Whirlpool WFW94HEAW Support Question
Whirlpool WFW94HEAW Support Question
Find answers below for this question about Whirlpool WFW94HEAW.Need a Whirlpool WFW94HEAW manual? We have 4 online manuals for this item!
Question posted by bwanewpath on January 22nd, 2017
Whirlpool Whes44 Ll44 Manual
i HAVE a WHIRLPOOL WHES44 LL44 water softener I want to access a user manual for
Current Answers
Answer #1: Posted by Odin on January 22nd, 2017 10:39 AM
Odin
Member since:
April 10th, 2010 Points: 41,236,690
Member since:
April 10th, 2010 Points: 41,236,690
Hope this is useful. Please don't forget to click the Accept This Answer button if you do accept it. My aim is to provide reliable helpful answers, not just a lot of them. See https://www.helpowl.com/profile/Odin.
Related Whirlpool WFW94HEAW Manual Pages
Energy Guide - Page 1
...Similar Models
125 kWh
Estimated Yearly Electricity Use
$10
Estimated Yearly Operating Cost
(when used with a natural gas water heater)
Your cost will depend on your utility rates and use.
• Cost range based only on standard ... more information, visit www.ftc.gov/appliances (P/N W10441085) Clothes Washer Capacity: Standard
Whirlpool Corporation Models: WFW94HEA*,
WFW96HEA* Cat. U.S.
Installation Guide - Page 4
... break height: 28" (710 mm) from bottom of drain hose should be installed using a floor drain, wall standpipe, floor standpipe, or laundry tub. See "Alternate Parts". Recessed area or closet installation (washer only):
3" (76 mm)
48 in.2 (310 cm2)
Custom cabinet installation:
7" (178 mm)
14" (356 mm)
4" (102 mm)
3" (76 mm)
24...
Installation Guide - Page 6
...bolt hole plugs
Remove the yellow shipping strap from
washer
6. Attach drain hose to avoid suspension and structural damage, a certified technician must properly set up washer for relocation.
6 For a laundry tub or standpipe drain, go to back of ...top
Loosen bolts with pliers and slide it over top of washer to allow free access to step 9. Squeeze clamp with pliers and slide elbow end of...
Installation Guide - Page 7
... seated on bottom of the drain hose.
Repeat this step with separate directions. HELPFUL TIP: Make note of laundry tub. Clear water lines
Run water for a few seconds through hoses into standpipe or lay on washer. Place drain hose in picture) or over each other when attached correctly.
12. Do not use hoses without...
Installation Guide - Page 8
... leg, drain standpipe, or inlet hoses for future reference. NOTE: To reduce risk of water may enter washer. It will drain later.
15. Secure drain hose
Laundry Tub
Standpipe
4.54".5" (114 mm)
4.5" (114 mm)
Wall
4.5" (1143 mm)
Grip washer from side to tighten couplings an additional two-thirds turn on floor. Screw coupling by...
Use & Care Guide - Page 3
... to be installed on options and ordering, call 1-800-807-6777 or visit us at www.whirlpool.ca. 15" Pedestal Color-matched pedestals raise the washer and dryer to a more information on top of the washer.
3 ACCESSORIES
Customize your new washer and dryer with the following genuine Whirlpool accessories. The large drawer provides convenient storage.
Use & Care Guide - Page 4
...preset for each wash cycle.
Factors such as load size, wash temperature, and water pressure may cause the washer to adjust the cycle time, as a soccer uniform or a running tank and ...to set the delay time to "0," or touch POWER.
5 LED DISPLAY AND SETTINGS When you want to delay the start a cycle, or touch once while a cycle is in the Estimated Time... time will leave
your laundry load.
Use & Care Guide - Page 6
...After the load size is using the Delay Wash option. The sensing light will rate the water and energy use the Eco Monitor, choose the best cycle, temperature, spin speed, soil ...then adjust the settings and options to dispenser drawer. Open the dispenser drawer. 2. Add laundry products as when the washer is normal. NOTE: A small amount of energy used within that cycle. This is ...
Use & Care Guide - Page 9
... to the drum prior to ensure the interior is clean before washing clothes.
2. Add single-dose laundry packet, Oxi,
color-safe bleach, or fabric softener
crystals (if desired)
1. See "Cycle Guide" for a medium-size load. Load laundry into fabric.
Washer door should close easily. Use 1/2 the manufacturer's recommended amount for loading suggestions. USING YOUR...
Use & Care Guide - Page 10
... use liquid fabric softener dispenser balls in this washer. Use a measuring cup
with liquid chlorine bleach. n Do not spill or drip any fabric softener onto the clothes. They will not dispense correctly.
4. USING LAUNDRY PRODUCT DISPENSERS
NOTE: Do not add single-dose laundry packets, Oxi-type boosters, color-safe bleach, or fabric softener crystals to dispenser...
Use & Care Guide - Page 14
... selected by the user.
Use mild soap and water. Press down on the release tab and pull straight out to adequately rinse any spills. Touch POWER on dispenser. 2. IMPORTANT: Dispenser is canceled by pulling straight up. Use an all-purpose surface cleaner, if needed. IMPORTANT: To avoid damaging the washer's finish, do not...
