Whirlpool WTW7340XW Support Question
Whirlpool WTW7340XW Support Question
Find answers below for this question about Whirlpool WTW7340XW.Need a Whirlpool WTW7340XW manual? We have 6 online manuals for this item!
Question posted by vgh000 on November 4th, 2017
Black Oil Substance Spits From Under The Machine
why does a black oil substance spits from under the machine when on heavy duty wash
Current Answers
Related Whirlpool WTW7340XW Manual Pages
Dimension Guide - Page 1
...separate circuit serving only this appliance be no less than 96" (2.4 m) from the bottom of the washer. For complete details, see Installation
our products, we reserve the right to change without notice. wall or...floor (view A & B) The standpipe drain requires a minimum diameter standpipe of the washer. The top of the laundry tub must be at least 39" (990 mm) high and no higher than 96...
Installation Instructions - Page 2
INSTALLATION REQUIREMENTS
TOOLS AND PARTS Gather the required tools and parts before starting installation.
Tools needed:
Parts supplied (located in the washer basket):
Pliers that open to 1 9/16" (39.5 mm)
Flashlight (optional)
4" min (102 mm)
Adjustable or open end wrench 9/16" (14 mm)
Wood block
Drain hose ...
Installation Instructions - Page 3
... mm)
24 in the top and bottom of the door are required. Some water can remain in washer and can cause damage in a basement, laundry room, closet, or recessed area. If you have:
You will need :
Laundry tub or standpipe taller than 96" (2.4 m)
Sump pump system (if not already available)
1" (25 mm) diameter...
Installation Instructions - Page 4
... m) from the bottom of the washer.
39" (990 mm)
28" (710 mm)
Laundry Tub
Floor
The laundry tub drain system needs a minimum 20 gal. (76 L) capacity laundry tub. Additional hoses might be purchased...
Wall standpipe
Floor standpipe
The standpipe drain requires a minimum diameter standpipe of the washer. or 20-amp, fused electrical supply is available. The floor drain system requires...
Installation Instructions - Page 5
... the
bottom of the drain hose helps to avoid water leakage and damage to move the washer in the "Remove Shipping Base and Packing Ring" section. ■■ If foam shipping... base has not been removed, be sure lid is stored inside the washer cabinet.
1. REMOVE SHIPPING BASE AND PACKING RING
1. Remove shipping base
and packing ring
INSTALLATION INSTRUCTIONS...
Installation Instructions - Page 6
...enough to water
faucets
4.5" (113 mm)
Place hose into one end of laundry tub. Firmly seat the washers in standpipe
A
B
A.
Check the temperature of the inlet hoses. Connect ...To keep drain water from going back into the washer: ■■ Do not force excess drain hose into a laundry tub, drainpipe, or bucket to washer correctly.
3. Hose
should run until it is...
Installation Instructions - Page 7
... of hose failure, replace the hoses every 5 years. Using pliers, rotate the foot up to laundry tub leg, drain standpipe, or inlet hoses for future reference. ■■ Periodically inspect and ... if bulges, kinks,
cuts, wear, or leaks are stable and in a later step. Level Washer
IMPORTANT: Leveling your floor.
2. Screw coupling by hand until it is snug. Damage can result...
Installation Instructions - Page 8
... move the washer out slightly, tip back and prop up or down as needed.After the washer is not level, move the washer out to reach area, you are not tight against the washer cabinet, the washer may have ...gently rocking it back and forth and side to level the washer. HELPFUL TIP: You may wish to the washer cabinet. Then place the level on the lid near the console. Check levelness ...
Installation Instructions - Page 9
... a normal cycle and press Start. Allow it into a grounded 3 prong outlet.
■■ Read "Washer Use" in your "Use and Care Guide".
■■ To test and clean your tools.
■■...and inlet hoses.
■■ Remove film from console and any tape remaining on washer.
■■ Check that washer is an extra part, go back through steps to complete one whole cycle.
9 If...
Owners Manual - Page 3
... and whirring sounds as with low-water washplate wash system
The most striking difference in the basket. Low-water washing creates excessive sudsing with dirty laundry, fill it evenly around the basket wall.
And sometimes, you start the cycle, the lid will lock, and the washer will be different kinds of the clothes will...
Owners Manual - Page 4
...chosen. Pressing once while the washer is still possible to add items to the load. Overloading, unbalanced loads, or excessive suds may be cooler than what your laundry load.
Press START/PAUSE ...When you select a cycle, its default settings will turn the washer ON. A lower soil level setting will result in your load more wash time, if needed . For best results and following the ...
Owners Manual - Page 6
... washed. Use this cycle to wash bed sheets. Use this cycle for machine washable delicate garments. This cycle uses extra water and a special wash action...wash, a cooldown, and medium spin speeds for better wrinkle performance.
Cold water temperatures are needed . Settings can be adjusted as sleeping bags, small comforters, jackets
Bulky Items
Sturdy fabrics, colorfast items
Heavy Duty...
Owners Manual - Page 8
... sturdy fabrics.
• Do not dry garments if stains remain after washing;
Try mixing different sized items to items during washing. NOTE: Always read and follow fabric care labels instructions to avoid damage to your laundry
2. USING YOUR WASHER
1. Helpful Tips:
• When washing water-proof or water-resistant items, load evenly. Sort and prepare...
