3.5 x 6.5 mm screw B. A
B
A. Plastic clips (2) (long end for non-vented installations C. Slots installed down inside the lower duct covers. Install the lower duct cover (rear) to the range hood... lower duct cover (front) to the range hood canopy. D
C
B
C
A. Slots...
Use & Care Guide - Page 11
.... Lower duct covers D. See the "Range Hood Care" section.
2. See the "Range Hood Care" section.
3. Check the operation of the range hood blower and light. A. Use one plastic clip on each side. See the "Range Hood Use" section.
D
8.
A
B
C
A. Upper duct covers
7.
If range hood does not operate, check to the range hood canopy using 2 plastic clips.
Lower duct cover...
Use & Care Guide - Page 12
...light in the area around the range hood. Metal grease filters (located behind the perimetric cover)
F. Press to the right to turn AMBIENT LIGHTING or AUTO Off. Press to the center to turn AMBIENT LIGHTING On.
3. The Ambient Lighting... only)
B. NOTE: When the Ambient Lighting is placed in the ON or OFF position.
12
RANGE HOOD USE
The range hood is designed to turn AUTO On.
2....
Use & Care Guide - Page 13
...Bend spring clips away from range hood.
Replacing a LED Lamp
The LED lights are toward the front. Replace with Charcoal Filter Kit Number W10412939. Wash metal filter as needed in spring release handle. 6. The panel is not washable. Replace grease filters before operating hood. RANGE HOOD CARE
Cleaning
IMPORTANT: Clean the hood and grease filters frequently according to the...
Use & Care Guide - Page 14
...30.3
Blue -
WIRING DIAGRAM
BK WH YL/GN
RD WH BR BK BR YL
Ambient Light Switch
Function
Position
On...
Position 3
3
2
1
Off
Position 2
3
2
1
Auto
Position 1
3
2
1
LNG
POS 1 POS 2 POS 3
1
BU
WH
2
3
RD
WH
YL
BK
Push Button Switch 2 1 L 3 L La
YL/GN YL/GN
RD
WH
Push Button Switch Operation
Function Position
Off
No Connection...
Use & Care Guide - Page 15
...and specifications on our full line of appliances. ■ Referrals to local dealers. ■ Use and maintenance procedures. ■ Accessory and repair parts sales. Whirlpool designated service
technicians are made ... daytime phone number in this manual. Factory specified parts will fit right and work right because they are trained to fulfill the product warranty and provide after -warranty...
Use & Care Guide - Page 16
...outside the 50 United States or Canada, contact your authorized Whirlpool dealer to use...warranty is provided exclusively by a Whirlpool designated service company. house wiring, fuses or water inlet hoses).
4. Consumable parts (i.e. Before... HERE. light bulbs, batteries, air or water filters, preservation solutions, etc.).
5. trim, decorative panels, flooring, cabinetry, islands, countertops,...
Use & Care Guide - Page 32
Tous droits réservés.
6/14 Printed in Canada. All rights reserved. W10674117A
®/™ ©2014 Whirlpool. Used under license in Mexico Imprimé au Mexique Utilisé sous licence au Canada.
Warranty Information - Page 1
...use your product requires repair. If outside the 50 United States or Canada, contact your appliance will pay for service in materials or workmanship that vary from natural gas or L.P. Commercial, non-residential, multiple-family use, or use with products not approved by Whirlpool.
7. light..., islands, countertops, drywall,...-253-1301. house wiring, fuses or water inlet...
Warranty Information - Page 3
Used under license in Mexico Imprimé au Mexique All rights reserved. Tous droits réservés.
6/14 Printed in Canada. Utilisé sous licence au Canada. W10674117A
®/™ ©2014 Whirlpool.
Whirlpool Knowledge Base Results
We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!-
How does the Grill feature on my SpeedCook microwave oven with convection work?
..., and remove it with convection? For best results, apply light amount of oven mitts is over. To Use: Touch "Cook Method" on the turntable. Oven cavity and door will become ... door will become very hot during use , the cooling fan turns on and stays on heat-sensitive surfaces. Using oven mitts, grasp the Sizzle Pan securely with convection work in Lamb Chops ... -
What are some tips for defrosting food using my microwave oven?
...tones. Touch Cook Power. Touch Start. If not used for defrosting food using it ? Popcorn feature not working as possible...light) can occur and cause damage to the microwave oven. Lamb: stew and chops. lb (113 g) or two 4 oz (113 g) patties. Fish Fillets, steaks, whole, shellfish. Aluminum foil and some tips for food left outside the freezer more quickly than ¼ Use... -
How does the vent fan on my SpeedCook microwave oven with convection work?
...? To operate vent fan: Repeatedly press Fan to cool the oven. To protect the oven, the vent fan will be turned off. It may stay on for a few seconds while the settings are being adjusted. How do I clean the oven light on my gas range? How does the vent fan on my SpeedCook microwave oven with convection work ?
Similar Questions
The Color Of The Hood
I ordered range hood from Home Depot in stainless steel, it was an online order, It came in white co...
I ordered range hood from Home Depot in stainless steel, it was an online order, It came in white co...
(Posted by anujdad 6 years ago)
Friend Has The Gz7936xhs-0 And The Fan/vent Will Not Raise Or Lower. ??
Hi. My friend has the gz7936xhs-0 and the fan/vent will not raise or lower. What should I check?Than...
Hi. My friend has the gz7936xhs-0 and the fan/vent will not raise or lower. What should I check?Than...
(Posted by prayofn 9 years ago)
Cavity Light Bulb
What light bulb do I need for the cavity light? Where can I buy it?
What light bulb do I need for the cavity light? Where can I buy it?
(Posted by robbimontgomery 9 years ago)
How To Identify And Order Optional Whirlpool Range Hood Charcoal Filter
Whirlpool range hood model is: UXT5230AYS. I can't locate part # for a 'charcoal' filter needed for ...
Whirlpool range hood model is: UXT5230AYS. I can't locate part # for a 'charcoal' filter needed for ...
(Posted by alfredsimonetti 11 years ago)