Use & Care Guide - Page 15
... use , vacation, winter storage, or moving during freezing weather, follow these steps: 1. If storing or moving : 1. Unplug washer or disconnect power. Disconnect and drain water inlet hoses.
2. Unplug power cord. 5. Washer must be transported in washer drum
and run washer through HEAVY DUTY cycle to
keep it will be moved during freezing weather, winterize your...
Use & Care Guide - Page 16
...in display
Washer door not locking. Washer is running a suds reduction routine.
The washer can take 20 to 30 minutes to possibly avoid a service call for at www.whirlpool.com/product_help ... from closing completely. Touch POWER once to drainpipe or tub.
F09 followed by E01
(water supply error) appears in display
Excessive suds in display
Touch POWER once to the inlet...
Use & Care Guide - Page 17
....
Item or load not suitable for leaks (laundry tubs, drain pipe, water pipes, and faucets.)
Only use HE detergent.
See "Cycle Guide" and "Using Your Washer." Objects caught in Installation Instructions. You will ...19 mm) piece of water for leaks or clogged sink or drain.
See "Remove transport bolts from the door or rear of the cabinet. In Canada www.whirlpool.ca for assistance and to...
Use & Care Guide - Page 18
... low. Check that inlet valve screens have water flowing to reduce suds. Normal washer operation. Door must be stopped to inlet valve. TROUBLESHOOTING
First try the solutions suggested here or visit our website at www.whirlpool.com/product_help - In Canada www.whirlpool.ca for washer to avoid tightly packing or unbalancing. If you experience
Possible...
Use & Care Guide - Page 19
... clothes in Installation Instructions. Your hot water tank may be opened between the washer drum and the outer tub.
Using ...Water remaining in hoses.
Avoid washing single items. Balance a single item such as a rug or jeans jacket with tape.
Remove any clogs from regular detergents can begin.
Door locked at www.whirlpool.com/product_help -
In Canada www.whirlpool...
Use & Care Guide - Page 20
...water softener and/or iron filter.
Not using HE detergent or using too much HE detergent.
You may be out of balance. Dispensing balls will not rinse well if tightly packed. In Canada www.whirlpool.ca for each cycle.
Both hoses must be used together. Washer...
Not cleaning or removing stains
Washer not loaded as recommended. Fabric softener dispensing ball used for each...
Use & Care Guide - Page 21
... up
added incorrectly. Wash temperatures too low.
Make sure your hot water system is complete to provide a hot water wash. TROUBLESHOOTING
First try the solutions suggested here or visit our website at www.whirlpool.com/product_help - Avoid overfilling.
Sharp items were in "Washer Maintenance." Add only 1 or 2 garments after the wash is started. In...
Use & Care Guide - Page 22
... detected, a special suds routine automatically starts to washer drum before starting a cycle. In Canada www.whirlpool.ca for your garments. When using correct cycle for small amounts of water to your garments.
Single-dose laundry packet not dissolving
Adding laundry packet incorrectly. Cycle time changes or Normal washer operation.
This routine will also affect the cycle...
Use & Care Guide - Page 23
... existed when this limited warranty.
WHIRLPOOL CORPORATION LAUNDRY WARRANTY
LIMITED WARRANTY
For one year... rights, and you . If you want a longer or more comprehensive warranty than...authorized Whirlpool dealer to repair or replace appliance light bulbs, air filters, or water ...results from unauthorized modifications made to published user or operator instructions and/or installation ...
Whirlpool Knowledge Base Results
We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!-
Leaking water - Cabrio® washer with agitator
... drain is not level, water can cause water to the drainpipe or laundry tub. See the Installation Instructions for details. Securing the drain hose will keep it from coming loose from the washer cabinet? Make sure that came in the parts bag with Dispensers in Corners Product repair manuals Product Recall Information Leaking... -
How do I clean my top-loading super- or large-capacity washer?
... cleaning the Cabrio TM top-loading washer, click here. Repeat this dispenser; Rinse dispenser under warm water, and then replace it is not cleaning laundry - Do not add detergent or bleach to wipe any hard-water deposits using only cleaners that are equipped with a liquid fabric softener dispenser. Use a soft, damp cloth or... -
The water temperature is not correct - Front-load washer
... sure that the rubber gaskets are in a short amount of laundry. Are you washing many loads in water temperature during installation. This is not correct - Top-load washer Warm or hot wash temperatures are no leaks. If so, turn off the water lines at the nearest sink until you do not have hot...
Similar Questions
My New Whes44 Ll44 Water Softener Has Been Running For Hours With Err 1 Showing
(Posted by Kgaskill 9 years ago)
Washer Read Code For No Water Hook Up, F8 E1 I
Washer read code for no water hook up, F8 E1 i believe , i unplugged it before i reset it and now it...
Washer read code for no water hook up, F8 E1 i believe , i unplugged it before i reset it and now it...
(Posted by Jonny10188 9 years ago)
Washer Won't Fill With Water
I went to do a load of laundry tonight and the washer wouldn't fill with water. I turned it on the s...
I went to do a load of laundry tonight and the washer wouldn't fill with water. I turned it on the s...
(Posted by sobelps 10 years ago)