Owners Manual - Page 9
...detergent. NOTE: If using an Oxi laundry boost product, add to dispenser
5. HELPFUL TIP: See "Washer Maintenance" for information on recommended method of cleaning washer dispensers.
4. Add liquid chlorine ... 3/4 cup (180 mL). Add HE detergent to the detergent dispenser. Low-water washing creates excessive sudsing with liquid chlorine bleach.
9
Using regular detergent will not dispense ...
Owners Manual - Page 12
... a period of time, follow WINTER STORAGE CARE directions before moving during freezing weather, follow these steps: 1. Because some water may find laundry product residue leftover in your washer only when you do not have packing ring, place heavy blankets or towels into basket opening. disconnect and drain water inlet hoses.
2. Put 1 qt. (1 L) of...
Owners Manual - Page 13
... flat washers are properly seated.
Empty pockets before water is normal.
This is added to possibly avoid a service call for leaks (laundry tubs, drain pipe, water pipes, and faucets.)
An unbalanced load can backup out of water are not appropriate for flexing or sagging. Sensing spins will take several minutes before washing.
Make...
Owners Manual - Page 16
... before starting a cycle. washing.
Add only 1 or 2 garments after washer has started .
This is started . Load garments in seams before starting wash load.
Use only HE detergent. Always measure detergent and follow detergent directions based on some models), wash only a few items.
Use Whites and Heavy Duty cycle for the fabrics being washed.
Use dispensers to avoid...
Owners Manual - Page 17
...wash cycle to indicate that cold water hose is connected to the hot water inlet and hot water hose is normal for small amounts of water to the cold water inlet. Incorrect dispenser operation
Clogged dispensers or laundry... more than 4.5" (114 mm) into standpipe.
The washer is flashing, reselect your load. Allow the machine to assure proper dispensing.
Do not place load items on...
Parts Diagram - Page 4
DESCRIPTION
1 W10299400 Control Unit
Assembly,
Machine & Motor
2 W10130502 Gasket, Valve Tray
3 8578550 Tray Assembly,
Console (Includes
Items 2 & 4)
4...,
10−16 x 1.75
15 8281136 Screw, 8−18 x 3/4
16 3407203 Cord Assembly,
Power
17 W10242307 Washer, Water
Inlet Hose
(1−1/16 x 5/8)(4)
18
Hose, Water Inlet
W10194208 Cold Water
8571378 Hot Water
4
W10314833 Part ...
Parts Diagram - Page 8
....)
350938 Primer, Gray 350930 White PAINT, BULK (1 qt.)
799344 White (Uncut)
Illus. DESCRIPTION
ACCESSORY PARTS
W10135699 Affresh Odor Remover
8212546RP Inlet Hoses, 4 Ft. (Two Black Hoses W/Straight Ends & 4 Rubber Washers)
8212641RP Inlet Hoses, 5 Ft. (Two Black Hoses W/Straight Ends & 4 Rubber Washers)
8212545RP Inlet Hoses, 5 Ft. (One Red Hose & One Blue Hose W/Straight Ends & 4 Rubber...
Whirlpool Knowledge Base Results
We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!-
Not draining, not spinning out water, wet loads - Top-load washer
... number in loads. Gentle cycles, such as Super Wash or Heavy Duty has higher spin speeds and will stop the washer from the drain hose, drainpipe or utility sink. To remove ... cycle or Low Spin speed selected? The wash load must be closed during operation for adequate water flow. Top-load washer Sounds during a cycle, the machine will leave less water in the search tool... -
How to remove odors from a front-load washer without a Clean Washer cycle
... in HE (High Efficiency) washers. To purchase Affresh washer cleaner and receive a 10% discount on the washer console. Order your washing machine unless the fabric you have run a maintenance cycle. See How to remove odors from the washer before beginning the cleaning process. Do not add detergent or other laundry products to this cycle. ... -
How to get the best performance from my washer - Cabrio® HE washer with Dispensers in Corners
...Machine Washable Wool" on garments before washing. Colors/Darks Use this cycle for this cycle to wash... not cleaning laundry - Tightly packing the washer can be available on all models. This washer has many...wash small, lightly soiled loads that are washing. This washer has preset spin speeds; Cabrio® washer with Dispensers in the search tool below may be used. Cabrio® Heavy Duty...
Similar Questions
Machined Won't Wash Or Run Clean Machine Mode
Machine starts, can hear some spinning motion, but has a grinding sound. Then quits, but will not un...
Machine starts, can hear some spinning motion, but has a grinding sound. Then quits, but will not un...
(Posted by slcaron77 1 year ago)
My Washer Just Under 30 Days , Maybe Used 5 Times. Started A Wash Last Night, O
opened lid to stop from filling to gather my clothes. All the water had drained out and just made no...
opened lid to stop from filling to gather my clothes. All the water had drained out and just made no...
(Posted by rwtaylor7678 6 years ago)
Please Provide Me With Dimensions For A Whirpool Washer Model Wtw7340xw Thank Y
Please provide me with the dimensions for a Whirlpool washer model WTW73XWThank you
Please provide me with the dimensions for a Whirlpool washer model WTW73XWThank you
(Posted by amrph1974 6 years ago)
The Start Button Is Flashing & The Time Says Lid, Machine Wont Start
(Posted by moosymar 9 years ago)
